Dangerous Working Conditions Sample Clauses
Dangerous Working Conditions
Unsafe Working Conditions Employees shall be recognized by the Employer to have the competence to determine what constitutes unsafe working conditions within their discipline. No employee shall be disciplined for refusal to work in a situation which is deemed unsafe beyond the reasonable requirements of the employee's job.
Safe Working Conditions The Employer undertakes to maintain office furniture, equipment, etc., in a practical and safe condition in order to avoid injury to employees or damage to their attire. Employees, for their part and in their own interest, are expected to advise the Employer of any such potentially injurious equipment.
WORKING CONDITIONS In order to effectively resolve workload issues, please provide details about the working conditions at the time of occurrence by providing the following information: Regular Staffing #: RN RPN PSW Clerks & Other Actual Staffing #: RN RPN PSW Clerks & Other Agency/Registry RN: Yes No And how many? Junior Staff*: Yes No And how many? RN RPN PSW Temp RNs RN Staff Overtime: Yes No If yes, how many staff? Total Hours: If there was a shortage of staff at the time of the occurrence, (including support staff) please check one or all of the following that apply: Absence/Emergency Leave Sick Call(s) Vacancies Management Support available on site? Yes No On Standby? Yes No On Call? Yes No Did they respond? Yes No Did they resolve the issue? Yes No Charge nurses (CN) are not held accountable for the actions of others, they are accountable for their actions in relation to others (“Nurse in Charge”, CNO Communique, Sept. 2002). Were you working in a Charge Nurse Leadership Role? Yes No i) Assigning: Could you assign staff according to their abilities? Yes No Did you have time to determine what staff was most likely to need your help? Yes No Did you have time to provide necessary support and supervision? Yes No
GENERAL WORKING CONDITIONS Section 18-1. Employment begins and ends at each project site. Section 18-2. The selection of craft foremen and/or general foremen and the number of foremen required shall be entirely the responsibility of the Employer, it being understood that in the selection of such foremen and/or general foremen the Employer will give primary consideration to the qualified individuals available in the local area. After giving such consideration, the Employer may select such individuals from other areas. All foremen shall take orders from the designated Employer representatives. Craft foremen shall be designated working foremen at the request of the Employer. Section 18-3. There shall be no limit on production by employees nor restrictions on the full use of tools or equipment. Employees using tools shall perform any of the work of the trade and shall work under the direction of the craft foremen. There shall be no restrictions on efficient use of manpower other than as may be required by safety regulations. Section 18-4. Employees shall be at their place of work at the starting time and shall remain at their place of work performing their assigned functions under the supervision of the Employer until quitting time. The parties reaffirm their policy of a fair day’s work for a fair day’s wage. Section 18-5. All equipment assigned to a project shall be under the control of the Employer. The Employer shall have the right to determine how many pieces of equipment an individual employee shall operate. In an emergency, foremen shall operate any equipment assigned by the Employer, and there shall be no restriction on foremen in the use of the tools of his or her craft in such emergency. The foremen shall be from the craft normally operating the equipment. In accordance with currently recognized craft jurisdiction, the Employer shall determine the assignment of employees to start, stop, and maintain small portable construction equipment. Such work may be assigned to craft employees within a reasonable distance of their primary duties or an employee may be assigned full time to start, stop and maintain the Employer’s small, portable equipment on the job site. There shall be no over xxxxxxx of this type of equipment. The number of employees assigned to rigging and scaffolding operations shall be at the sole discretion of the Employer. The ratio of journeyperson to welders shall be determined solely by the Employer. Section 18-6. The Employer may utilize the most efficient methods or techniques of construction, tools or other labor saving devices to accomplish the work. Practices not a part of the terms and conditions of this Agreement, stand by crews and feather bedding practices will not be recognized. Section 18-7. It is recognized that specialized or unusual equipment may be installed and/ or serviced by individuals who have special training, skill, or qualifications and are not covered by this Agreement. Testing, inspection, or service performed on plant equipment under warranty may be performed by the vendor’s personnel. Section 18-8. Neither the Union nor its local unions shall coerce or in any way interfere with the Owner’s personnel, operation or facilities at the plant site. The Owner’s right to contract directly with other companies for work at the plant site shall not be limited, and the Union shall cooperate and not interfere with the Employer’s operations. Section 18-9. It is agreed that overtime is undesirable and not in the best interest of the industry or the employees; therefore, except in unusual circumstances, overtime will not be worked. Where unusual circumstances do exist, however, the Employer will have the right to assign specific employees and/or crews to perform such overtime work as is necessary to accomplish the job. Section 18-10. There will be no rest periods, organized coffee breaks or other non-working time established during working hours. Section 18-11. Individual seniority shall not be recognized or applied to employees working on projects under this Agreement. Section 18-12. The Employer shall establish such reasonable project rules as the Employer deems appropriate. These rules will be reviewed at the pre-job conference and posted at the project site by the Employer, and may be amended thereafter as necessary.
