Insurance Terms and Conditions Company must maintain the following limits and coverages uninterrupted or amended through the term of this Agreement. In the event Company becomes in default of the following requirements, Authority reserves the right to take whatever actions it deems necessary to protect its interests. Required liability policies other than Workers’ Compensation / Employer’s Liability will provide that Authority, members of Authority’s governing body, and Authority’s officers, volunteers and employees are included as additional insureds.
General Terms and Conditions During the term of this Contract, Contractor agrees to procure and maintain insurance which meets all County’s requirements in the General Terms and Conditions.
FACTS AND PROVISIONS/LEGAL REQUIREMENTS The term of the Agreement shall be from September 1, 2015, through May 31, 2018. The County may terminate its participation in the Agreement by providing 90 days advance written notice to the other participating agencies. The Department will provide its personnel assigned to OPSG Grant Program with all supplies and/or prescribed safety gear, body armor, and/or standard issue equipment necessary to perform OPSG Grant Program activities. The County agrees to defend and indemnify the County of San Diego for any claim, action, or proceeding against the County of San Diego arising solely out of the acts or omissions of the County in the performance of the Agreement. Each party to the Agreement agrees to defend itself from any claim, action, or proceeding arising out of concurrent acts or omissions of the parties. In such a case, each party agrees to retain its own legal counsel, bear its own defense costs, and waive its right to seek reimbursement of such costs except where a court finds and allocates comparative fault. Board approval is required for this Agreement, as the funding amount exceeds the authority previously delegated by the Board to the Sheriff on May 15, 2015. County Counsel has approved the attached Agreement as to form. The Honorable Board of Supervisors 5/17/2016
Standard Terms and Conditions Executive expressly understands and acknowledges that the Standard Terms and Conditions attached hereto are incorporated herein by reference, deemed a part of this Agreement and are binding and enforceable provisions of this Agreement. References to “this Agreement” or the use of the term “hereof” shall refer to this Agreement and the Standard Terms and Conditions attached hereto, taken as a whole.
Compliance with Terms and Conditions All the terms, covenants and conditions of this Agreement to be complied with and performed by Parent or Sub on or before the Closing Date shall have been (and tender by Parent or Sub of any documents required to be delivered at the Closing by it shall constitute a representation by Parent and Sub as at the Closing that, except as otherwise specifically approved in writing by Company, they have been) complied with and performed in all material respects.
Governing Provisions This Agreement is made under and subject to the provisions of the Plan, and all of the provisions of the Plan are also provisions of this Agreement. If there is a difference or conflict between the provisions of this Agreement and the provisions of the Plan, the provisions of the Plan will govern. By signing this Agreement, the Grantee confirms that he or she has received a copy of the Plan.
SAFETY PROVISIONS It is the essence of this Order that all Services to be performed by Seller shall be done in a safe and good workmanlike manner, free of any accidents. Accordingly, Seller shall promulgate, maintain, and enforce appropriate safety and health rules and procedures (including training) with respect to its personnel and the Work to be performed hereunder, which rules and procedures at a minimum shall be the equivalent of or exceed applicable Buyer safety and health rules. All Services performed hereunder shall fully comply with all lawful governmental safety and health requirements, including the rules and standards established by the Occupational Safety and Health Act of 1970 ("OSHA"), as amended, and any other applicable federal, state and/or local safety or health laws, rules or regulations. Any equipment provided by Buyer to Seller for the benefit of Seller's employees or those of its subcontractors shall be at the sole risk and liability of Seller to make sure that such equipment is fit for the use intended and is in proper working order. XXXXXX AGREES TO INDEMNIFY (INCLUDING ATTORNEYS' FEES) DEFEND, AND TO SAVE HARMLESS BUYER FROM ANY AND ALL CLAIMS OF SELLER, SELLER’S SUBCONTRACTORS, AND THEIR EMPLOYEES ARISING OUT OF THE USE OF ANY EQUIPMENT FURNISHED BY BUYER OR ADVICE GIVEN BY BUYER RELATING TO SUCH EQUIPMENT, TO THE FULLEST EXTENT ALLOWED BY LAW, IT BEING UNDERSTOOD THAT BUYER SHALL NOT BE LIABLE UNDER LAW, CONTRACT, NEGLIGENCE, STRICT LIABILITY, OR OTHERWISE. Seller shall maintain a drug and alcohol-free workforce at all times while on Xxxxx's premises/location. Upon Xxxxx's request, Seller shall provide Buyer with a copy of all accident reports prepared by or submitted to Seller, including all OSHA illness and injury reports.
