CLEC Methods of Interconnection Sample Clauses

CLEC Methods of Interconnection. In addition to Collocation in SBC- AMERITECH’s Switch Center or Fiber Meet as currently provided for in the Agreement, CLEC may interconnect with SBC-AMERITECH for purposes of delivering Local Traffic and IntraLATA Toll Traffic originating in CLEC's network for termination on SBC- AMERITECH’s network by using the method of Interconnection described below: 3.3.1 Under this method of Interconnection, CLEC will transport Local Traffic and IntraLATA Toll Traffic to SBC-AMERITECH’s Tandem Offices by using trunks (i.e., DS1's) on existing DS3 access facilities between CLEC's Switch Center POIs and the SBC-AMERITECH Tandem Office POI. Such facilities may be provided by SBC- AMERITECH, CLEC, other vendors used by CLEC or SBC-AMERITECH, or a combination thereof. 3.3.2 If additional capacity is needed for Interconnection under this method, CLEC will provision such facilities: (i) from SBC-AMERITECH under its access tariff, (ii) from SBC-AMERITECH under Article IX of the Agreement, (iii) from CLEC's own facility inventory, or (iv) from an alternative access vendor. 3.3.3 CLEC may interconnect with SBC-AMERITECH at a DS1 bandwidth. SBC-AMERITECH may allow Interconnection at other bandwidths where technically feasible and mutually agreeable at termination charges to be agreed upon by the Parties. SBC-AMERITECH will provide any multiplexing required for DS1 facilities or trunking at their end and CLEC will provide any DS1 multiplexing required for facilities or trunking at their end.
Sample 1Sample 2Sample 3See All (7)
AutoNDA by SimpleDocs
CLEC Methods of Interconnection. In addition to Collocation in SBC ILLINOIS' Switch Center or Fiber Meet as currently provided for in the Agreement, CLEC may interconnect with SBC ILLINOIS for purposes of delivering Local Traffic and IntraLATA Toll Traffic originating in CLEC's network for termination on SBC ILLINOIS' network by using the methods of Interconnection described below: 3.3.1 CLEC will transport Local Traffic and IntraLATA Toll Traffic to SBC ILLINOIS's Tandem Offices by using trunks (i.e., DS1's) on existing DS3 access facilities between CLEC's Switch Center POIs and the SBC ILLINOIS Tandem Office POI. Such facilities may be provided by SBC ILLINOIS, CLEC, other vendors used by CLEC or SBC ILLINOIS, or a combination thereof. 3.3.2 CLEC may obtain facility capacity for network interconnection trunking: (i) from SBC ILLINOIS under its access tariff, (ii) from SBC ILLINOIS under Article 9 of the Agreement, (iii) from CLEC's own facility inventory, or (iv) from an alternative access vendor.
Sample 1Sample 2Sample 3See All (5)
CLEC Methods of Interconnection. In addition to Collocation in SBC’s Switch Center or Fiber Meet as currently provided for in the Agreement, CLEC may interconnect with SBC for purposes of delivering Local Traffic and IntraLATA Toll Traffic originating in CLEC's network for termination on SBC’s network by using the method of Interconnection described below: 3.3.1 Under this method of Interconnection, CLEC will transport Local Traffic and IntraLATA Toll Traffic to SBC’s Tandem Offices by using trunks (i.e., DS1's) on existing DS3 access facilities between CLEC's Switch Center POIs and the SBC Tandem Office POI. Such facilities may be provided by SBC, CLEC, other vendors used by CLEC or SBC, or a combination thereof. 3.3.2 If additional capacity is needed for Interconnection under this method, CLEC will provision such facilities: (i) from SBC under its access tariff, (ii) from SBC under Article IX of the Agreement, (iii) from CLEC's own facility inventory, or (iv) from an alternative access vendor. 3.3.3 CLEC may interconnect with SBC at a DS1 bandwidth. SBC may allow Interconnection at other bandwidths where technically feasible and mutually agreeable at termination charges to be agreed upon by the Parties. SBC will provide any multiplexing required for DS1 facilities or trunking at their end and CLEC will provide any DS1 multiplexing required for facilities or trunking at their end.
Sample 1

