Transportation Working Conditions. Provisions for Bidding on School Bus Routes for Bus Attendants (cont’d)
Transportation Working Conditions
Transportation Working Conditions Sample Clauses
Related to Transportation Working Conditions
Unsafe Working Conditions Employees shall be recognized by the Employer to have the competence to determine what constitutes unsafe working conditions within their discipline. No employee shall be disciplined for refusal to work in a situation which is deemed unsafe beyond the reasonable requirements of the employee's job.
Safe Working Conditions The Employer undertakes to maintain office furniture, equipment, etc., in a practical and safe condition in order to avoid injury to employees or damage to their attire. Employees, for their part and in their own interest, are expected to advise the Employer of any such potentially injurious equipment.
GENERAL WORKING CONDITIONS Section 18-1. Employment begins and ends at each project site. Section 18-2. The selection of craft foremen and/or general foremen and the number of foremen required shall be entirely the responsibility of the Employer, it being understood that in the selection of such foremen and/or general foremen the Employer will give primary consideration to the qualified individuals available in the local area. After giving such consideration, the Employer may select such individuals from other areas. All foremen shall take orders from the designated Employer representatives. Craft foremen shall be designated working foremen at the request of the Employer. Section 18-3. There shall be no limit on production by employees nor restrictions on the full use of tools or equipment. Employees using tools shall perform any of the work of the trade and shall work under the direction of the craft foremen. There shall be no restrictions on efficient use of manpower other than as may be required by safety regulations. Section 18-4. Employees shall be at their place of work at the starting time and shall remain at their place of work performing their assigned functions under the supervision of the Employer until quitting time. The parties reaffirm their policy of a fair day’s work for a fair day’s wage. Section 18-5. All equipment assigned to a project shall be under the control of the Employer. The Employer shall have the right to determine how many pieces of equipment an individual employee shall operate. In an emergency, foremen shall operate any equipment assigned by the Employer, and there shall be no restriction on foremen in the use of the tools of his or her craft in such emergency. The foremen shall be from the craft normally operating the equipment. In accordance with currently recognized craft jurisdiction, the Employer shall determine the assignment of employees to start, stop, and maintain small portable construction equipment. Such work may be assigned to craft employees within a reasonable distance of their primary duties or an employee may be assigned full time to start, stop and maintain the Employer’s small, portable equipment on the job site. There shall be no over xxxxxxx of this type of equipment. The number of employees assigned to rigging and scaffolding operations shall be at the sole discretion of the Employer. The ratio of journeyperson to welders shall be determined solely by the Employer. Section 18-6. The Employer may utilize the most efficient methods or techniques of construction, tools or other labor saving devices to accomplish the work. Practices not a part of the terms and conditions of this Agreement, stand by crews and feather bedding practices will not be recognized. Section 18-7. It is recognized that specialized or unusual equipment may be installed and/ or serviced by individuals who have special training, skill, or qualifications and are not covered by this Agreement. Testing, inspection, or service performed on plant equipment under warranty may be performed by the vendor’s personnel. Section 18-8. Neither the Union nor its local unions shall coerce or in any way interfere with the Owner’s personnel, operation or facilities at the plant site. The Owner’s right to contract directly with other companies for work at the plant site shall not be limited, and the Union shall cooperate and not interfere with the Employer’s operations. Section 18-9. It is agreed that overtime is undesirable and not in the best interest of the industry or the employees; therefore, except in unusual circumstances, overtime will not be worked. Where unusual circumstances do exist, however, the Employer will have the right to assign specific employees and/or crews to perform such overtime work as is necessary to accomplish the job. Section 18-10. There will be no rest periods, organized coffee breaks or other non-working time established during working hours. Section 18-11. Individual seniority shall not be recognized or applied to employees working on projects under this Agreement. Section 18-12. The Employer shall establish such reasonable project rules as the Employer deems appropriate. These rules will be reviewed at the pre-job conference and posted at the project site by the Employer, and may be amended thereafter as necessary.
