Scheduling and Leave Time
Scheduling and Leave Time Sample Clauses
Related to Scheduling and Leave Time
Maternity Adoption and Parental Leave For the purposes of granting Maternity, Adoption and Parental Leave, the provisions of the Canada Labour Code and of its Regulations shall apply.
Felling and Bucking Felling shall be done to minimize breakage of Included Timber and dam- age to residual timber. Unless agreed otherwise, felling shall be done by saws or shears. Bucking shall be done to permit removal of all minimum pieces set forth in A2. B6.411 Felling in Clearings. Insofar as ground conditions, tree lean, and shape of clearings per- mit, trees shall be felled so that their tops do not extend outside Clearcutting Units, construction clearings, and ar- eas of regeneration cutting. B6.000 Xxxxx Xxxxxxx. Stumps shall not exceed, on the side adjacent to the highest ground, the maximum heights set forth in A6, except that occasional stumps of greater heights are acceptable when Purchaser determines that they are necessary for safe and efficient conduct of logging. Unless otherwise agreed, Purchaser shall re-cut high stumps so they will not exceed heights specified in A6 and shall dispose of severed portions in the same manner as other logging debris. The xxxxx heights shown in A6 were selected with the objective of maximum reasonable utilization of the timber, unless Sale Area Map shows special areas where xxxxx heights are lower for aesthetic, land treatment, or silvicultural rea- sons.
Maternity and Parental Leave Employees are eligible for unpaid leave of absence from employment subject to the conditions in this article. Every employee who intends to take a leave of absence under this article will give at least four weeks' notice in writing to the Employer unless there is a valid reason why such notice cannot be given and will inform the Employer in writing of the length of leave intended to be taken. Each employee who wishes to change the effective date of approved leave will give four weeks' notice of such change unless there is a valid reason why such notice cannot be given.
Skidding and Yarding Methods of skid- ding or yarding specified for particular areas, if any, are indicated on Sale Area Map. Outside Clearcutting Units and construction clearings, insofar as ground conditions permit, products shall not be skidded against reserve trees or groups of reproduction and tractors shall be equipped with a winch to facilitate skidding. B6.421 Rigging. Insofar as practicable, needed rigging shall be slung on stumps or trees desig- nated for cutting.
Working and Labor Synergies The Contractor shall be responsible for maintaining a tranquil working relationship between the Contractor work force, the Contractor Parties and their work force, State employees, and any other contractors present at the work site. The Contractor shall quickly resolve all labor disputes which result from the Contractor's or Contractor Parties’ presence at the work site, or other action under their control. Labor disputes shall not be deemed to be sufficient cause to allow the Contractor to make any claim for additional compensation for cost, expenses or any other loss or damage, nor shall those disputes be deemed to be sufficient reason to relieve the Contractor from any of its obligations under the Contract.
TRAINING AND RELATED MATTERS The parties recognise that in order to increase the efficiency and productivity of the company a significant commitment to structured training and skill development is required. Accordingly the parties commit themselves to: a) The parties to this Agreement recognise the importance of the apprenticeship system to the construction industry. It is agreed that every employer party to this Agreement who employs five (5) or more tradespersons in any one classification shall undertake to employ at least one (1) apprentice or make arrangements to host an apprentice from an agreed group apprenticeship scheme. Where an employer does not currently have an apprentice as per this provision, reasonable time shall be allowed to enable the employer to comply with this clause. Further, the parties are committed to a strong ratio of apprentices in the industry. Apprenticeship levels on a specific project may be discussed at the Project Pre-Commencement Conference (refer Clause 16). b) Providing employees with the opportunity to acquire additional skills within relevant career path structures through appropriate structured training based on nationally endorsed (i.e. Construction Training Australia endorsed) competency standards and curriculum; c) Actively encouraging employees to seek formal recognition of their skills (i.e. recognition of prior learning); and d) Using training providers accredited and acceptable to the parties. The CFMEU, MBAV and other employer associations are legitimately engaged in providing training to industry and it is hereby agreed that all parties will properly recognise and accept the validity of nationally accredited training as provided by the other parties. e) The parties will consult on the development of training programs which are consistent with the following: • Training provided will be consistent with the company’s business requirements, relevant to the work of the employees, consistent with the skills development of each employee and with applicable national competency standards. • Training may be taken either on or off the job with all reasonable steps being taken to conduct training in normal working hours. • If an approved training activity is undertaken during ordinary working hours, the employee/s concerned shall not suffer any loss of pay. • Approved training activities undertaken outside of ordinary hours will be paid at single time or will, at the employee’s option, be taken as time off in lieu of payment. Provided that the scheduling of time off must be consistent with the needs of the business and be by agreement with the company. • Training costs of courses approved by the company will be met by the company. • The company will not be asked to meet the costs of training undertaken by employees which was not approved by the company. • Leave of absence granted pursuant to this clause shall count as service for all purposes of the award and this agreement. • Accredited members of the union will be allowed up to 5 days per year, without loss of pay, to attend trade union educational courses conducted or approved by the union. (see appendix H) f) The parties to this Agreement recognise the importance of the role that Apprentices/Trainees fulfill within the industry and, more importantly, a role that they will fulfill as trades persons following the conclusion of the indentures. To this end the Victorian Building Industry Consultative Committee will investigate ways of enhancing employment prospects for Apprentice/Trainees. In addition it is agreed that, where appropriate, employers will use their best endeavours to employ Apprentices/Trainees in order to ensure appropriate trade persons levels for the future.
Training and Orientation (a) No employee shall be required to work on any job or operate any piece of equipment until he/she has received proper training and instruction. (b) The Employer shall provide sufficient and adequate training and/or orientation to any employee working in a new or unfamiliar work area or position.
Portability of Sick Leave 1. The employer will accept up to sixty (60) accumulated sick leave days from other school districts in British Columbia, for employees hired to or on exchange in the district. 2. An employee hired to or on exchange in the district shall accumulate and utilize sick leave credit according to the provisions of the Collective Agreement as it applies in that district.
Pregnancy and Parental Leave (a) Pregnancy/Parenting leave will be granted in accordance with the provisions of the Employment Standards Act, except where amended in this provision. (b) If possible the employee shall give written notification at least one (1) month in advance of the date of commencement of such leave and the expected date of return. (c) The employee shall reconfirm her intention to return to work on the date originally approved in subsection (b) above by written notification received by the Employer at least four (4) weeks in advance thereof. The employee shall be reinstated to her former position, unless the position has been discontinued in which case she shall be given a comparable job. (d) An employee who is on pregnancy leave as provided under this Agreement, who has completed five (5) months of continuous service and has applied for and is in receipt of Employment Insurance pregnancy/ parental benefits pursuant to the Employment Insurance Act shall be paid a supplemental employment benefit. That benefit will be equivalent to the difference between seventy-five percent (75%) of her regular weekly earnings (which for part-time employees shall include percentage-in-lieu) and the sum of her weekly Employment Insurance benefits and any other earnings. Such payment shall commence following receipt by the Employer of the employee's Employment Insurance cheque stub as proof that she is in receipt of Employment Insurance pregnancy/ parenting benefits, and shall continue while the employee is in receipt of such benefits for a maximum period of seventeen (17) weeks. The employee will endeavour to provide a copy of the Employment Insurance cheque stub within two (2) weeks of receipt of the employee’s EI benefit. The employee's regular weekly earnings shall be determined by multiplying her regular hourly rate on her last day worked prior to the commencement of the leave times her normal weekly hours. The normal weekly hours for an employee working less than seventy-five
Packing and Marking All material and equipment to be furnished by the Contractor shall be packed, crated or otherwise suitably protected to withstand shipment undamaged to the destination. Each package, crate or part shall be marked plainly with the name of the consignee, shipping destination, the Owner's order number, and such other markings as are required. Complete packing lists, one copy with each package and two (2) copies by mail to the Owner at time of shipment, shall be supplied showing contents and identity of each package.
