Tree Trimming and Clearance Sample Clauses

Tree Trimming and Clearance. LES shall remove and/or trim all trees and xxxx along the location of the facilities to be installed sufficiently to permit the Contractor to perform all work required by this Contract. When tree trimming is required, the contractor will coordinate with the Contract Owner to facilitate scheduling.
AutoNDA by SimpleDocs

Related to Tree Trimming and Clearance

  • SITE CLEARANCE ETC Allow for clearing the area of the site to be built upon of all grass, weeds, shrubs, trees with trunks not exceeding 200mm girth, debris, etc., including grubbing up all roots, scoffling up as required and cart away all vegetation and debris. Quantity m2 200 Rate 2 Stripping average 300mm thick layer of topsoil and stockpiling on site. m2 200

  • Evaluation, Testing, and Monitoring 1. The System Agency may review, test, evaluate and monitor Grantee’s Products and services, as well as associated documentation and technical support for compliance with the Accessibility Standards. Review, testing, evaluation and monitoring may be conducted before and after the award of a contract. Testing and monitoring may include user acceptance testing. Neither the review, testing (including acceptance testing), evaluation or monitoring of any Product or service, nor the absence of review, testing, evaluation or monitoring, will result in a waiver of the State’s right to contest the Grantee’s assertion of compliance with the Accessibility Standards.

  • Skidding and Yarding Methods of skid- ding or yarding specified for particular areas, if any, are indicated on Sale Area Map. Outside Clearcutting Units and construction clearings, insofar as ground conditions permit, products shall not be skidded against reserve trees or groups of reproduction and tractors shall be equipped with a winch to facilitate skidding. B6.421 Rigging. Insofar as practicable, needed rigging shall be slung on stumps or trees desig- nated for cutting.

  • TESTING AND COMMISSIONING 24 Allow for a Lump Sum for testing and commissioning of the entire electrical installation, including the provision of Compliance Certificate. Item Carried to Collection R Section No. 4 Electrical Installation (Provisional) Bill No. 1 Electrical Installation COLLECTION Total Brought Forward from Page No. Carried to Final Summary 76 77 R Amount FINAL SUMMARY Section No Page No 1 Preliminaries 26 2 Alterations (Provisional) 30 3 External Works (Provisional) 73

  • CLEARANCE PATTERNS 7.1 The State shall develop separate clearance patterns for each of the following:

  • Traditional Medicine Cooperation 1. The aims of Traditional Medicine cooperation will be: (a) to build on existing agreements or arrangements already in place for Traditional Medicine cooperation; and (b) to promote information exchanges on Traditional Medicine between the Parties. 2. In pursuit of the objectives in Article 149 (Objectives), the Parties will encourage and facilitate, as appropriate, the following activities, including, but not limited to: (a) encouraging dialogue on Traditional Medicine policies and promotion of respective Traditional Medicine; (b) raising awareness of active effects of Traditional Medicine; (c) encouraging exchange of experience in conservation and restoration of Traditional Medicine; (d) encouraging exchange of experience on management, research and development for Traditional Medicine; (e) encouraging cooperation in the Traditional Medicine education field, mainly through training programs and means of communication; (f) having a consultation mechanism between the Parties' Traditional Medicine authorities; (g) encouraging cooperation in Traditional Medicine therapeutic services and products manufacturing; and (h) encouraging cooperation in research in the fields of Traditional Medicine in order to contribute in efficacy and safety assessments of natural resources and products used in health care.

  • Synchronization, Commissioning and Commercial Operation 4.1.1 The Power Producer shall give at least thirty (30) days written notice to the SLDC and GUVNL, of the date on which it intends to synchronize the Power Project to the Grid System.

  • Felling and Bucking Felling shall be done to minimize breakage of Included Timber and dam- age to residual timber. Unless agreed otherwise, felling shall be done by saws or shears. Bucking shall be done to permit removal of all minimum pieces set forth in A2. Purchaser may buck out cull material when necessary to produce pieces meeting Utilization Standards. Such bucked out material shall contain a minimum amount of sound wood, not in excess of the net scale in percentage of gross scale, or based on the merchantability factor, whichever is stated in A2. If necessary to assess extent of defect, Purchaser shall make sample saw cuts or wedges. B6.411 Felling in Clearings. Insofar as ground conditions, tree lean, and shape of clearings per- mit, trees shall be felled so that their tops do not extend outside Clearcutting Units, construction clearings, and ar- eas of regeneration cutting. B6.000 Xxxxx Xxxxxxx. Stumps shall not exceed, on the side adjacent to the highest ground, the maximum heights set forth in A6, except that occasional stumps of greater heights are acceptable when Purchaser determines that they are necessary for safe and efficient conduct of logging. Unless otherwise agreed, Purchaser shall re-cut high stumps so they will not exceed heights specified in A6 and shall dispose of severed portions in the same manner as other logging debris. The xxxxx heights shown in A6 were selected with the objective of maximum reasonable utilization of the timber, unless Sale Area Map shows special areas where xxxxx heights are lower for aesthetic, land treatment, or silvicultural rea- sons.

  • Security Clearance 6.7.1 Where specified by the Authority or the Contract user, the Supplier shall be responsible for ensuring that all Staff are security cleared to the level required by the Security Requirements not less than 5 Working Days before such person begins to perform the Services. If the Authority is responsible for applying for security clearance for Staff pursuant to this Clause 6.7.1, the Supplier shall provide a completed security clearance application form for such members of Staff to the Authority not less than 30 days before such members of Staff begin to perform the Services.

  • Incident Reporting and Client Risk Prevention An incident report shall be created and maintained at the AGENCY for the following: in the event the AGENCY’S staff or subcontractor becomes aware of an occurrence of any incident of injury to a client receiving program services through the COUNTY, requiring medical treatment by a licensed physician; any lawsuit entered into or against the AGENCY, all allegations of any kind of abuse, neglect, or exploitation of the AGENCY’S clients with the exception of those AGENCIES whose primary function is working with those that have been abused, neglected or exploited unless the allegation is against an AGENCY staff member; media coverage relating to the media expressing an interest in a case or issue concerning a client of the AGENCY or an employee on the AGENCY premises, a fire, hostage situation, bomb threat, epidemic or any circumstance which may impact the service provision. All occurrences shall be verbally communicated directly to COUNTY staff no later than 10:00 a.m. the following business day via telephone to the COUNTY. All incident reports shall be made available to the COUNTY upon request and maintained at the AGENCY. These reporting requirements shall in no way supersede the requirements for notification of allegations of abuse/neglect/exploitations to the State of Florida Abuse Hotline, as mandated in Chapter(s) 39 and 415, Florida Statutes.

Time is Money Join Law Insider Premium to draft better contracts faster.