Airport Layout Plan Drawing. The engineer will update the electronic versions of the Airport Layout Plan drawing which is identified as Sheet 3 of the Airport Layout Plan drawing set. The engineer will update the drawing to reflect the actual work accomplished by the project.
Airport Layout Plan Drawing. Description: Following the Recommended Airport Master Plan Concept developed under the preceding elements and FAA AC 150/5070‐6B, an ALP drawing for the airport will be prepared. The ALP will reflect updated physical features, location of airfield facilities (runways, taxiways, navigational aids), and existing landside development. Development of recommended landside and airfield facilities, including runways and taxiways; property and runway protection zone boundaries; and revenue support areas will also be shown. Guidelines for the preparation of an airport layout plan as defined by the FAA Airports ARP SOP 2.00 Standard Procedure for FAA Review and Approval of Airport Layout Plans (October 1, 2013) will be followed. A Title Sheet and Airport Data Sheet will also be prepared and included with the full Airport Layout Plan set. Responsibilities: Consultant: Prepare a new ALP for the airport. Sponsor: Review and comment. Product: A new ALP drawing for the airport which meets federal guidelines. Task 9.2 Terminal Area Drawing(s) Description: Prepare Terminal Area Drawing(s) reflecting development resulting from the recommenda‐ tions of this study. Depending on the future recommended development for the general aviation areas, more than one drawing may be required to adequately reflect the detail of development within the area. The drawing(s) will include detailed planning level information such as access taxiways, apron areas, hangar layouts, aircraft tie‐down areas, customer and employee parking areas, and vehicular circulation and access for the short, intermediate, and long‐term planning periods. Responsibilities: Consultant: Prepare Terminal Area Drawing(s). Sponsor: Review and comment. Product: Terminal Area Drawing(s) reflecting the selected development alternative for these facilities at the airport. Task 9.3 Part 77, Approach and Inner Approach Surface Plans Description: Prepare Part 77, Approach and Inner Approach Surface plans in conformance with FAR Part 77 and FAA Airports ARP SOP 2.00 Standard Procedure for FAA Review and Approval of Airport Layout Plans (October 1, 2013). As necessary, height of potential obstructions will be researched and identified on the drawing along with an obstruction chart/table indicating the obstruction description, their top elevation, affected Part 77 surface, the penetration, and disposition or corrective action to eliminate or mitigate the obstruction. Responsibilities:
