Electrical Codes Sample Clauses

Electrical Codes. Electrical equipment supplied shall comply with latest applicable codes and standards of the Institute of Electrical and Electronic Engineer's (IEEE), the National Electrical Code (NEC), National Electrical Manufacturers Association (NEMA), and the Instrument Society of America (ISA). -------------------------------------------------------------------------------- Proprietary Information Page 2 AES IRONWOOD CONTRACT FINAL ISSUE - OCTOBER 30, 1998 -------------------------------------------------------------------------------- Requirements for electrical equipment certification shall be in accordance with local building codes.
AutoNDA by SimpleDocs
Electrical Codes a. Electrical work will conform with the national, state and local electrical codes.
Electrical Codes. All Electrical designs shall conform to the requirements of the New York City Electrical Code.

Related to Electrical Codes

  • Electrical Equipment Residents must use only CSA, UL-approved or Canadian-certified electrical equipment; the rated wattage of light fixtures must never be exceeded; and only replacement bulbs supplied by Waterloo maintenance staff may be used. Do not leave any unattended electrical equipment turned on (i.e. hair straighteners, lights etc.)

  • Building Codes The following Building Codes, in the latest editions approved by the Georgia Department of Community Affairs, shall be used. (See O.C.G.A. §8-2-20.) The Design Professional will designate any additional codes or special modifications in the Supplementary General Conditions. As of the year 2000, these codes are published jointly by the Southern Building Code Congress International, the International Code Council, the Building Officials and Code Administrators, International, and the International Conference of Building Officials, and are commonly referred to as the International Building Codes. 1.7.1.3.1 Georgia State Minimum Standard Building Code (International Building Code, 2000 Edition) with Georgia Amendments. 1.7.1.3.2 Georgia State Minimum Standard Mechanical Code (International Mechanical Code, 2000 Edition), with Georgia Amendments. 1.7.1.3.3 Georgia State Minimum Standard Gas Code (International Fuel Gas Code, 2000 Edition), with Georgia Amendments. 1.7.1.3.4 Georgia State Minimum Standard Plumbing Code (International Plumbing Code, 2000 Edition), with Georgia Amendments. 1.7.1.3.5 Georgia State Minimum Standard Electric Code (National Electrical Code, 2002 Edition), with Georgia Amendments. 1.7.1.3.6 Georgia State Minimum Standard Energy Code (International Energy Conservation Code, 2000 Edition), with Georgia Amendments. 1.7.1.3.7 Georgia State Minimum Standard Fire Prevention Code (International Fire Code, 2003 Edition), with Georgia Amendments.

  • Fixtures The Seller agrees that all fixtures shall be included as part of the sale EXCEPT: _

