Lines and Markings Sample Clauses

Lines and Markings. 1. When drawing Lines and Markings on parking spaces outdoors, the parking space that is to be marked must be free of sand and swept clean and free of xxxx and weeds on the day of the marking. If these conditions have not been met, the work cannot be carried out; in that case, Eneco may charge extra costs to the Customer. 2. The working area and the directly adjacent parking spaces must be completely freely available. These spaces must be fenced off in advance by the Customer to avoid unnecessary waiting times: in this case Eneco may charge extra costs to the Customer. 3. Weather conditions determine to a large extent whether the work can be carried out. An earlier issued planning can therefore change. When the work cannot be carried out, the appointment will be rescheduled in consultation with the Customer. 4. Work can be carried out at temperatures above the freezing point and under dry weather conditions. 5. Any waiting times that are not attributable to Eneco or to a third party contracted by Eneco, are charged to the Customer based on post-calculation. 6. In the event of high pressure water spray washing and/or dust-free power washing, Eneco does not accept any liability with regard to the durability of the surface.
Sample 1
AutoNDA by SimpleDocs

Related to Lines and Markings

  • Markings If permitted by applicable Law, on or reasonably promptly after the Closing Date, Owner will cause to be affixed to, and maintained in, the cockpit of the Airframe and on each Engine, in each case, in a clearly visible location, a placard of a reasonable size and shape bearing the legend: “Subject to a security interest in favor of Wilmington Trust, National Association, not in its individual capacity but solely as Mortgagee.” Such placards may be removed temporarily, if necessary, in the course of maintenance of the Airframe or Engines. If any such placard is damaged or becomes illegible, Owner shall promptly replace it with a placard complying with the requirements of this Section.

  • Packing and Marking All material and equipment to be furnished by the Contractor shall be packed, crated or otherwise suitably protected to withstand shipment undamaged to the destination. Each package, crate or part shall be marked plainly with the name of the consignee, shipping destination, the Owner's order number, and such other markings as are required. Complete packing lists, one copy with each package and two (2) copies by mail to the Owner at time of shipment, shall be supplied showing contents and identity of each package.

  • Sealing and Marking of Bids The bidder shall seal the original and each copy of the bid in separate envelopes duly marking the envelopes “ORIGINAL” and “COPY”. The envelopes shall then be sealed in an outer separate envelope.

  • WORKMANSHIP AND MATERIALS 1.10.1 Contractor shall furnish all supervision, labor, transportation, materials, tools and equipment necessary to satisfactorily complete the service in a manner consistent with the Project Manager’s plan and schedule. Contractor’s equipment shall be of the size and type appropriate for completing the various types of work described in the contract or any associating Purchase Order. Contractor shall ensure that any equipment considered by the Project Manager to be improper or inadequate for this purpose is removed from the site and replaced with satisfactory equipment. 1.10.2 All work performed under this contract shall be completed in accordance with local, state, and national codes and standards, and other recognized industry standards associated with the work. 1.10.3 The Contractor guarantees that all materials shall be of the best quality, that all work shall be done in a professional manner, and that all aspects of the project will be delivered in good working order, complete and perfect in every respect, and that all systems and materials necessary to make the project completely operational as contemplated by the above description of the project, even if those systems and materials are not specifically described in this Contract, shall be included in the contract price. 1.10.4 Contractor shall ensure that all supplies, equipment and machines shall be kept free of traffic lanes or other areas that may be hazardous. Contractor shall further ensure that all dirt and debris resulting from the work under this contract shall be disposed of at the end of each day or at the completion of work in each building. 1.10.5 Contractor shall, at no additional cost to the State, repair furnishings, equipment, facilities or other property of the State damaged by Contractor, its officers, employees, agents, contractors, subcontractors and invitees. Contractor acknowledges that the determination of the need for, and extent of, any repair work shall be made at the sole discretion of the Project Manager.

