Root Cause Failure Analysis Sample Clauses

Root Cause Failure Analysis. Supplier shall have the capability to perform root cause analysis and report findings in a timely manner, as stated in the request. Capability shall also exist which enables the effective capture and routing of Product requiring root cause analysis from identified defects or customer requests. Notification of the need for a root cause analysis may come from many sources, e.g. email, voice mail, fax and may come before or after authorization to return Product for repair.
Sample 1Sample 2
AutoNDA by SimpleDocs
Root Cause Failure Analysis. Supplier shall have the capability to perform root cause and failure analysis and report findings in a timely manner, as shown below or as stated in Dot Hill's request, and to effectively capture and route Product requiring root cause analysis from identified defects or customer requests. Supplier shall maintain and track accurate and detailed records of all such failure analysis performed. Measurement for Failure Analysis ("FA") response is based on the date of receipt of the defective unit requiring FA by the supplier. 5.5.1 FA on identified defects is required with corrective action within [...***...] after discovery of the defect. [...***...] = CERTAIN CONFIDENTIAL INFORMATION CONTAINED IN THIS DOCUMENT, MARKED BY BRACKETS, HAS BEEN OMITTED AND FILED SEPARATELY WITH THE SECURITIES AND EXCHANGE COMMISSION PURSUANT TO RULE 24b-2 OF THE SECURITIES EXCHANGE ACT OF 1934, AS AMENDED. 5.5.2 Notification of the requirement for a root cause analysis may be provided to Supplier by phone, email, voicemail or fax prior to or after the return of the defective Product for repair. 5.5.3 Reasonable requests for FA generated by Dot Hill's Corrective & Preventive Action System ("CPAS") require complete FA and written response via email or a mailed report within [...***...] after Supplier's receipt of the defective unit. [...***...] = CERTAIN CONFIDENTIAL INFORMATION CONTAINED IN THIS DOCUMENT, MARKED BY BRACKETS, HAS BEEN OMITTED AND FILED SEPARATELY WITH THE SECURITIES AND EXCHANGE COMMISSION PURSUANT TO RULE 24b-2 OF THE SECURITIES EXCHANGE ACT OF 1934, AS AMENDED. Failure Analysis requirements: a. Duplication of the failure on all Products. b. Sub-assembly that has failed (except for board Products). c. Component on the sub-assembly that has failed. d. Reason for the component failure, if required by Dot Hill, within thirty (30) days after determination of component failure.
Sample 1
Root Cause Failure Analysis. Infortrend shall have the capability to perform root cause and failure analysis and report findings in a timely manner, as set forth below in this Section 5.5, and to effectively capture and route Product requiring root cause analysis from identified defects or customer requests. Measurement for Failure Analysis ("FA") response is based on the date of receipt of the defective unit requiring FA by the Infortrend. 5.5.1 FA on identified defects is required, as set forth in Section 8.7 of the Agreement. 5.5.2 Notification of the requirement for a root cause analysis may be provided to Infortrend by phone, email, voicemail or fax prior to or after the return of the defective Product for repair. 5.5.3 Failure Analysis under this Section 5.5 requires the following: a. Duplication of the failure on all failed Products. b. Analysis of sub-assembly that has failed (except for board Products). c. Analysis of component on the sub-assembly that has failed. d. Reason for the component failure, upon the written request of Dot Hill, within [...***...] days after determination of component failure.
Sample 1
Root Cause Failure Analysis. Supplier shall have the capability to perform root cause and failure analysis and report findings in a timely manner, as shown below or as stated in Dot Hill’s request, and to effectively capture and route Product requiring root cause analysis from identified defects or customer requests. Supplier shall maintain and track accurate and detailed records of all such failure analysis performed. Measurement for Failure Analysis (“FA”) response is based on the date of receipt of the defective unit requiring FA by the supplier. 5.5.1 Notification of the requirement for a root cause analysis may be provided to Supplier by phone, email, voicemail or fax prior to or after the return of the defective Product for repair. 5.5.2 Reasonable requests for FA generated by Dot Hill’s Corrective & Preventive Action System (“CPAS”) require complete FA and written response via email or a mailed report within five (5) working days after Supplier’s receipt of the defective unit. Failure Analysis requirements: a. [...***...].
Sample 1
Root Cause Failure Analysis. The Parties acknowledge that the RCFA developed by a qualified independent third-party is currently underway. The scope of the RCFA includes an assessment of all five LNG storage tanks at the Facility for similar events pertinent to the causal factors of the incident on January 22, 2018. The RCFA shall be completed by May 31, 2018, and shall document all contributory factors (including any pertinent operating information from other tanks at the Sabine Pass Facility) and the report’s decision-making process. Xxxxxx must submit a final report of the RCFA to the Director and shall include any recommendations and the applicability of the recommendations to the five LNG storage tanks within the Facility.
Sample 1
Root Cause Failure Analysis. In accordance with the Notice, Respondent performed a Root Cause Failure Analysis (RCFA), and a report of the RCFA was provided to the Director on March 13, 2019. The RCFA documented a timeline of events relating to the accident and included a pipeline history, a seam integrity assessment history, a failure history, results from the Metallurgical Report conclusions, contributing factors, and action items.
Sample 1

