Where Type Sample Clauses

Where Type. 2B Interconnection facilities are used for two-way traffic exchanged between the Parties, the charges for such facilities provided by Sandhill shall be shared based on each Party’s proportion of originating traffic to total traffic exchanged between the Parties, in accordance with this Agreement. Sandhill shall xxxx Cingular, on a monthly basis, for the entire charges associated with the facilities provided by Sandhill. The following month, Cingular shall apply the agreed upon Traffic Factor listed below to the total two-way interconnection facility charges billed by Sandhill to Cingular to calculate Sandhill’s proportionate share of the charges associated with the Sandhill provided facilities, for billing Sandhill. The parties agree to the Traffic Factor percentages below until Cingular and Sandhill perform traffic studies to determine more accurate Traffic Factors. In order for Cingular to measure traffic and perform such study, Cingular will order separate facilities in addition to the two-way facilities discussed above. Cingular will have full financial responsibility for the facilities needed to perform the traffic study. Once the traffic study is complete and agreed upon by both Parties, the Parties agree to revise the following traffic factors in writing and to true up billing for Reciprocal Compensation and facilities, not to exceed six months from the time the traffic study facility is operational. The Parties agree to review the Traffic Factor percentages on a periodic basis and, if warranted by the actual usage, revise the Traffic Factor percentages appropriately. a) Landline to Wireless 20% b) Wireless to Landline 80%
AutoNDA by SimpleDocs
Where Type. 2B Interconnection facilities are used for two-way traffic exchanged between the Parties, the charges for such facilities provided by Sandhill shall be shared based on each Party's proportion of originating traffic to total traffic exchanged between the Parties, in accordance with this Agreement. Sandhill shall xxxx Cingular, on a monthly basis, for the entire charges associated with the facilities provided by Sandhill. The following month, Cingular shall apply the agreed upon Traffic Factor listed below to the total two-way interconnection facility charges billed by Sandhill to Cingular to calculate Sandhill's proportionate share of the charges associated with the Sandhill provided 11/11/02 11 InterconnectioanndReciprocaCl ompensatioAngreemenbtetweenSandhil&l Cingular facilities, for billing Sandhill, Thepartiesagreeto the Traffic Factorpercentagebselow until Cingular and Sandhillperform traffic studiesto determinemore accurateTraffic Factors. In order for Cingularto measuretraffic andperform such study,Cingularwill order separatefacilities in addition to the two-way facilities discussedabove.Cingular will havefull financialresponsibilityfor the facilitiesneededto perform thetraffic study. Oncethe traffic studyis completeandagreedupon by both Parties,the Partiesagreeto revise the following traffic factors in writing and to true up billing for Reciprocal Compensationand facilities, not to exceedsix months from the time the traffic study facility is operational.The Partiesagreeto review the Traffic Factorpercentageson a periodicbasisand,if warrantedby theactualusage,revisethe Traffic Factorpercentages appropriately. a) Landlineto Wireless 20% b) Wirelessto Landline 80%

Related to Where Type

  • License Type Your license to a Product will be under a Named User or CPU license type, as specified on an order. Each Named User license to a Product entitles a Named User to access and use that Product in one production environment and up to two non-production environments. Each CPU license to a Product entitles you to assign the Product to a single CPU in one production environment and up to two non-production environments, for use in support of an unspecified number of Named Users.

  • LEASE TYPE This Agreement shall be considered a: (check one)

  • OTHER TYPES OF LEAVE Court Leave

  • Contract Type Full time equivalency (FTE); and,

  • Trunk Types 2.2.1 In interconnecting their networks pursuant to this Attachment, the Parties will use, as appropriate, the following separate and distinct trunk groups: 2.2.1.1 Interconnection Trunks for the transmission and routing of Reciprocal Compensation Traffic, translated LEC IntraLATA toll free service access code (e.g., 800/888/877) traffic, and IntraLATA Toll Traffic, between their respective Telephone Exchange Service Customers, Tandem Transit Traffic, and, Measured Internet Traffic, all in accordance with Sections 5 through 8 of this Attachment; 2.2.1.2 Access Toll Connecting Trunks for the transmission and routing of Exchange Access traffic, including translated InterLATA toll free service access code (e.g., 800/888/877) traffic, between Ymax Telephone Exchange Service Customers and purchasers of Switched Exchange Access Service via a Verizon access Tandem in accordance with Sections 9 through 11 of this Attachment; and 2.2.1.3 Miscellaneous Trunk Groups as mutually agreed to by the Parties, including, but not limited to: (a) choke trunks for traffic congestion and testing; and, (b) untranslated IntraLATA/InterLATA toll free service access code (e.g. 800/888/877) traffic. 2.2.2 Other types of trunk groups may be used by the Parties as provided in other Attachments to this Agreement (e.g., 911/E911 Trunks) or in other separate agreements between the Parties (e.g., directory assistance trunks, operator services trunks, BLV/BLVI trunks or trunks for 500/555 traffic). 2.2.3 In accordance with the terms of this Agreement, the Parties will deploy One-Way Interconnection Trunks (trunks with traffic going in one direction, including one-way trunks and uni-directional two-way trunks) and/or Two-Way Interconnection Trunks (trunks with traffic going in both directions). 2.2.4 Ymax shall establish, at the technically feasible Point(s) of Interconnection on Verizon’s network in a LATA, separate Interconnection Trunk group(s) between such POI(s) and each Verizon Tandem in a LATA with a subtending End Office(s) to which Ymax originates calls for Verizon to terminate. 2.2.5 In the event the volume of traffic between a Verizon End Office and a technically feasible Point of Interconnection on Verizon’s network in a LATA, which is carried by a Final Tandem Interconnection Trunk group, exceeds (a) the Centium Call Seconds (Hundred Call Seconds) busy hour equivalent of one (1) DS1 at any time; (b) 200,000 minutes of use for a single month; and/or; (c) 600 busy hour Centium Call Seconds (BHCCS) of use for a single month: (i) if One-Way Interconnection Trunks are used, the originating Party shall promptly establish new or augment existing End Office One-Way Interconnection Trunk groups between the Verizon End Office and the technically feasible Point of Interconnection on Verizon’s network; or,

