CONTRACTOR PERFORMANCE AUDIT The Contractor shall allow the Authorized User to assess Contractor’s performance by providing any materials requested in the Authorized User Agreement (e.g., page load times, response times, uptime, and fail over time). The Authorized User may perform this Contractor performance audit with a third party at its discretion, at the Authorized User’s expense. The Contractor shall perform an independent audit of its Data Centers, at least annually, at Contractor expense. The Contractor will provide a data owner facing audit report upon request by the Authorized User. The Contractor shall identify any confidential, trade secret, or proprietary information in accordance with Appendix B, Section 9(a), Confidential/Trade Secret Materials.
MEASUREMENT AND VERIFICATION The goal of this task is to report the benefits resulting from this project by performing measurement and verification (M&V) of fossil fuel consumption and associated GHG reduction. • Enter into agreement with M&V subcontractor per Task 1.9 • Coordinate site visits with the M&V subcontractor at the demonstration site(s) • Develop M&V protocol for pre-installation measurements (and calculations): o Electric, natural gas and/or other fossil fuel consumption and GHG emissions (use appropriate emissions factor from Attachment 8 of the grant solicitation) of the equipment/process/system(s)/sub-system(s) that are to be upgraded and/or replaced and/or modified. o Ensure installation of sub-metering equipment and data loggers for pre/post data analysis. • Prepare and provide a detailed M&V Plan for each project demonstration site to include but not be limited to: o A description of the monitoring equipment and instrumentation which will be used. o A description of the key input parameters and output metrics which will be measured. o A description of the M&V protocol and analysis methods to be employed. o A description of the independent, third-party M&V services to be employed, if applicable. • Perform three months (or shorter period as approved in writing by the CAM) of pre- installation measurements (and calculations) based on the M&V protocol for pre- installation. • Prepare and provide a Pre-Installation M&V Findings Report for the demonstration site that includes M&V protocol, pre-install measurements (and calculations), analysis, and results performed in this task. • Develop M&V protocol for post-installation measurements (and calculations) of: o Electric, natural gas and/or other fossil fuel consumption and GHG emissions (use appropriate emissions factor from Attachment 8 of the grant solicitation) of the equipment/process/system(s)/sub-system(s) that will be upgraded and/or replaced and/or modified • Perform 12 months or two seasons, for seasonal facilities, (or shorter period as approved in writing by the CAM) of post-installation measurements based on M&V protocol for post-installation. • Provide a summary of post-installation M&V progress in Progress Report(s) (see subtask 1.5) which shall include but not be limited to:
Performance and Compliance with Contracts and Credit and Collection Policy The Seller shall (and shall cause the Servicer to), at its expense, timely and fully perform and comply with all material provisions, covenants and other promises required to be observed by it under the Contracts related to the Receivables, and timely and fully comply in all material respects with the applicable Credit and Collection Policies with regard to each Receivable and the related Contract.
Statement of Services Service Attachments The services to be delivered by Provider (the “Services”) and the fees for those Services, and the specific terms applicable to those Services are described in the Order or in one or more Service Attachments referencing this Agreement. Except for Supplemental Services or Project Services (described below), and unless otherwise agreed in writing, the services Provider will deliver to Client are limited to those Services specifically identified in the Order and described in the Service Attachments or Schedule of Services. In the event of any conflict between the terms of a Service Attachment or Schedule of Services and this Agreement, the terms in the Service Attachment or Schedule of Services control. In the event of any conflict between the terms of this Agreement and of an Order and any Service Attachment or Schedule of Services, the terms of the Order control. Provider may decline to perform any services requested by Client that are in violation of any applicable law or that are not typically associated with the Services provided by Provider. Supplemental Services “Supplemental Services” include additional services and equipment Client may need on a “one- off” or emergency basis that are not included within the scope of the Services described in an Order or the applicable Service Attachments. You will incur additional Service Fees for Supplemental Services. We will notify Client of any such additional Service Fees and will obtain Client’s approval prior to providing them. However, Provider has no obligation to determine the need for or to provide any Supplemental Services. All Supplemental Services are provided on an “as-is” basis and include no warranties of any kind, whether express or implied. In addition, if Provider determines that any additional services Client requests would be inappropriate for treatment as Supplemental Services under this paragraph, Provider may deliver to Client a proposed Service Attachment for Project Services or a Proposal prior to providing Supplemental Services. Project Services In some cases, Client may ask Provider to deliver services outside the scope of any Order or Service Attachment and inappropriate for treatment as Supplemental Services. Examples of such services include major system upgrades, new computer, machine or device setup, network changes, datacenter moves or setups, or installations. In those cases, Provider will prepare a separate Service Attachment for Project Services describing the proposed scope of those services and Provider’s fee to deliver them. Installation dates are estimates only. Client shall be responsible for preparation and maintenance of the site for such Project Services or installations, including, but not limited to, providing necessary electrical power and communication lines and proper air conditioning and humidity control. FEES FOR SERVICES | PAYMENT TERMS Service Fees Fees for Services are set forth in Order or Statement of Work. Unless otherwise indicated in writing, all Services will be performed on a time-and-materials basis at Provider’s then-current rates. Adjustments to Service Fees Except as may be specified in an Order, Provider may adjust the Service Fees charged under this Agreement as follows: • End-User or Network Growth. During the term of an Order, if the number of users or devices in Client’s environment or the Service or Equipment types or quantities to be covered within the scope of the Order exceeds the numbers, types or quantities previously ordered, Provider may apply a pro rata adjustment to the total Service Fees. You shall pay all Service Fees owed as they become due following any such adjustment. Similarly, during the term of an Order, if the number of users or devices in Client’s environment or the Service or Equipment types or quantities to be covered within the scope of the Order is less than the numbers, types or quantities previously ordered, upon request, Provider will apply a pro rata adjustment to the total Service Fees. You shall pay all Service Fees owed as they become due following any such adjustment. However, under no circumstances may any such adjustments result in a number of users or devices in Client’s environment or in any Service or Equipment types or quantities to be covered within the scope of the Order that is less than the numbers, types or quantities ordered at the time Client signed that Order.
Engineer Payment of Subproviders No later than ten (10) days after receiving payment from the State, the Engineer shall pay all subproviders for work performed under a subcontract authorized hereunder. The State may withhold all payments that have or may become due if the Engineer fails to comply with the ten-day payment requirement. The State may also suspend the work under this contract or any work authorization until subproviders are paid. This requirement also applies to all lower tier subproviders, and this provision must be incorporated into all subcontracts.
Performance and Compliance with Receivables and Contracts At its expense, timely and fully perform and comply with all material provisions, covenants and other promises, if any, required to be observed by the Issuer under the Contracts related to the Receivables.
SCHEDULE FOR PERFORMANCE REVIEWS 7.1 The performance of the Employee in relation to his performance agreement shall be reviewed for the following quarters with the understanding that the reviews in the first and the third quarter may be verbal if performance is satisfactory:
Timing of Payment of Performance When the payment of any obligation or the performance of any covenant, duty or obligation is stated to be due or performance required on a day which is not a Business Day, the date of such payment (other than as described in the definition of Interest Period) or performance shall extend to the immediately succeeding Business Day.
Quarterly Contractor Performance Reporting Customers shall complete a Contractor Performance Survey (Exhibit I) for each Contractor on a Quarterly basis. Customers will electronically submit the completed Contractor Performance Survey(s) to the Department Contract Manager no later than the due date indicated in Contract Exhibit D, Section 17, Additional Special Contract Conditions. The completed Contractor Performance Survey(s) will be used by the Department as a performance-reporting tool to measure the performance of Contractors. The Department reserves the right to modify the Contractor Performance Survey document and introduce additional performance-reporting tools as they are developed, including online tools (e.g. tools within MyFloridaMarketPlace or on the Department's website).
Excuse for Nonperformance or Delayed Performance Except with respect to defaults of subcontractors, Contractor/Vendor shall not be in default by reason of any failure in performance of this contract in accordance with its terms (including any failure by Contractor/Vendor to make progress in the prosecution of the work hereunder which endangers such performance) if Contractor/Vendor has notified the Commission or designee within 15 days after the cause of the delay and the failure arises out of causes such as: acts of God; acts of the public enemy; acts of the State and any other governmental entity in its sovereign or contractual capacity; fires; floods; epidemics; quarantine restrictions; strikes or other labor disputes; freight embargoes; or unusually severe weather. If the failure to perform is caused by the failure of a subcontractor to perform or to make progress, and if such failure arises out of causes similar to those set forth above, Contractor/Vendor shall not be deemed to be in default, unless the services to be furnished by the subcontractor were reasonably obtainable from other sources in sufficient time to permit Contractor to meet the contract requirements. Upon request of Contractor, the Commission or designee shall ascertain the facts and extent of such failure, and, if such officer determines that any failure to perform was occasioned by any one or more of the excusable causes, and that, but for the excusable cause, Contractor’s progress and performance would have met the terms of the contract, the delivery schedule shall be revised accordingly, subject to the rights of the State under the clause entitled (in fixed-price contracts, “Termination for Convenience,” in cost-reimbursement contracts, “Termination”). (As used in this Paragraph of this clause, the term “subcontractor” means subcontractor at any tier).