Follow general T»k»-Down (Exterior Sample Clauses

Follow general T»k»-Down (Exterior instructions, Step* 1-9, discussed later in this manual. SYSTEMS WATER SYSTEM Fresh water may be supplied to the sink from one of two sources; either a water tank or a city water hook-up. Fixtures for both sources are located adjacent to each other on the same side of the camper and are labeled. You should install a pressure reducer in the campground faucet that will limit the pressure to 60 PSI If the source pressure exceeds that amount. The city water bypasses the internal water tank, but does fill the water heater. Open a hot water faucet to help fill the heater tank. In either case, put only clean drinkable water in the system. DEMAND PUMP The pressure in the internal tank system comes from the 12V demand pump. Open the faucet the first time you turn on the demand pump until the water flows steadily, then close the faucet. When the system is pressurized, the pump will stay off until you use water. Then the pump turns on to meet the demand. If it turns on between uses, check the system for leaks. Do not run the pump when the tank is empty. Before breaking camp, turn the pump switch to off and make sure it's off by turning on the cold water faucet. When you're sure the pump is off, close the faucet. See Step 4 under Storage for cold weather protection. WATER FILLS There are two water fills on Starcraft campers (see photographs next page) The city water fill uses a hose connection which can be used to provide water pressure without the use of the 12V pump. The country or "gravity" water fill is used to pour water into the storage tank when water hook ups are not available.
AutoNDA by SimpleDocs

Related to Follow general T»k»-Down (Exterior

  • Provisioning of High Frequency Spectrum and Splitter Space 3.2.1 BellSouth will provide <<customer_name>> with access to the High Frequency Spectrum as follows:

  • Modification of the Small Generating Facility The Interconnection Customer must receive written authorization from the NYISO and Connecting Transmission Owner before making any change to the Small Generating Facility that may have a material impact on the safety or reliability of the New York State Transmission System or the Distribution System. Such authorization shall not be unreasonably withheld. Modifications shall be done in accordance with Good Utility Practice. If the Interconnection Customer makes such modification without the prior written authorization of the NYISO and Connecting Transmission Owner, the Connecting Transmission Owner shall have the right to temporarily disconnect the Small Generating Facility. If disconnected, the Small Generating Facility will not be reconnected until the unauthorized modifications are authorized or removed.

  • Additional Wet Weather Procedure 14.15.1 Remaining On Site Where, because of wet weather, the employees are prevented from working:

  • Provisioning of Line Sharing and Splitter Space 3.2.1 BellSouth will provide ONS with access to the High Frequency Spectrum as follows:

  • Union Access to Premises Representatives of the Union shall have access to the Company’s premises to carry on inspections or investigations pertaining to the terms and conditions of this Agreement, upon reasonable advance notice to the Company. Such access shall be carried on at reasonable hours and in such a manner so as not to interfere with the normal operations of the Company. The Union will advise the Company of its designated representatives who wish to gain access to the premises and the Union agrees to comply with all reasonable Company security precautions as may be in force from time to time.

  • Preconstruction Phase Services Preconstruction Phase Services shall mean all services described in Article 3.1, and any similar services described in the Request for Proposals, including such similar services as are described in the Construction Manager at Risk’s Response to the Request for Proposals to the extent they are accepted by Owner, but excluding any Early Work. Early Work shall be considered part of Construction Phase Services.

  • Disbursement Generally OEM shall reimburse eligible costs incurred in carrying out the Project, up to the Grant Fund amount provided in Section 3. Reimbursements shall be made by OEM upon approval by OEM of an RFR. Eligible costs are the reasonable and necessary costs incurred by Subrecipient for the Project, in accordance with the Emergency Management Performance Grants guidance and application materials, including without limitation the United States Department of Homeland Security Notice of Funding Opportunity Announcement (NOFO), that are not excluded from reimbursement by OEM, either by this Agreement or by exclusion as a result of financial review or audit. The guidance, application materials and NOFO are available at xxxx://xxx.xxxxxx.xxx/OEM/emresources/Grants/Pages/EMPG.aspx

  • Drawings Submitted During the Contract Term Where required to develop maintain and deliver diagrams or other technical schematics regarding the scope of work, Contractor shall do so on an ongoing basis at no additional charge, and must, as a condition of payment, update drawings and plans during the Contract term to reflect additions, alterations, and deletions. Such drawings and diagrams shall be delivered to the Authorized User’s representative.

  • Initial Forecasts/Trunking Requirements Because Verizon’s trunking requirements will, at least during an initial period, be dependent on the Customer segments and service segments within Customer segments to whom CSTC decides to market its services, Verizon will be largely dependent on CSTC to provide accurate trunk forecasts for both inbound (from Verizon) and outbound (to Verizon) traffic. Verizon will, as an initial matter, provide the same number of trunks to terminate Reciprocal Compensation Traffic to CSTC as CSTC provides to terminate Reciprocal Compensation Traffic to Verizon. At Verizon’s discretion, when CSTC expressly identifies particular situations that are expected to produce traffic that is substantially skewed in either the inbound or outbound direction, Verizon will provide the number of trunks CSTC suggests; provided, however, that in all cases Verizon’s provision of the forecasted number of trunks to CSTC is conditioned on the following: that such forecast is based on reasonable engineering criteria, there are no capacity constraints, and CSTC’s previous forecasts have proven to be reliable and accurate.

  • Please see the current Washtenaw Community College catalog for up-to-date program requirements Secondary / Post-Secondary Program Alignment Welding HIGH SCHOOL COURSE SEQUENCE 9th Grade 10th Grade 11th Grade 12th Grade English 9 Algebra I World History/Geography Biology World Language Phys Ed/Health English 10 Geometry U.S. History/Geography Physics or Chemistry World Language Visual/Performing/Applied Arts English 11 Algebra II Civics/Economics Welding English 12 Math Credit Science Credit Welding WASHTENAW COMMUNITY COLLEGE Welding Associate in Applied Science Semester 1 Math Elective(s)* 3 WAF 105 Introduction to Welding Processes 2 WAF 111 Oxy-fuel Welding 4 WAF 112 Shielded Metal Arc Welding 4 Semester Total 13 Semester 2 Speech Elective(s) 3 WAF 106 Blueprint Reading for Welders 3 WAF 123 Advanced Oxy-fuel Welding 4 WAF 124 Advanced Shielded Metal Arc Welding 4 Semester Total 14 Semester 3 Arts/Human. Elective(s) 3 Computer Lit. Elective(s) 3 WAF 215 Advanced Gas Tungsten Arc Welding 4 WAF 288 Gas Metal Arc Welding 4 Semester Total 14 Semester 4 WAF 200 Layout Theory Welding 3 WAF 210 Welding Metallurgy 3 Soc. Sci. Elective(s) 3 WAF 226 Specialized Welding Procedures 4 Semester Total 13 Semester 5 Nat. Sci. Elective(s) 4 WAF 227 Basic Fabrication 3 WAF 229 Shape Cutting Operations 3 Writing Elective(s) 3 Semester Total 13 Program Totals 67

Draft better contracts in just 5 minutes Get the weekly Law Insider newsletter packed with expert videos, webinars, ebooks, and more!