  • Various Types of Loans Each Revolving Loan shall be, and each Term Loan may be divided into tranches which are, either a Base Rate Loan or a Eurodollar Loan (each a "type" of Loan), as the Company shall specify in the related notice of borrowing or conversion pursuant to Section 2.2.2 or 2.2.

  • Selection Criteria Each Contract is secured by a new or used Motorcycle. No Contract has a Contract Rate less than 1.00%. Each Contract amortizes the amount financed over an original term no greater than 84 months (excluding periods of deferral of first payment). Each Contract has a Principal Balance of at least $500.00 as of the Cutoff Date.

  • License Types (a) A Team License shall mean a subscription license that provides a limited number of licenses to a set amount of developers for a named Customer. Customer must procure enough active licenses for each individual who has Programmatic Access. A Team License only grants rights to a named Customer and does not extend any right, in any form, to any parent or subsidiary company of Customer. A Team License cannot be used as a floating license. (b) A Project License shall mean a subscription license which covers one named Customer application. The license fees are based on the total number of developers working on a named project, regardless of whether such developers are directly using the Licensed Product. For the purposes of pricing and license administration, a “Project Group” is deemed to be a distinct Customer software team within a Customer’s business unit that works towards a distinct business purpose for the benefit of a single application. Customer is required to identify the name of each such Project Group to Syncfusion; such name must be unambiguous in nature. It is acknowledged and agreed by Customer that each identified Project Group shall exist for a valid business purpose and not just as a means for consolidating software licenses to minimize license fees that are otherwise due. If, in the sole opinion of Syncfusion, multiple Customer teams would each individually meet the above definition of a Project Group, such multiple teams shall not be combined for the purpose of consolidating licenses under a single Project Group. Customer is responsible for providing information about each such Project Group to Syncfusion. By entering into this Agreement, Customer represents that after the effective date, it will not withhold information that Syncfusion requires to properly license each such Project Group, and further agrees that any misrepresentation in this regard constitutes a material breach of this Agreement. (c) A Division License shall mean a subscription license which will cover one named Division and allow for development work on more than one project within such Division. A Division shall mean a business unit within Customer’s organization that works towards a distinct business purpose. Customer is required to identify the name of such Division to Syncfusion; such name must be unambiguous in nature. License fee determinations will be at the sole discretion of Syncfusion and be based on such factors including, but not limited to, Customer’s Division size, developer count, and the scope of the Division’s business purpose. By entering into this Agreement, Customer acknowledges that it is responsible for providing information about the named Customer Division to Syncfusion sufficient for Syncfusion to price the Division License, and Customer represents that it will not withhold information that Syncfusion requires to properly license each such named Customer division, and further agrees that any misrepresentation in this regard constitutes a material breach of this Agreement. (d) A Global License shall mean a subscription license for all development for a named Customer, where the license fees are based on the overall size of a named Customer. A Global License only grants rights to a named Customer and does not extend any right, in any form, to any parent or subsidiary company of Customer. (e) A Retail License shall mean a single named user, non-transferable license to use the Licensed Product. Retail Licenses will only made available to Customers in Syncfusion’s sole discretion and only when the number of such End-Users is finite and readily ascertainable. Accordingly, Syncfusion will make a determination as to whether or not the provision of Retail Licenses is appropriate under the circumstances applicable to any given Customer, and Syncfusion reserves the right, in its sole discretion, to refuse to make available Retail Licenses to a Customer and instead require a given Customer to procure a Project License, Division License, or Global License as circumstances dictate. A Retail License only grants rights to a named Customer and does not extend any right, in any form, to any parent or subsidiary company of Customer.

  • Loop Transmission Types 3.1 Subject to the conditions set forth in Section 1 of this Attachment, Verizon shall allow CBB to access Loops unbundled from local switching and local transport, in accordance with this Section 3 and the rates and charges provided in the Pricing Attachment. Verizon shall allow CBB access to Loops in accordance with, but only to extent required by, Applicable Law. The available Loop types are as set forth below:

  • Presentation of Potential Target Businesses The Company shall cause each of the Initial Shareholders to agree that, in order to minimize potential conflicts of interest which may arise from multiple affiliations, the Initial Shareholders will present to the Company for its consideration, prior to presentation to any other person or company, any suitable opportunity to acquire an operating business, until the earlier of the consummation by the Company of a Business Combination or the liquidation of the Company, subject to any pre-existing fiduciary obligations the Initial Shareholders might have.

Draft better contracts in just 5 minutes Get the weekly Law Insider newsletter packed with expert videos, webinars, ebooks, and more!