Scope of Services The specific scope of work for each job shall be determined in advance and in writing between TIPS Member, Member’s design professionals and Vendor. It is permitted for the TIPS Member to provide a general scope description, but the awarded vendor should provide a written scope of work, and if applicable, according to the TIPS Member’s design Professional as part of the proposal. Once the scope of the job is agreed to, the TIPS Member will issue a PO and/or an Agreement or Contract with the Job Order Contract Proposal referenced or as an attachment along with bond and any other special provisions agreed by the TIPS Member. If special terms and conditions other than those covered within this solicitation and awarded Agreements are required, they will be attached to the PO and/or an Agreement or Contract and shall take precedence over those in this base TIPS Vendor Agreement.
Compensation The Depositor shall receive at the times set forth in Sections 3.05, 3.18, 3.23 and 4.03 as compensation for performing portfolio supervisory services, bookkeeping and administrative expenses and evaluation services, such amount and for such periods as specified the Prospectus and/or Reference Trust Agreement. The compensation for providing portfolio supervisory services, bookkeeping and administrative expenses and evaluation services shall be made on the basis of the largest number of units outstanding at any time during the period for which such compensation is being computed. At no time, however, will the total amount received by the Depositor for services rendered to all series of Guggenheim Defined Portfolios in any calendar year exceed the aggregate cost to them of supplying such services in such year. Such rate may be increased by the Trustee from time to time, without the consent or approval of any Unitholder, or the Depositor, by amounts not exceeding the proportionate increase during the period from the date of such Prospectus and/or Reference Trust Agreement to the date of any such increase, in consumer prices as published either under the classification "All Services Less Rent" in the Consumer Price Index published by the United States Department of Labor or, IF such Index is no longer published, a similar index. In the event that any amount of the compensation paid to the Depositor pursuant to Sections 3.05, 3.18 and 3.23 and 4.03 is found to be an improper charge against a Trust, the Depositor shall reimburse the Trust in such amount. An improper charge shall be established if a final judgment or order for reimbursement of the Trust shall be rendered against the Depositor and such judgment or order shall not be effectively stayed or a final settlement is established in which the Depositor agrees to reimburse the Trust for amounts paid to the Depositor pursuant to this Section 7.05.
Termination for Convenience TIPS may, by written notice to Vendor, terminate this Agreement for convenience, in whole or in part, at any time by giving thirty (30) days’ written notice to Vendor of such termination, and specifying the effective date thereof.
Dimensions Education Bachelor’s or Master’s Degree in Computer Science, Information Systems, or other related field. Or equivalent work experience. Experience: A minimum of 7 years of experience with large and complex database management systems.
SCOPE OF WORK The Contractor has overall responsibility for and shall provide and furnish all materials, equipment, tools and labor as necessary or reasonably inferable to complete the Work, or any phase of the Work, in accordance with the Owner’s requirements and the terms of the Contract Documents.
Grievance Procedure 7.01 For purposes of this Agreement, a grievance is defined as a difference arising between the parties relating to the interpretation, application, administration or alleged violation of the Agreement including any question as to whether a matter is arbitrable.
Termination for Cause If Vendor fails to materially perform pursuant to the terms of this Agreement, TIPS shall provide written notice to Vendor specifying the default. If Vendor does not cure such default within thirty (30) days, TIPS may terminate this Agreement, in whole or in part, for cause. If TIPS terminates this Agreement for cause, and it is later determined that the termination for cause was wrongful, the termination shall automatically be converted to and treated as a termination for convenience.
RECOGNITION 1. For the purposes of the fulfillment, in whole or in part, of its standards or criteria for the authorization, licensing or certification of services suppliers, and subject to the requirements of paragraph 3, a Party may recognize the education or experience obtained, requirements met, or licences or certifications granted in the other Party or a non-Party. Such recognition, which may be achieved through harmonization or otherwise, may be based upon an agreement or arrangement with the other Party or a non-Party concerned or may be accorded autonomously. 2. A Party that is a party to an agreement or arrangement of the type referred to in paragraph 1, whether existing or future, shall afford adequate opportunity for the other Party, if the other Party is interested, to negotiate its accession to such an agreement or arrangement or to negotiate comparable ones with it. Where a Party accords recognition autonomously, it shall afford adequate opportunity for the other Party to demonstrate that education, experience, licences or certifications obtained or requirements met in that other Party's territory should be recognized. 3. A Party shall not accord recognition in a manner which would constitute a means of discrimination between countries in the application of its standards or criteria for the authorization, licensing or certification of services suppliers, or a disguised restriction on trade in services. 4. Each Party should encourage the relevant bodies in its respective territory to conduct future negotiations for developing mutually acceptable standards and criteria for licensing, temporary licensing and certification of professional services suppliers.
Complexity Intermediate professional level role. Provides data warehouse architectural design, development and support in multi-platform environments. Works on multiple projects as a team member and may lead projects of moderate complexity. May coach more junior technical staff.
Overtime Overtime will begin to accrue after sixty (60) hours in a two (2) week period averaged over the scheduling period determined by the local parties. Overtime will apply if the employee works in excess of the normal daily hours. Payment for overtime is as in Article 16.01.