Unsafe Work Conditions No Employee shall be disciplined for refusal to work on a job which in the opinion of: (a) A member of a safety committee; or (b) A person designated by a safety committee; or (c) A safety officer after an on-site inspection and following discussion with a representative of the Employer, does not meet the standards established pursuant to the Workers' Compensation Act.
TEACHING CONDITIONS The parties recognize that optimum school facilities for both student and teacher are desirable to insure the high quality of education that is the goal of both the Association and the Board. It is also acknowledged that the primary duty and responsibility of the teacher is to teach and that the organization of the school and school day should be directed toward ensuring that the energy of the teacher is primarily utilized to this end.
Hazardous Conditions Whenever the Contractor’s operations create a condition hazardous to traffic or to the public, the Contractor shall provide flagmen and furnish, erect and maintain control devices as are necessary to prevent accidents or damage or injury to the public at Contractor’s expense and without cost to the County. The Contractor shall comply with County directives regarding potential hazards. Emergency lights and traffic cones must also be readily available at all times and must be used in any hazardous condition. Emergency traffic cones must be placed in front of and behind vehicles to warn oncoming traffic. Signs, lights, flags, and other warning and safety devices shall conform to the requirements set forth in Chapter 5 of the current traffic manual, Traffic Control for Construction and Maintenance Work Zones, published by the state of California Department of Transportation. The Contractor shall take proper safety and health precautions to protect the Work, the workers, the public, and the property of others. The Contractor shall also be responsible for all materials delivered and Work performed until completion and acceptance of the entire construction Work, except for any completed unit of construction thereof which theretofore may have been accepted.
Unsafe Conditions In accordance with 29 CFR § 1977, occasions might arise when an employee is confronted with a choice between not performing assigned tasks or subjecting himself/herself to serious injury or death arising from a hazardous condition at the workplace. If the employee, with no reasonable alternative, refuses in good faith to expose himself/herself to the dangerous condition, he/she would be protected against subsequent discrimination. The condition causing the employee's apprehension of death or injury must be of such a nature that a reasonable person, under the circumstances then confronting the employee, would conclude that there is a real danger of death or serious injury and that there is insufficient time, due to the urgency of the situation, to eliminate the danger by resorting to regular statutory enforcement channels. In addition, in such circumstances, the employee, where possible, must also have sought from his Employer, and been unable to obtain, a correction of the dangerous condition.
Existing Conditions Tenant accepts the Property in its condition as of the execution of the Lease, subject to all recorded matters, laws, ordinances, and governmental regulations and orders. Except as provided herein, Tenant acknowledges that neither Landlord nor any agent of Landlord has made any representation as to the condition of the Property or the suitability of the Property for Tenant's intended use. Tenant represents and warrants that Tenant has made its own inspection of and inquiry regarding the condition of the Property and is not relying on any representations of Landlord or any Broker with respect thereto. If Landlord or Landlord's Broker has provided a Property Information Sheet or other Disclosure Statement regarding the Property, a copy is attached as an exhibit to the Lease.
Buyer’s Conditions Buyer’s obligations to Close are conditioned upon the following (“Buyer’s Conditions”): (i) All representations and warranties of Seller in this Agreement shall be true, correct and complete in all material respects as of the Closing Date and Seller shall have performed in all material respects all covenants and obligations required to be performed by Seller on or before the Closing Date. (ii) Title Insurance Company is irrevocably committed to issue to Buyer an owner’s title insurance policy covering the Property with standard coverage customary in the state where the Property is located showing liability in the amount of the Purchase Price and showing insurable title to the Property vested in Buyer, subject only to the following: (a) Title Insurance Company’s standard exceptions; (b) liens for all current general and special real property taxes and assessments not yet due and payable; (c) liens of supplemental taxes, if any assessed; (d) any facts an accurate survey and/or a personal inspection of the Property may disclose; (e) the mortgage/deed of trust/deed to secure debt lien in connection with any Buyer financing; (f) any laws, regulations, ordinances (including but not limited to, zoning, building and environmental) as to the use, occupancy, subdivision or improvement of the Property adopted or imposed by any governmental body, or the effect of any non-compliance with or any violation thereof, including but not limited to, any disclosure and/or report required by ordinance; (g) rights of existing tenants and/or occupants of the Property (if any); (h) covenants, restrictions, easements and other matters that do not materially impair the value of the Property or the use thereof; (i) non-monetary encumbrances disclosed to Buyer in writing prior to entering into this Agreement; and (j) any other matter for which Title Insurance Company agrees to provide insurance at no additional cost to Buyer.