Owners' Development Rights Sample Clauses

Owners' Development Rights. (A) Each Owner covenants to the other Owners, their successors and assigns for the benefit of and as an appurtenance to their respective Lots that from and after the date hereof, no building, structure, equipment or other improvement on its Lot, or combination of improvements, including any addition to or extension of its Buildings, shall be erected or installed or allowed or suffered to exist on its Lot, and no repair, alteration, reconstruction or rebuilding of its Buildings (following a casualty or otherwise) shall be made or allowed or suffered to be made: (i) having a total Floor Area, as defined in the Zoning Resolution, in excess of the greater of (x) the amount of Floor Area that would be available to its Lot under the Zoning Resolution if its Lot were considered to be a separate zoning lot and (y) the amount of Floor Area existing on the Owner's Lot on the date of this Agreement (the "Owner Lot Xxxxxxx Xxxxx Xxxx"), xx (xx) xxxulting in the creation on its Lot of (x) a new use that does not conform to the use regulations in the Zoning Resolution, (y) a failure of any building or structure on its Lot to comply with any provision of the Zoning Resolution, including without limitation coverage, yard and bulk requirements, or (z) an increase in the degree to which any such structure or building fails to comply with the Zoning Resolution, in each case treating its Lot as if it were a separate zoning lot. (B) Subject to applicable laws, rules and regulations, each Owner shall have the absolute right to construct replacement buildings on its Lot not violative of the restrictions set forth in subsection (A) of this Section 1.1; provided however, that if as a result of any amendment or change in the Zoning Resolution, the Zoning Lot shall become entitled to fewer development rights in the future, then each Owner shall have the right to construct replacement buildings or other improvements on its Lot with a Floor Area equal to the lesser of (i) the amount of Floor Area that would be available to its Lot under the Zoning Resolution, as amended, if its Lot were considered to be a separate zoning lot, (ii) the amount of permissible Floor Area remaining on its Lot, taking into account the existing Floor Area on the other Lots, and (iii) its proportionate share of the permissible Floor Area available on all the Lots combined based on the proportion that its Lot area bears to the aggregate area of all the Lots; and, provided further, that if as a result of any am...
Sample 1
AutoNDA by SimpleDocs

Related to Owners' Development Rights

  • Development Rights The Employee agrees and declares that all proprietary information including but not limited to trade secrets, know-how, patents and other rights in connection therewith developed by or with the contribution of Employee's efforts during his employment with the Company shall be the sole property of the Company. Upon the Company's request (whenever made), Employee shall execute and assign to the Company all the rights in the proprietary information.

  • Design Development Documents See Section 2, Part 1, Article 2.1.5.

  • Condominiums/Planned Unit Developments If the Mortgaged Property is a condominium unit or a planned unit development (other than a de minimis planned unit development) such condominium or planned unit development project such Mortgage Loan was originated in accordance with, and the Mortgaged Property meets the guidelines set forth in the Originator's Underwriting Guidelines;

  • Design Development An interim step in the design process. Design Development documents consist of plans, elevations, and other drawings and outline specifications. These documents will fix and illustrate the size and character of the entire project in its essentials as to kinds of materials, type of structure, grade elevations, sidewalks, utilities, roads, parking areas, mechanical and electrical systems, and such other work as may be required.

  • Design Development Phase INDICATE IN STATEMENT OF WORK “NOT APPLICABLE” IF SECTION IS NOT APPLICABLE 1.1.6.1. The ARCHITECT/ENGINEER shall prepare from the approved Schematic Design Studies, the Design Development Documents consisting of drawings (including at least architectural, landscaping, civil, structural, mechanical and electrical plans, building sections; and finish schedule), outline specifications following the Construction Specification Institute "CSI" Format and other necessary documents to fix and describe the size and character of the entire Project as to its site, structural, mechanical, and electrical systems, materials and other such essentials as may be appropriate, for and until approved by the State. 1.1.6.2. The ARCHITECT/ENGINEER shall conduct meetings with the State, Efficiency Vermont, and relevant members of the design team, to review the Design Development Documents for the purposes of furthering the energy efficiency objectives of the Project. 1.1.6.3. The ARCHITECT/ENGINEER shall prepare for the State a revised accounting of how the Project is responding to LEED criteria. 1.1.6.4. The ARCHITECT/ENGINEER shall submit to the State a revised Statement of Probable Construction Cost based thereon for and until approved by the State.