Related to Root Cause Failure Analysis

  • Root Cause Analysis Upon Vendor's failure to provide the Services in accordance with the applicable Service Levels (for any reason other than a Force Majeure Event) Vendor will promptly (a) perform a root-cause analysis to identify the cause of such failure, (b) provide Prudential with a report detailing the cause of, and procedure for correcting, such failure, (c) obtain Prudential's written approval of the proposed procedure for correcting such failure, (d) correct such failure in accordance with the approved procedure, (e) provide weekly (or more frequent, if appropriate) reports on the status of the correction efforts, and (f) provide Prudential with assurances satisfactory to Prudential that such failure has been corrected and will not recur.

  • Termination Due to Force Majeure Event If the period of Force Majeure continues or is in the reasonable judgment of the Parties likely to continue beyond a period of 120 (one hundred and twenty) Days, the Parties may mutually decide to terminate this Agreement or continue this Agreement on mutually agreed revised terms. If the Parties are unable to reach an agreement in this regard, the Affected Party shall after the expiry of the said period of 120 (one hundred and twenty ) Days be entitled to terminate the Agreement in which event, the provisions of Articles 16 and 17 shall, to the extent expressly made applicable, apply.

  • Termination due to Force Majeure 13.5.1 If the Force Majeure Event or its effects continue to be present beyond the period as specified in Article 4.5.3, either Party shall have the right to cause termination of the Agreement. In such an event, this Agreement shall terminate on the date of such Termination Notice.

  • Termination for Force Majeure 15.5.1. The License Agreement may be terminated for Force Majeure Reasons as specified in Article -14.

  • Termination for Market Change (a) In the event of delay or interruption under B8.33, exceeding 90 days, and Contract has not been modified to include replacement timber, this contract may be terminated upon election and written notice by Purchaser, if (i) a rate redetermination for market change under B3.33 shows that the appraised weighted average Indicated Advertised Rate of all Included Timber remaining immediately prior to the delay or interruption has been reduced through a market change by an amount equal to or more than the the weighted average Current Contract Rate, or (ii) the appraised value of the remaining timber is insufficient to cover the adjusted base rates as determined under B3.33.

  • T ermination In the event that either party seeks to terminate this DPA, they may do so by mutual written consent and as long as any service agreement or terms of service, to the extent one exists, has lapsed or has been terminated. The LEA may terminate this DPA and any service agreement or contract with the Provider if the Provider breaches any terms of this DPA.

  • Termination; Reinstatement This Guaranty is a continuing and irrevocable guaranty of all Obligations now or hereafter existing and shall remain in full force and effect until all Obligations and any other amounts payable under this Guaranty are indefeasibly paid in full in cash and the Commitments and the Facilities with respect to the Obligations are terminated. Notwithstanding the foregoing, this Guaranty shall continue in full force and effect or be revived, as the case may be, if any payment by or on behalf of the Borrower or any Guarantor is made, or any of the Secured Parties exercises its right of setoff, in respect of the Obligations and such payment or the proceeds of such setoff or any part thereof is subsequently invalidated, declared to be fraudulent or preferential, set aside or required (including pursuant to any settlement entered into by any of the Secured Parties in their discretion) to be repaid to a trustee, receiver or any other party, in connection with any proceeding under any Debtor Relief Laws or otherwise, all as if such payment had not been made or such setoff had not occurred and whether or not the Secured Parties are in possession of or have released this Guaranty and regardless of any prior revocation, rescission, termination or reduction. The obligations of each Guarantor under the preceding sentence shall survive termination of this Guaranty.

  • Excuse for Nonperformance or Delayed Performance Except with respect to defaults of subcontractors, Contractor/Vendor shall not be in default by reason of any failure in performance of this contract in accordance with its terms (including any failure by Contractor/Vendor to make progress in the prosecution of the work hereunder which endangers such performance) if Contractor/Vendor has notified the Commission or designee within 15 days after the cause of the delay and the failure arises out of causes such as: acts of God; acts of the public enemy; acts of the State and any other governmental entity in its sovereign or contractual capacity; fires; floods; epidemics; quarantine restrictions; strikes or other labor disputes; freight embargoes; or unusually severe weather. If the failure to perform is caused by the failure of a subcontractor to perform or to make progress, and if such failure arises out of causes similar to those set forth above, Contractor/Vendor shall not be deemed to be in default, unless the services to be furnished by the subcontractor were reasonably obtainable from other sources in sufficient time to permit Contractor to meet the contract requirements. Upon request of Contractor, the Commission or designee shall ascertain the facts and extent of such failure, and, if such officer determines that any failure to perform was occasioned by any one or more of the excusable causes, and that, but for the excusable cause, Contractor’s progress and performance would have met the terms of the contract, the delivery schedule shall be revised accordingly, subject to the rights of the State under the clause entitled (in fixed-price contracts, “Termination for Convenience,” in cost-reimbursement contracts, “Termination”). (As used in this Paragraph of this clause, the term “subcontractor” means subcontractor at any tier).

  • Epidemic Failure “Epidemic Failure” for any particular Product shall mean a failure resulting from defects in material, workmanship, and manufacturing process, including but not limited to the use of Components with known defects. The Epidemic Failure clause shall be invoked [***]. The failure rate may be calculated [***], as determined by BUYER. Epidemic failures do not supersede the requirements of any expressed or implied warranty defined herein. In the case of an epidemic failure, SUPPLIER’s obligation is to propose an action plan to fix the failure of any affected Product within seventy-two (72) hours of discovery. SUPPLIER shall implement this action plan upon BUYER’s acceptance thereof. If the action plan is not acceptable to BUYER, BUYER can require SUPPLIER to repair or replace, at BUYER’s option, the affected Product. In addition to bearing the costs associated therewith, if requested by BUYER, SUPPLIER shall support and provide at SUPPLIER’s expense a sufficient number of units of the Product to permit the field exchange or “hot swap” of Products at customer sites. The parties agree to make all reasonable efforts to complete the repair or replacement of all affected Products within eight (8) Business Days after written notice of epidemic failure by BUYER to SUPPLIER. SUPPLIER also agrees that BUYER will be supported with accelerated shipments of replacement Product to cover BUYER’s supply requirements. If an Epidemic Failure is caused by (i) a design, including a BUYER-provided test process, as required by the Specifications or (ii) a failure by a Component required by the Specifications, (iii) misuse or damage during transit or damage by a third party at no fault of SUPPLIER, SUPPLIER shall perform the obligations in this Section 10.5 and BUYER shall pay to SUPPLIER the fees mutually agreed upon by the parties in writing. If an Epidemic Failure is caused by any other reason other than as set forth in the immediately preceding sentence, SUPPLIER shall perform the obligations set forth in this Section free of charge. Confidential treatment is being requested for portions of this document. This copy of the document filed as an exhibit omits the confidential information subject to the confidentiality request. Omissions are designated by the symbol [***]. A complete version of this document has been filed separately with the Securities and Exchange Commission.

  • Termination for Good Reason The Employee's employment may be terminated by the Employee for Good Reason. For purposes of this Agreement, "Good Reason" shall mean:

Draft better contracts in just 5 minutes Get the weekly Law Insider newsletter packed with expert videos, webinars, ebooks, and more!