Related to CLEC Methods of Interconnection

  • Methods of Interconnection The Parties will negotiate the facilities arrangement used to interconnect their respective networks. CLEC shall establish at least one (1) physical Point of Interconnection in CenturyLink territory in each LATA CLEC has local End User Customers. CLEC represents and warrants that it is serving End User Customers physically located within each local calling area for which it wishes to exchange traffic within CenturyLink territory. The Parties shall establish, through negotiations, at least one (1) of the following Interconnection arrangements, at any Technically Feasible point: (1) a DS1 or DS3 CenturyLink-provided facility; (2) Collocation; (3) negotiated Mid-Span Meet POI facilities; or (4) other Technically Feasible methods of Interconnection via the Bona Fide Request (BFR) process unless a particular arrangement has been previously provided to a third party, or is offered by CenturyLink as a product. 7.1.2.1 CenturyLink-provided Facility. Interconnection may be accomplished through the provision of a DS1 or DS3 Entrance Facility of CLEC's determination. An Entrance Facility extends from the CenturyLink Serving Wire Center to CLEC's Switch location or any Technically Feasible POI chosen by CLEC. CenturyLink-provided Entrance Facilities may not extend beyond the area served by the CenturyLink Serving Wire Center. The rates for CenturyLink-provided Entrance Facilities are provided in Exhibit A. CenturyLink's private line transport service is available as an alternative to CenturyLink-provided Entrance Facilities, when CLEC uses such private line transport service for multiple services. Entrance Facilities may not be used for Interconnection with Unbundled Network Elements. 7.1.2.2 Collocation. Interconnection may be accomplished through the Collocation arrangements offered by CenturyLink. The terms and conditions under which Collocation will be available are described in Section 8 of this Agreement. 7.1.2.2.1 Expanded Interconnection Channel Termination (EICT) provides the communication path that actually connects the physical space or in the case of virtual collocation, the designated equipment to CenturyLink's direct trunked transport and must be ordered to provision LIS to a collocation. 7.1.2.3 Mid-Span Meet POI. A Mid-Span Meet POI is a negotiated Point of Interface, limited to the Interconnection of facilities between the CenturyLink Serving Wire Center location and the location of the CLEC switch or other equipment located within the area served by the CenturyLink Serving Wire Center. The actual physical Point of Interface and facilities used will be subject to negotiations between the Parties. Each Party will be responsible for its portion of the build to the Mid-Span Meet POI. The Mid-Span Meet POI will be used exclusively as an Interconnection facility and cannot be used for other purposes such as Unbundled Network Elements or Access Services.

  • NETWORK INTERCONNECTION METHODS 3.1 The Interconnection provided herein may not be used solely for the purpose of originating a Party’s own interexchange traffic.

  • Points of Interconnection and Trunk Types 2.1 Point(s) of Interconnection. 2.1.1 Each Party, at its own expense, shall provide transport facilities to the technically feasible Point(s) of Interconnection on Verizon’s network in a LATA selected by PNG.

  • Network Interconnection Architecture Each Party will plan, design, construct and maintain the facilities within their respective systems as are necessary and proper for the provision of traffic covered by this Agreement. These facilities include but are not limited to, a sufficient number of trunks to the point of interconnection with the tandem company, and sufficient interoffice and interexchange facilities and trunks between its own central offices to adequately handle traffic between all central offices within the service areas at a P.01 grade of service or better. The provisioning and engineering of such services and facilities will comply with generally accepted industry methods and practices, and will observe the rules and regulations of the lawfully established tariffs applicable to the services provided.

  • Interconnection Service Interconnection Service allows the Interconnection Customer to connect the Large Generating Facility to the Participating TO’s Transmission System and be eligible to deliver the Large Generating Facility’s output using the available capacity of the CAISO Controlled Grid. To the extent the Interconnection Customer wants to receive Interconnection Service, the Participating TO shall construct facilities identified in Appendices A and C that the Participating TO is responsible to construct.

  • Scope of Interconnection Service 1.3.1 The NYISO will provide Energy Resource Interconnection Service and Capacity Resource Interconnection Service to Interconnection Customer at the Point of Interconnection. 1.3.2 This Agreement does not constitute an agreement to purchase or deliver the Interconnection Customer’s power. The purchase or delivery of power and other services that the Interconnection Customer may require will be covered under separate agreements, if any, or applicable provisions of NYISO’s or Connecting Transmission Owner’s tariffs. The Interconnection Customer will be responsible for separately making all necessary arrangements (including scheduling) for delivery of electricity in accordance with the applicable provisions of the ISO OATT and Connecting Transmission Owner’s tariff. The execution of this Agreement does not constitute a request for, nor agreement to, provide Energy, any Ancillary Services or Installed Capacity under the NYISO Services Tariff or any Connecting Transmission Owner’s tariff. If Interconnection Customer wishes to supply or purchase Energy, Installed Capacity or Ancillary Services, then Interconnection Customer will make application to do so in accordance with the NYISO Services Tariff or Connecting Transmission Owner’s tariff.

  • Interconnection 2.1 This section applies to linking with suppliers providing public telecommunications transport networks or services in order to allow the users of one supplier to communicate with users of another supplier and to access services provided by another supplier, where specific commitments are undertaken.

  • Interconnection Customer (1) Interconnection Customer shall construct and, unless otherwise indicated, shall own, the following Interconnection Facilities: None (2) In the event that, in accordance with the Interconnection Construction Service Agreement, Interconnection Customer has exercised the Option to Build, it is hereby permitted to build in accordance with and subject to the conditions and limitations set forth in that Section, the following portions of the Transmission Owner Interconnection Facilities which constitute or are part of the Customer Facility: None Ownership of the facilities built by Interconnection Customer pursuant to the Option to Build shall be as provided in the Interconnection Construction Service Agreement.

  • Interconnection Customer Drawings Within one hundred twenty (120) days after the date of Initial Operation, unless the Interconnection Parties agree on another mutually acceptable deadline, the Interconnection Customer shall deliver to the Transmission Provider and the Interconnected Transmission Owner final, “as-built” drawings, information and documents regarding the Customer Interconnection Facilities, including, as and to the extent applicable: a one-line diagram, a site plan showing the Customer Facility and the Customer Interconnection Facilities, plan and elevation drawings showing the layout of the Customer Interconnection Facilities, a relay functional diagram, relaying AC and DC schematic wiring diagrams and relay settings for all facilities associated with the Interconnection Customer's step-up transformers, the facilities connecting the Customer Facility to the step-up transformers and the Customer Interconnection Facilities, and the impedances (determined by factory tests) for the associated step-up transformers and the Customer Facility. As applicable, the Interconnection Customer shall provide Transmission Provider and the Interconnected Transmission Owner specifications for the excitation system, automatic voltage regulator, Customer Facility control and protection settings, transformer tap settings, and communications.

  • One-Way Interconnection Trunks 2.3.1 Where the Parties use One-Way Interconnection Trunks for the delivery of traffic from Onvoy to Frontier, Onvoy, at Xxxxx’s own expense, shall: 2.3.1.1 provide its own facilities for delivery of the traffic to the technically feasible Point(s) of Interconnection on Frontier’s network in a LATA; and/or 2.3.1.2 obtain transport for delivery of the traffic to the technically feasible Point(s) of Interconnection on Frontier’s network in a LATA (a) from a third party, or, (b) if Frontier offers such transport pursuant to a Frontier access Tariff, from Frontier. 2.3.2 For each Tandem or End Office One-Way Interconnection Trunk group for delivery of traffic from Onvoy to Frontier with a utilization level of less than sixty percent (60%) for final trunk groups and eighty-five percent (85%) for high usage trunk groups, unless the Parties agree otherwise, Onvoy will promptly submit ASRs to disconnect a sufficient number of Interconnection Trunks to attain a utilization level of approximately sixty percent (60%) for all final trunk groups and eighty-five percent (85%) for all high usage trunk groups. In the event Onvoy fails to submit an ASR to disconnect One-Way Interconnection Trunks as required by this Section, Frontier may disconnect the excess Interconnection Trunks or bill (and Onvoy shall pay) for the excess Interconnection Trunks at the rates set forth in the Pricing Attachment. 2.3.3 Where the Parties use One-Way Interconnection Trunks for the delivery of traffic from Frontier to Onvoy, Frontier, at Frontier’s own expense, shall provide its own facilities for delivery of the traffic to the technically feasible Point(s) of Interconnection on Frontier’s network in a LATA.

Draft better contracts in just 5 minutes Get the weekly Law Insider newsletter packed with expert videos, webinars, ebooks, and more!