OMISSION OF DETAILS. All work called for in the Specifications but not shown on the Contract Drawings in their present form, or vice versa, and work not specified in either the Contract Drawings or in the Specifications but involved in carrying out their intent or in the complete and proper execution of the work, is required, and shall be performed by the Contractor as though it were specifically delineated or described.
OMISSION OF DETAILS. Any details of design, materials or construction not specifically stated in this specification are left to the discretion of the manufacturer provided they meet the requirements of all applicable NFPA Standards pertaining to the items for which the proposer submits a bid. Nothing in this specification shall be construed to exclude the use of materials, which exceed these specifications.
OMISSION OF DETAILS. Contractor shall not take advantage of any apparent error in the Contract Documents. If it appears that the Work to be done or any matter related to the Work is not sufficiently detailed or explained in the Contract Documents, Contractor shall request in writing from VPRA further written explanations as may be necessary and will conform to the explanation provided. Contractor shall promptly notify VPRA of any error that it discovers in the Contract Documents and must obtain specific instructions in writing from VPRA regarding any such error before proceeding with the affected Work. The fact that the Contract Documents omit or misdescribe any minor details of any Work that are necessary to carry out the intent of the Contract Documents, or that are customarily performed under similar circumstances, will not relieve Contractor from performing the omitted Work or the misdescribed details of the Work, and they must be performed as if fully and correctly stated and described in the Contract Documents, without entitlement to adjustment of the Contract Price or a Completion Deadline except as specifically allowed under Article14 of these General Terms and Conditions.
OMISSION OF DETAILS. No advantage shall be taken by the manufacturer or dealer in the omission of any part or detail to make the equipment complete and ready for service, even though such part of the detail is not mentioned explicitly. All units or parts not specified shall be the manufacturer’s standard unit and shall conform to the highest standards in the industry. The Contractor shall provide competent representatives to provide a minimum of (4) Four hours of operator training for each complete vehicle purchased. The training shall include all aspects of operating and servicing the entire equipment. Videotape training series may be used to supplement training with the Client Agency approval. The Contractor shall provide factory representatives to provide the following:
