Limitation on Number of Leaves Sample Clauses

Limitation on Number of Leaves. 17 The number of unit members granted Sabbatical Leaves shall always be related to and dependent 18 upon the availability of funds, but the number of persons on Sabbatical Leave at any given time 19 shall not exceed a total of 3% of the unit members. Should the number of qualified applicants 20 exceed this number, first consideration for approval shall be given those programs judged to be of 21 greatest value to the District.
AutoNDA by SimpleDocs
Limitation on Number of Leaves. The Board of Education shall grant sabbatical leaves each year. This shall be announced no later than April 1 of each school year. The Association and the District’s Representative shall meet and confer on the exact number to recommend to the Board of Education as a joint agreement.
Limitation on Number of Leaves. Approval of sabbatical leaves, if any, will rest exclusively with the District Superintendent and Board of Trustees, and in no case will the number be greater than two percent of full-time regular certificated teaching staff in any one year.

Related to Limitation on Number of Leaves

  • Rollover of XXX Xxxx If you receive a refund of eligible retirement plan assets that had been wrongfully levied, you may roll over the amount returned up until your tax return due date (not including extensions) for the year in which the money was returned.

  • Limitation on Use Tenant shall use the Premises solely for the Permitted Use specified in Section N of the Summary. There shall not be any change in use without the prior written consent of Landlord which will not be unreasonably withheld. Tenant shall not do anything in or about the Premises which will (i) cause structural injury to the Building, or (ii) cause damage to any part of the Building except to the extent reasonably necessary for the installation of Tenant’s Trade Fixtures and Tenant’s Alterations, and then only in a manner which has been first approved by Landlord in writing. Tenant shall not operate any equipment within the Premises which will (i) materially damage the Building or the Common Area, (ii) overload existing electrical systems or other mechanical equipment servicing the Building, (iii) impair the efficient operation of the sprinkler system or the heating, ventilating or air conditioning (“HVAC”) equipment within or servicing the Building, or (iv) damage, overload or corrode the sanitary sewer system. Tenant shall not attach, hang or suspend anything from the ceiling, roof, walls or columns of the Building or set any load on the floor in excess of the load limits for which such items are designed nor operate hard wheel forklifts within the Premises. Any dust, fumes, or waste products generated by Tenant’s use of the Premises shall be contained and disposed so that they do not (i) create an unreasonable fire or health hazard, (ii) damage the Premises, or (iii) result in the violation of any Law. Except as approved by Landlord, Tenant shall not change the exterior of the Building or install any equipment or antennas on or make any penetrations of the exterior or roof of the Building. Tenant shall not commit any waste in or about the Premises, and Tenant shall keep the Premises in a neat, clean, attractive and orderly condition, free of any nuisances. If Landlord designates a standard window covering for use throughout the Building, Tenant shall use this standard window covering to cover all windows in the Premises. Tenant shall not conduct on any portion of the Premises or the Project any sale of any kind, including any public or private auction, fire sale, going-out-of-business sale, distress sale or other liquidation sale.

  • Limitation on Out of-State Litigation - Texas Business and Commerce Code § 272 This is a requirement of the TIPS Contract and is non-negotiable. Texas Business and Commerce Code § 272 prohibits a construction contract, or an agreement collateral to or affecting the construction contract, from containing a provision making the contract or agreement, or any conflict arising under the contract or agreement, subject to another state’s law, litigation in the courts of another state, or arbitration in another state. If included in Texas construction contracts, such provisions are voidable by a party obligated by the contract or agreement to perform the work. By submission of this proposal, Vendor acknowledges this law and if Vendor enters into a construction contract with a Texas TIPS Member under this procurement, Vendor certifies compliance.

  • Limitation on Benefits (a) It is the intention of the Executive and of the Employers that no payments by the Employers to or for the benefit of the Executive under this Agreement and/or any other agreement or plan pursuant to which the Executive is entitled to receive payments or benefits shall be non-deductible to the Employers by reason of the operation of Section 280G of the Code relating to parachute payments. Accordingly, and notwithstanding any other provision of this Agreement or any such agreement or plan, if by reason of the operation of said Section 280G, any such payments exceed the amount which can be deducted by the Employers in the aggregate, such payments shall be reduced to the maximum amount which can be deducted by the Employers. To the extent that payments exceeding such maximum deductible amount have been made to or for the benefit of the Executive, such excess payments shall be refunded to the Employers with interest thereon at the applicable Federal Rate determined under Section 1274(d) of the Code, compounded annually, or at such other rate as may be required in order that no such payments shall be non-deductible to the Employers by reason of the operation of said Section 280G. To the extent that there is more than one method of reducing the payments to bring them within the limitations of said Section 280G, the Executive shall determine which method shall be followed, provided that if the Executive fails to make such determination within forty-five days after the Employers have sent him written notice of the need for such reduction, the Employers may determine the method of such reduction in their sole discretion.

  • Limitation on Market Access Limitation on National Treatment Additional Commitments (b) Accounting and auditing and bookkeeping services (CPC 862) (1) None. (2) None. (3) None. (4) Unbound, except as indicated in the horizontal section. (1) None. (2) None. (3) None. (4) Unbound, except as indicated in the horizontal section.

  • XXXXX-XXXXX AND RELATED ACT PROVISIONS This section is applicable to all Federal-aid construction projects exceeding $2,000 and to all related subcontracts and lower-tier subcontracts (regardless of subcontract size). The requirements apply to all projects located within the right-of- way of a roadway that is functionally classified as Federal-aid highway. This excludes roadways functionally classified as local roads or rural minor collectors, which are exempt. Contracting agencies may elect to apply these requirements to other projects. The following provisions are from the U.S. Department of Labor regulations in 29 CFR 5.5 “Contract provisions and related matters” with minor revisions to conform to the FHWA- 1273 format and FHWA program requirements.

  • Xxxxxx Limitation The Service reserves the right to refuse to pay any Xxxxxx to whom you may direct a payment. As required by applicable law, the Service will notify you promptly if it decides to refuse to pay a Xxxxxx designated by you. as set forth in Section 13 of the General Terms (Prohibited Payments) or an Exception Payment under this Agreement.

  • Venue Limitation for TIPS Sales Vendor agrees that if any "Venue" provision is included in any TIPS Sale Agreement/contract between Vendor and a TIPS Member, that clause must provide that the "Venue" for any litigation or alternative dispute resolution shall be in the state and county where the TIPS Member operates unless the TIPS Member expressly agrees otherwise. Any TIPS Sale Supplemental Agreement containing a “Venue” clause that conflicts with these terms is rendered void and unenforceable.

  • Purpose limitation The data importer shall process the personal data only for the specific purpose(s) of the transfer, as set out in Annex I.B, unless on further instructions from the data exporter.

  • Termination on Insolvency The Authority may terminate this Framework Agreement with immediate effect by notice in writing where the Supplier is a company and in respect of the Supplier:

Draft better contracts in just 5 minutes Get the weekly Law Insider newsletter packed with expert videos, webinars, ebooks, and more!