WORKING CONDITIONS 9.01 Lunch periods shall be at mid-shift. 9.02 The Employer shall allow each employee two (2) breaks of ten (10) minutes each, but not more in a work shift. Time of breaks shall be mutually agreed upon. 9.03 Essential protective clothing including welder’s gloves, protective vests or leather jackets, noise abatement devices, and rainwear shall be supplied at no charge to the employee. In the event that an employee does not return the foregoing items supplied to him by the Employer, the Employer shall charge the cost of same to the employee and deduct this cost from any money owing to the employee. 9.04 Chemical or flush toilets shall be provided from the commencement of work on all jobs. Where the sewer or chemical toilets are not available, sanitary toilet facilities shall be provided as called for in local sanitary regulations. Toilet houses shall be painted, at least on the inside, and cleaned out daily. Toilet paper will be provided. 9.05 Where there is no running tap water available, drinking water in approved sanitary containers shall be provided. Paper cups will be supplied. Salt tablets shall be supplied during the summer months. 9.06 If requested by the Union or employee, the Employer will provide within three (3) calendar days, a termination slip which shall state the reason for the employee’s termination and whether or not he is eligible for rehire. 9.07 Adequate time will be allowed prior to quitting time for picking up tools. 9.08 A lock-up shall be provided for employees for drying clothes, and dressing room, as well as lunch room. The lock-up shall have tables, and benches with provision for drying clothes. Such lock-up shall have windows and venting with adequate lighting and provision for continuous heat twenty-four (24) hours a day. The Employer shall be responsible for having the lock-up cleaned out daily and kept cleared of building material and other construction paraphernalia. Additional shelters shall be provided for employees to eat their lunch as may be required. 9.09 In case of fire or burglary on property or premises provided by the Employer, the Employer shall protect the value of an employee’s work clothes up to a total of three hundred and fifty dollars ($350.00). The Employer shall also provide fire and burglary insurance for the employees required tools to a total value of the tools, tool for tool, make for make, provided an inventory of tools and clothing is filed with the Employer. The Employer shall supply the required forms and obtain the inventory from each employee. The employee shall receive a signed copy of the inventory from the Employer. Coverage will commence at the date of the filing of the inventory with the Employer. Where an employee fails to file an inventory his rights to submit a claim shall be waived. (a) All mechanics, welders, servicemen, tire servicemen, drill doctors, steel sharpeners, bodymen painters, and mechanics and welder apprentices who request coveralls shall have these supplied and cleaned by the Employer. There shall be one change a week available in the employee’s proper size. Employees are expected to take reasonable care of coveralls supplied. In the event that an employee does not return the coveralls supplied to him by the Employer, the Employer shall charge the cost of same to the employee and deduct this cost from any monies owing to the employee. When requested, coveralls shall be supplied on a temporary basis to employees who assist on work as described above, or where the Employer and the Union mutually agree that coveralls are required. (b) Employees entitled to receive coveralls as provided herein may obtain an additional change of coveralls in any one week providing the condition of the coveralls requires a change. The shop xxxxxxx shall use discretion in authorizing the additional change. (c) All shops shall provide adequate clean-up facilities. 9.11 The Employer shall pay the cost of obtaining operators’ licences other than those required under the Motor Vehicles Act for employees covered by this Agreement. 9.12 No employee will be permitted to use his own motor vehicle in a manner which is unfair to other members or against the best interest of the Union. 9.13 Each employee being terminated will be given one (1) hour’s notice of termination by the Employer or one (1) hour’s pay allowed in lieu thereof. Heavy duty mechanics and apprentice mechanics may utilize this hour to gather together their tools and put them in shape for their next job. 9.14 When a mechanic leaves the employ of the Employer, the Employer shall be required to pay cost of shipping mechanic’s tools. Tools shall be shipped within forty-eight (48) hours of his leaving his employment, subject to the same conditions as govern transportation. When an Operating Engineer elects to transport his own tools to and from the jobsite, the employee shall be paid the rate of two dollars and seventy-five cents ($2.75) per one hundred (100) pounds per one hundred (100) miles. (e.g. $2.75 x 528 pounds x 273 miles = $39.64). Where the Employer fails to comply with the above, the employee shall be deemed to be still on the payroll of the Employer and shall receive his usual wages and all other conditions of this Agreement until there is compliance with these provisions. 9.15 Where an employee is involved in an accident while on the job and as a result is unable to perform his work, he shall receive a full day’s pay for the day of the accident.
Unsafe Work Conditions No Employee shall be disciplined for refusal to work on a job which in the opinion of: (a) A member of a safety committee; or (b) A person designated by a safety committee; or (c) A safety officer after an on-site inspection and following discussion with a representative of the Employer, does not meet the standards established pursuant to the Workers' Compensation Act.
Unsafe Conditions In accordance with 29 CFR § 1977, occasions might arise when an employee is confronted with a choice between not performing assigned tasks or subjecting himself/herself to serious injury or death arising from a hazardous condition at the workplace. If the employee, with no reasonable alternative, refuses in good faith to expose himself/herself to the dangerous condition, he/she would be protected against subsequent discrimination. The condition causing the employee's apprehension of death or injury must be of such a nature that a reasonable person, under the circumstances then confronting the employee, would conclude that there is a real danger of death or serious injury and that there is insufficient time, due to the urgency of the situation, to eliminate the danger by resorting to regular statutory enforcement channels. In addition, in such circumstances, the employee, where possible, must also have sought from his Employer, and been unable to obtain, a correction of the dangerous condition.