  • Project Development a. Collaborate with COUNTY and project clients to identify requirements and develop a project Scope Statement. a. Develop a Work Breakdown Structure (WBS) for each project. b. Evaluate Scope Statement to develop a preliminary cost estimate and determinate whether project be vendor bid or be executed under a Job Order Contract (JOC).

  • Completion of Development 7.4.1 Upon the completion of the whole development or complete phases of the development, Council may review this Agreement, in whole or in part, and may: (a) retain the Agreement in its present form; (b) negotiate a new Agreement; (c) discharge this Agreement; or (d) for those portions of the development which are completed, discharge this Agreement and apply appropriate zoning pursuant to the Municipal Planning Strategy and Land Use By-law for Halifax Peninsula as may be amended from time to time.

  • Development Work The Support Standards do not include development work either (i) on software not licensed from CentralSquare or (ii) development work for enhancements or features that are outside the documented functionality of the Solutions, except such work as may be specifically purchased and outlined in Exhibit 1. CentralSquare retains all Intellectual Property Rights in development work performed and Customer may request consulting and development work from CentralSquare as a separate billable service.

  • Development Agreement As soon as reasonably practicable following the ISO’s selection of a transmission Generator Deactivation Solution, the ISO shall tender to the Developer that proposed the selected transmission Generator Deactivation Solution a draft Development Agreement, with draft appendices completed by the ISO to the extent practicable, for review and completion by the Developer. The draft Development Agreement shall be in the form of the ISO’s Commission-approved Development Agreement for its reliability planning process, which is in Appendix C in Section 31.7 of Attachment Y of the ISO OATT, as amended by the ISO to reflect the Generator Deactivation Process. The ISO and the Developer shall finalize the Development Agreement and appendices as soon as reasonably practicable after the ISO’s tendering of the draft Development Agreement. For purposes of finalizing the Development Agreement, the ISO and Developer shall develop the description and dates for the milestones necessary to develop and construct the selected project by the required in-service date identified in the Generator Deactivation Assessment, including the milestones for obtaining all necessary authorizations. Any milestone that requires action by a Connecting Transmission Owner or Affected System Operator identified pursuant to Attachment P of the ISO OATT to complete must be included as an Advisory Milestone, as that term is defined in the Development Agreement. If the ISO or the Developer determines that negotiations are at an impasse, the ISO may file the Development Agreement in unexecuted form with the Commission on its own, or following the Developer’s request in writing that the agreement be filed unexecuted. If the Development Agreement is executed by both parties, the ISO shall file the agreement with the Commission for its acceptance within ten (10) Business Days after the execution of the Development Agreement by both parties. If the Developer requests that the Development Agreement be filed unexecuted, the ISO shall file the agreement at the Commission within ten (10) Business Days of receipt of the request from the Developer. The ISO will draft, to the extent practicable, the portions of the Development Agreement and appendices that are in dispute and will provide an explanation to the Commission of any matters as to which the parties disagree. The Developer will provide in a separate filing any comments that it has on the unexecuted agreement, including any alternative positions it may have with respect to the disputed provisions. Upon the ISO’s and the Developer’s execution of the Development Agreement or the ISO’s filing of an unexecuted Development Agreement with the Commission, the ISO and the Developer shall perform their respective obligations in accordance with the terms of the Development Agreement that are not in dispute, subject to modification by the Commission. The Connecting Transmission Owner(s) and Affected System Operator(s) that are identified in Attachment P of the ISO OATT in connection with the selected transmission Generator Deactivation Solution shall act in good faith in timely performing their obligations that are required for the Developer to satisfy its obligations under the Development Agreement.

  • Information Systems Acquisition Development and Maintenance a. Client Data – Client Data will only be used by State Street for the purposes specified in this Agreement.

Draft better contracts in just 5 minutes Get the weekly Law Insider newsletter packed with expert videos, webinars, ebooks, and more!