Operating Room Call Back. A Registered Nurse who is in on-call status for the Operating Room and is called back to duty shall be paid for the actual time so spent plus one (1) hour, but not less than three (3) hours total for each call back.
Operating Room Call Back Sample Clauses
Related to Operating Room Call Back
Emergency Call Back Employees who are called back to work after completing their regular shift and who are relieved of duty before commencing their next regular shift shall be paid a minimum of four (4) hours’ straight-time pay for all time worked up to two (2) hours. Any time worked in excess of two (2) hours shall be paid for at double the straight-time rate of pay for actual hours worked. Example: Zero (0) minutes to two (2) hours = 4 hours’ straight-time pay. Two and one-half (2 1/2) hours = 5 hours’ straight-time pay. Four (4) hours = 8 hours’ straight-time pay.
Call Back Where employees are called back to work after having completed a regular shift, and prior to the commencement of their next regular shift, they shall receive a minimum of four (4) hours of work or four (4) hours pay at the rate of time and one-half (1-1/2) their regular hourly earnings. Superior provisions shall remain.
Minimum Call-Back Time An employee who is called in and required to work outside their regular working hours shall be paid for a minimum of two (2) hours at overtime rates unless the call-in is immediately prior to their normal work day, in which case there should be no minimum.
Call Backs 9.1 Call-back occurs when the employee:
Check Meters Developer, at its option and expense, may install and operate, on its premises and on its side of the Point of Interconnection, one or more check meters to check Connecting Transmission Owner’s meters. Such check meters shall be for check purposes only and shall not be used for the measurement of power flows for purposes of this Agreement, except as provided in Article 7.4 below. The check meters shall be subject at all reasonable times to inspection and examination by Connecting Transmission Owner or its designee. The installation, operation and maintenance thereof shall be performed entirely by Developer in accordance with Good Utility Practice.
Earned Value Management System An earned value management system (EVMS) means a project management tool that effectively integrates the project scope of work with cost, schedule and performance elements for optimum project planning and control. The qualities and operating characteristics of EVMS are described in American National Standards Institute /Electronics Industries Alliance (ANSI/EIA) Standard-748. An EVMS is not mandatory; however, Contractors are encouraged to have an EVMS ANSI/EIA Standard-748 during the entire term of OASIS. The Contractor shall notify the OASIS CO, in writing, if there are any changes in the status of their EVMS and provide the reasons for the change and copies of audits by the Defense Contract Management Agency (DCMA) or other cognizant Government administration office, as applicable. If only part of a Contractor’s organization is EVMS ANSI/EIA Standard-748 certified, the Contractor shall make the distinction between which business units or sites and geographic locations have been certified.
