Road Crossings. Where the Design requires one or more road crossings, which will be formed before service trenches are opened, Enable will provide the road crossing duct to be installed by the Developer at road crossing points to facilitate cables being pulled through at later dates. These road crossings will be indicated in the Build Pack. These ducts are only to be used by Enable. Ducting cannot be utilised by any other utility provider to provide cross road connections.
Road Crossings. Grantor shall have the right to cross the Easement herein granted with a private paved or concrete driveway, roadway or sidewalk; provided, however, that any such new crossings will (i) be at an angle of between 75 to 90 degrees, and (ii) not result in the cover over the pipeline being reduced to less than three (3) feet. Grantor shall provide Grantee with at least fourteen (14) days written notice prior to the construction of such road. Notwithstanding the foregoing, and provided that sufficient depth of the pipe is maintained, Grantor may use the road currently located on the property. In performing such construction or installing such road crossings, Grantor shall defend, indemnify, and hold harmless the Grantee from all cost, loss, damage, expense, or claims of any nature arising from or in any way related to Grantor’s activities. Grantee acknowledges and consents to the right of the Grantor to perform such improvements provided it does not interfere with the rights granted to Grantee herein. In the event the Grantee elects to repair, upgrade, expand or extend the Pipeline Facilities, or any other area contained in and described by this Easement, and such action requires the removal of or damage to any such improvements as described in this Section, the parties agree that any cost or labor required to restore any damage to the Grantor’s improvements shall be the sole responsibility of the party performing the removal or causing the damage to any such improvements as described in this Section. Grantee shall not be responsible for damage to road crossings constructed after installation of the Pipeline Facilities.
Road Crossings. A. All road crossings shall be bored. No cut and patch shall be allowed.
Road Crossings. The standard for a road crossing surface installed and maintained by the BNSF is concrete plank (for 136-lb. rail) placed on 10-ft. switch ties. Also, ten 10-ft. switch ties are placed on both ends of the crossing, replacing any standard cross-ties. For crossings installed and maintained by the Customer, a concrete plank is recommended, with a wood plank surface as acceptable (see appendix, pages A-21 to 23).
Road Crossings. Delete the last sentence of this subclause and substitute: The ducts shall be laid to the lengths shown on the drawings or as directed by the Engineer.
Road Crossings. (i) "Tarmac or Asphalt Road" means the road surface, which is metalled by sphalt/tarmac normally having compacted strata below the metalled surface, irrespective of thickness of asphalt/tarmac.
Road Crossings