  • Utilities; Amenities The following utilities are included in the Total Rent set forth in this Agreement: Internet access and trash disposal. Resident will pay as additional Rent a pro-rata share (based on the number of contracted residents in possession for the applicable period) for the apartment's usage of electricity and water, applied pro-rata to any partial billing cycle. Resident will be responsible for his or her pro-rata share of electricity and water charges during the term of this Agreement, regardless of actual date of move-in or move-out. No refund or credit will be provided for usage below any applicable allowance levels. In connection with the administration of utility billing during the term of this Agreement, Resident will pay prior to occupying the assigned apartment (or on the first utility bill, at Owner's discretion), a single up-front billing service fee of up to $72.00 (or alternately, at Owner's option, a service fee of up to $6.00 per monthly bill) for administration, billing, overhead and similar expenses and charges incurred by Owner for providing utility allocations and billing services. Upon Resident's request, Owner will provide copies of applicable utility bills. At Owner's option, to the extent permitted by law, Resident may be pre-billed for the estimated amount of charges for any electricity and/or water bills anticipated to be received during the final 30 days of the term or after the end of the term of this Agreement, calculated based on historical electricity and/or water charges for the apartment and pursuant to applicable utility billing laws and regulations. As part of each utility bill, Resident may be charged and agrees to pay promptly to Owner any other miscellaneous charges billed by the utility provider and payable by the customer of record, plus late payment fees and/or NSF fees, as may be applicable, in the amounts stated in paragraph 2 of this Agreement, as liquidated estimates of costs incurred in connection with the administration and collection of late payment. Owner may elect to use one or more third-party service providers for providing, billing and/or servicing utility accounts; Resident acknowledges that such third-party providers are not utility providers. Owner makes no representations and hereby disclaims any and all warranties, express or implied, with respect to any utilities provided, including but not limited to those warranties concerning merchantability and fitness for a particular purpose or use, whether made allegedly by Owner or its representatives or agents, whether in writing or otherwise, except as otherwise expressly stated in this Agreement. Owner does not warrant or guarantee the protection of Resident's privacy during operation of utilities, that such utilities will satisfy Resident's requirements, or that the operation of utilities will be uninterrupted or error free. Resident acknowledges and agrees that neither Owner nor its affiliates, agents, employees or representatives will be responsible to Resident for any non-economic, consequential, incidental, indirect or special damages, including incidental, economic or punitive damages, arising from breach of warranty, breach of contract, negligence or any other legal ground of action, or by reason of the use, discontinuation or modification of any utilities or the termination of any utilities, whether arising from Resident's use of (or inability to use) utilities, or otherwise, even if Owner has been advised of the possibility of such damage. In the event that any utility service proves defective, or is discontinued or terminated, Owner's and Manager's entire combined liability and Resident's exclusive remedy will be limited to a reimbursement of the approximate cost of that utility incurred by Resident, prorated by the day for each day the utility service proved defective, or was discontinued or terminated, for more than 24 hours. Resident agrees to indemnify, defend and hold harmless Owner and its employees, affiliates and agents, from any and all losses, claims, damages, expenses, other liabilities and causes of action of every nature, including attorney fees, which arise directly or indirectly in connection with: (i) violation by Resident of any laws, ordinances, regulations or rules regarding the utilities; or (ii) illegal or inappropriate use of the utilities. Any damage or loss to any utility devices during Resident's occupancy will be charged to Resident (and the other resident(s) in the apartment, as applicable) at the replacement cost. Management will establish schedules and policies for the use of recreation facilities, amenities and other common spaces. Owner may add, remove, close (temporarily or permanently), upgrade or modify any of the recreation facilities, amenities or common spaces in Owner's discretion, without notice or compensation; provided that if this Agreement expressly includes a separate Amenity Fee, Resident's sole remedy will be limited to a pro-rata credit of such Amenity Fee for the period a covered amenity is closed or fully unavailable. SAMPLE

  • Electrical Provide drawings for the following systems: .1 Lighting including circuiting and luminaire identification and switching. Also provide illuminance computer printout for all indoor typical indoor spaces and parking lots. .2 Convenience outlets and circuiting, special outlets and circuiting, television outlets, and power systems and equipment. Provide riser diagrams for all electrical systems including master clock, intercom, fire alarm, ITV, computer networking/telephone. Also, provide for emergency and normal power distribution. Provide luminaire schedule. .3 Panel schedule may be in preliminary form but circuitry must be included. .4 Applicable installation details. .5 General legend and list of abbreviations. .6 Voltage drop computation for all main feeders. .7 Short circuit analysis .8 Provide 1/2" scale floor plan and wall elevations for all electrical rooms.

  • Electrical connections Equipment requiring electrical connections for operation shall either be hard wired to the Authorized User's provided connections or the Contractor shall be responsible for a male electrical union. All connections shall be made by the Contractor and accomplished in accordance with National Electrical Code requirements. Electrically operated equipment shall be available in the following volts and phases: 208 volt 1 or 3 phase, 60 HZ 220 volt 1 or 3 phase, 60 HZ 440 volt 1 or 3 phase, 60 HZ

  • Lighting A system of fixtures providing or controlling the light sources used on or near the airport or within the airport buildings. The field lighting includes all luminous signals, markers, floodlights, and illuminating devices used on or near the airport or to aid in the operation of aircraft landing at, taking off from, or taxiing on the airport surface.

  • Installations Any special carpentry, wiring, electrical or other work, gas, steam, water and drainage connection shall be installed at Exhibitor’s expense, and in accordance with the building and Management’s direction.

  • Drainage Systems (1) Clear culvert inlets, outlets, and sediment catching basins. (2) Maintain waterbars, drainage dips, and other water diversion measures. (3) During active use, patrol and maintain functional drainage. (4) Repair damaged culvert ends.

  • Utility Any service provided by an outside source or manufactured in-house that facilitates building operations (e.g., gas, water, electricity, fire suppression water, fire alarm systems).

Draft better contracts in just 5 minutes Get the weekly Law Insider newsletter packed with expert videos, webinars, ebooks, and more!