Waiver of Terms and Conditions Failure to enforce any of the terms or conditions of this Agreement shall not constitute a waiver of any such terms or conditions, or of any other terms or conditions.
Governing Terms and Conditions If there is an irreconcilable conflict between the terms and conditions set forth in this Contract or any Contract Amendment and the terms and conditions set forth in any Exhibit, Appendix, Work Authorization or Supplemental Work Authorization to this Contract, the terms and conditions set forth in this Contract or any Contract Amendment shall control over the terms and conditions set forth in any Exhibit, Appendix, Work Authorization or Supplemental Work Authorization to this Contract.
Transitional Provisions 24.1. As from the official date of entry into force of the 01 series of amendments to this Regulation, no Contracting Party applying this Regulation shall refuse to grant or refuse to accept type approval under this Regulation as amended by the 01 series of amendments. 24.2. As from 12 months after the date of entry into force of the 01 series of amendments to this Regulation, Contracting Parties applying this Regulation shall grant approvals only if the type of components to be approved meets the requirements of Part I of this Regulation as amended by the 01 series of amendments to this Regulation. 24.3. Type approvals of components other than fuel rail, as defined in paragraph 4.72., granted according to the original version of this Regulation or of components granted according to the 01 series of amendments, shall remain valid and shall be accepted for the purpose of their installation on vehicles as long as the requirements for the specific component have not changed by any series of amendments. 24.4. As from 18 months after the date of entry into force of the 01 series of amendments to this Regulation, Contracting Parties applying this Regulation shall grant approvals only if the vehicle type to be approved meets the requirements of Part II of this Regulation as amended by the 01 series of amendments to this Regulation. 24.5. Until 12 months after the date of entry into force of the 01 series of amendments to this Regulation, Contracting Parties applying this Regulation can continue to grant type approvals for the type of components to the original version of this Regulation without taking into account the provisions of the 01 series of amendments. 24.6. Until 18 months after the date of entry into force of the 01 series of amendments to this Regulation, Contracting Parties applying this Regulation can continue to grant type approvals for the vehicle type to the original version of this Regulation without taking into account the provisions of the 01 series of amendments. 24.7. Notwithstanding the provisions of paragraphs 24.5. and 24.6., Contracting Parties applying this Regulation shall not refuse to grant extensions of type approvals for existing types of component or vehicle types which have been issued according to this Regulation without taking into account the provisions of the 01 series of amendments to this Regulation. 24.8. As from the official date of entry into force of the 02 series of amendments to this Regulation, no Contracting Party applying this Regulation shall refuse to grant or refuse to accept type approval under this Regulation as amended by the 02 series of amendments. 24.9. As from 1 September 2017 Contracting Parties applying this Regulation shall grant approvals only if the type of components to be approved meets the requirements of Part I of this Regulation as amended by the 02 series of amendments to this Regulation. 24.10. As from 1 September 2018 Contracting Parties applying this Regulation shall grant approvals only if the vehicle type to be approved meets the requirements of Part II of this Regulation as amended by the 02 series of amendments to this Regulation. 24.11. As from 1 September 2019 Contracting Parties applying this Regulation may refuse to recognize approvals of a type of vehicle which have not been granted in accordance with Part II of this Regulation as amended by the 02 series of amendments to this Regulation. 24.12. Contracting Parties applying this Regulation shall not refuse to grant extensions of type approvals for existing types of component or vehicle types which have been issued according to this Regulation without taking into account the provisions of the 02 series of amendments to this Regulation. 24.13. Notwithstanding paragraphs 24.11. and 24.12., Contracting Parties applying this Regulation shall continue to accept type approvals granted to the preceding series of amendments, which are not affected by the 02 series of amendments.