HAZARDOUS SUBSTANCE CONDITIONS If a Hazardous Substance Condition occurs, unless Lessee is legally responsible therefor (in which case Lessee shall make the investigation and remediation thereof required by Applicable Requirements and this Lease shall continue in full force and effect, but subject to Lessor's rights under Paragraph 6.2(c) and Paragraph 13), Lessor may at Lessor's option either (i) investigate and remediate such Hazardous Substance Condition, if required, as soon as reasonably possible at Lessor's expense, in which event this Lease shall continue in full force and effect, or (ii) if the estimated cost to investigate and remediate such condition exceeds twelve (12) times the then monthly Base Rent or $100,000 whichever is greater, give written notice to Lessee within thirty (30) days after receipt by Lessor of knowledge of the occurrence of such Hazardous Substance Condition of Lessor's desire to terminate this Lease as of the date sixty (60) days following the date of such notice. In the event Lessor elects to give such notice of Lessor's intention to terminate this Lease, Lessee shall have the right within ten (10) days after the receipt of such notice to give written notice to Lessor of Lessee's commitment to pay for the excess costs of (a) investigation and remediation of such Hazardous Substance Condition to the extent required by Applicable Requirements, over (b) an amount equal to twelve (12) times the then monthly Base Rent or $100,000, whichever is greater. Lessee shall provide Lessor with the funds required of Lessee or satisfactory assurance thereof within thirty (30) days following said commitment by Lessee. In such event this Lease shall continue in full force and effect, and Lessor shall proceed to make such investigation and remediation as soon as reasonably possible after the required funds are available. If Lessee does not give such notice and provide the required funds or assurance thereof within the time period specified above, this Lease shall terminate as of the date specified in Lessor's notice of termination.
Installation, Maintenance, Testing and Repair Unless otherwise agreed in writing by the Parties, to the extent required by Applicable Law, Interconnection provided by a Party shall be equal in quality to that provided by such Party to itself, any subsidiary, affiliates or third party. If either Party is unable to fulfill its obligations under this Section 14.2, it shall notify the other Party of its inability to do so and will negotiate alternative intervals in good faith. The Parties agree that to the extent required by Applicable Law, the standards to be used by a Party for isolating and clearing any disconnections and/or other outages or troubles shall be at parity with standards used by such Party with respect to itself, any subsidiary, affiliate or third party.
Seller’s Conditions Notwithstanding any other provision of this Agreement, the obligation of Seller to consummate the Transactions shall be subject to and conditioned upon the following: (i) Buyer’s representations and warranties being true and correct in all material respects as of the Closing and Buyer shall have delivered all documents required to be delivered by Buyer pursuant to Paragraph 5(b) below. (ii) The satisfaction of the [REDACTED] Waiver Condition. In the event the [REDACTED] Waiver Condition is not satisfied at or prior to Closing, then Seller may elect to either (a) terminate this Agreement with respect to the Commerce Property (but not the other Properties), in which event the Purchase Price shall be reduced by the Allocated Purchase Price for the Commerce Property, neither party shall have any further liability or obligation under this Agreement with respect to the Commerce Property (except for the provisions of this Agreement which recite that they survive termination), and the Closing shall proceed with respect to all other Properties, or (b) elect to continue this Agreement in full force and effect with respect to the Commerce Property. If any condition to Seller’s obligation to proceed with the Closing hereunder has not been satisfied as of the Closing Date or other applicable date (other than the condition to Closing set forth in Paragraph 3(g)(ii) for which Seller’s rights for such failure of the condition to Closing are set forth therein), Seller shall have the right to (i) nevertheless proceed to Closing, notwithstanding the non-satisfaction of such condition, in which event Seller shall be conclusively deemed to have waived any such condition, or (ii) terminate this Agreement upon written notice to Buyer prior to Closing, in which case the provisions of Paragraph 3(f) shall apply.
Hazardous Conditions Whenever the Contractor’s operations create a condition hazardous to traffic or to the public, the Contractor shall provide flagmen and furnish, erect and maintain control devices as are necessary to prevent accidents or damage or injury to the public at Contractor’s expense and without cost to the County. The Contractor shall comply with County directives regarding potential hazards. Emergency lights and traffic cones must also be readily available at all times and must be used in any hazardous condition. Emergency traffic cones must be placed in front of and behind vehicles to warn oncoming traffic. Signs, lights, flags, and other warning and safety devices shall conform to the requirements set forth in Chapter 5 of the current traffic manual, Traffic Control for Construction and Maintenance Work Zones, published by the state of California Department of Transportation. The Contractor shall take proper safety and health precautions to protect the Work, the workers, the public, and the property of others. The Contractor shall also be responsible for all materials delivered and Work performed until completion and acceptance of the entire construction Work, except for any completed unit of construction thereof which theretofore may have been accepted.
