Correction of Unsafe Conditions. Contractor shall correct any violations of safety laws, rules, orders, standards, or regulations. Contractor shall correct violations promptly upon the issuance of a citation or notice of violation by the Division of Occupational Safety and Health.
Correction of Unsafe Conditions. (a) Whenever an employee observes what appears to be an unsafe or harmful condition or act the employee shall report it as soon as possible to a supervisor or to the Employer. The person receiving the report shall investigate the reported unsafe conditions or act and shall ensure that any necessary corrective action is taken without delay.
Correction of Unsafe Conditions. If Design-Builder observes an unsafe condition or activity on-site, property damage, or personal injury, it shall: (a) stop Work in areas potentially impacted or endangered by it; (b) remove workers from the affected area, securing immediate medical and emergency assistance where persons are injured or property is further threatened; (c) post and secure the unsafe area; (d) stabilize the condition; and (e) immediately notify the ADR by e-mail (and telephone if jeopardy to life or property is involved), detailing: (i) the unsafe condition; (ii) what Work was stopped; (iii) which workers were removed from the area, when, and under what circumstances; (iv) whether and how the unsafe condition was stabilized and secured;
Correction of Unsafe Conditions. If CM observes an unsafe condition or activity on-site, property damage, or personal injury, it shall: (a) stop Work in areas potentially impacted or endangered by it; (b) remove workers from the affected area, securing immediate medical and emergency assistance where persons are injured or property is further threatened; (c) post and secure the unsafe area; (d) stabilize the condition; and (e) immediately notify the ADR by e-mail (and telephone if jeopardy to life or property is involved), detailing: (i) the unsafe condition; (ii) what Work was stopped; (iii) which workers were removed from the area, when, and under what circumstances; (iv) whether and how the unsafe condition was stabilized and secured; (v) known or suspected causes of the condition; and (vi) recommended alternative remedies or means to correct it. CM shall continually update the ADR as to: (A) corrective measures taken;
Correction of Unsafe Conditions. If Contractor observes an unsafe condition or activity on-site, property damage, or personal injury, it shall: (a) stop Work in areas potentially impacted or endangered by it; (b) remove workers from the affected area, securing immediate medical and emergency assistance where persons are injured or property is further threatened; (c) post and secure the unsafe area; (d) stabilize the condition; and (e) immediately notify the ADR by e-mail (and telephone if jeopardy to life or property is involved), detailing: (i) the unsafe condition; (ii) what Work was stopped; (iii) which workers were removed from the area, when, and under what circumstances; (iv) whether and how the unsafe condition was stabilized and secured; (v) known or suspected causes of the condition; and (vi) recommended alternative remedies or means to correct it. Contractor shall continually update the ADR as to: (A) corrective measures taken; (B) which Laws and contract provisions were affected; (C) which emergency, health, medical, law enforcement, or other officials or facilities, if any, were notified, and how they responded; (D) whether citations were issued, fines imposed, or other governmental action was taken or threatened; (E) how and when correction will be completed and Work resumed; (F) how the condition was ultimately corrected or rendered safe; and (G) what adjustments, if any, are needed to conform to the Project Schedule and to complete the Work within the Contract Time.