  • Network Maintenance and Management 38.1 The Parties will work cooperatively to implement this Agreement. The Parties will exchange appropriate information (for example, maintenance contact numbers, network information, information required to comply with law enforcement and other security agencies of the government, escalation processes, etc.) to achieve this desired result. 38.2 Each Party will administer its network to ensure acceptable service levels to all users of its network services. Service levels are generally considered acceptable only when End Users are able to establish connections with little or no delay encountered in the network. Each Party will provide a twenty four (24)-hour contact number for Network Traffic Management issues to the other’s surveillance management center. 38.3 Each Party maintains the right to implement protective network traffic management controls, such as “cancel to”, “call gapping” or seven (7)-digit and ten (10)-digit code gaps, to selectively cancel the completion of traffic over its network, including traffic destined for the other Party’s network, when required to protect the public-switched network from congestion as a result of occurrences such as facility failures, switch congestion or failure or focused overload. Each Party shall immediately notify the other Party of any protective control action planned or executed. 38.4 Where the capability exists, originating or terminating traffic reroutes may be implemented by either Party to temporarily relieve network congestion due to facility failures or abnormal calling patterns. Reroutes shall not be used to circumvent normal trunk servicing. Expansive controls shall be used only when mutually agreed to by the Parties. 38.5 The Parties shall cooperate and share pre-planning information regarding cross-network call-ins expected to generate large or focused temporary increases in call volumes to prevent or mitigate the impact of these events on the public-switched network, including any disruption or loss of service to the other Party’s End Users. Facsimile (FAX) numbers must be exchanged by the Parties to facilitate event notifications for planned mass calling events. 38.6 Neither Party shall use any Interconnection Service provided under this Agreement or any other service related thereto or used in combination therewith in any manner that interferes with or impairs service over any facilities of AT&T-21STATE, its affiliated companies or other connecting telecommunications carriers, prevents any carrier from using its Telecommunications Service, impairs the quality or the privacy of Telecommunications Service to other carriers or to either Party’s End Users, causes hazards to either Party’s personnel or the public, damage to either Party’s or any connecting carrier’s facilities or equipment, including any malfunction of ordering or billing systems or equipment. Upon such occurrence either Party may discontinue or refuse service, but only for so long as the other Party is violating this provision. Upon any such violation, either Party shall provide the other Party notice of the violation at the earliest practicable time. 38.7 AT&T TENNESSEE hereby commits to provide Disaster Recovery to CLEC according to the plan below. 38.7.1 AT&T TENNESSEE Disaster Recovery Plan 38.7.2 In the unlikely event of a disaster occurring that affects AT&T TENNESSEE’s long-term ability to deliver traffic to a CLEC, general procedures have been developed by AT&T TENNESSEE to hasten the recovery process in accordance with the Telecommunications Service Priority (TSP) Program established by the FCC to identify and prioritize telecommunication services that support national security or emergency preparedness (NS/EP) missions. A description of the TSP Program as it may be amended from time to time is available on AT&T TENNESSEE’s Wholesale – Southeast Region Web site. Since each location is different and could be affected by an assortment of potential problems, a detailed recovery plan is impractical. However, in the process of reviewing recovery activities for specific locations, some basic procedures emerge that appear to be common in most cases. 38.7.3 These general procedures should apply to any disaster that affects the delivery of traffic for an extended time period. Each CLEC will be given the same consideration during an outage, and service will be restored as quickly as possible. AT&T TENNESSEE reserves the right to make changes to these procedures as improvements become available or as business conditions dictate. 38.7.4 This plan will cover the basic recovery procedures that would apply to every CLEC.

  • Manufacturing and Marketing Rights The Company has not granted rights to manufacture, produce, assemble, license, market, or sell its products to any other person and is not bound by any agreement that affects the Company's exclusive right to develop, manufacture, assemble, distribute, market, or sell its products.

  • Equipment and Materials CONTRACTOR shall provide all equipment, materials, and supplies necessary for the performance on the Agreement except:

  • Time and Materials If this contract is designated as a Time and Materials contract, invoicing and payment shall be as follows: (a) Consultant shall submit invoices, not more often than once a month during the term of this agreement, based on the cost for work performed in accordance with the Rate Schedule in the Scope of Work and authorized reimbursable expenses incurred prior to the invoice date. Invoices shall contain the following information: (i) Serial identifications of bills, i.e., Xxxx No. 1; (ii) The beginning and ending dates of the billing period; (iii) A summary containing the total contract amount, the amount of prior xxxxxxxx, the total due this period, percentage of work completed, the remaining balance available for all remaining billing periods, and a brief description of work completed during the billing period. (b) City shall make monthly payments, based on such invoices, for satisfactory progress in completion of the Scope of Work, and for authorized reimbursable expenses incurred.

  • Use of School Buildings The ASSOCIATION and its representatives shall have the right to use school buildings at all reasonable hours for meetings. This use must be within the hours when custodians are regularly employed and within accepted school policy.

  • Moonlighting Employment as a physician in a professional capacity outside of what is outlined in this Agreement, whether temporary special medical activity (“TSMA”) or external moonlighting, must be approved in writing, in advance, by the Departmental Chair, Program Director and Director of Graduate Medical Education (or designee). Even if approved, professional and general liability insurance as outlined in Section 5.4 is not provided to Trainee engaged in external moonlighting. Trainee acknowledges he or she has the responsibility to obtain insurance for such engagement. TSMA and external moonlighting must be included and reported as part of Trainee's hours spent on clinical experience and education. Trainee shall not be required to engage in any outside work.

Draft better contracts in just 5 minutes Get the weekly Law Insider newsletter packed with expert videos, webinars, ebooks, and more!