Section 10.5 Notices, Etc., to Trustee and Company....................... 11
Tax Law Section 5-A Section 5-a of the Tax Law, requires certain Contractors awarded State Contracts for commodities, services and technology valued at more than $100,000 to certify to the NYS Department of Taxation and Finance (DTF) that they are registered to collect New York State and local sales and compensating use taxes. The law applies to Contracts where the total amount of such Contractors’ sales delivered into New York State are in excess of $300,000 for the four quarterly periods immediately preceding the quarterly period in which the certification is made, and with respect to any affiliates and subcontractors whose sales delivered into New York State exceeded $300,000 for the four quarterly periods immediately preceding the quarterly period in which the certification is made. A Vendor is required to file the completed and notarized Form ST-220-CA with OGS certifying that the Vendor filed the ST-220-TD with the NYS Department of Taxation and Finance (DTF). Please note that the NYS Department of Taxation and Finance should receive the completed Form ST-220-TD, not OGS. OGS should only receive the Form ST-220-CA. Proposed Contractors should complete and return the certification forms within five (5) business days of request (if the forms are not completed and returned with Vendor Submission). Failure to make either of these filings may render a Vendor non- responsive and non-responsible. Each Vendor shall take the necessary steps to provide properly certified forms within a timely manner to ensure compliance with the law. Website links to the Contractor certification forms and instructions are provided below. Form No. ST- 220-TD must be filed with and returned directly to DTF and can be found at xxxx://xxx.xxx.xx.xxx/pdf/current_forms/st/st220td_fill_in.pdf. Unless the information upon which the ST-220-TD is based changes, this form only needs to be filed once with DTF. If the information changes for the Contractor, its affiliate(s), or its subcontractor(s), a new Form No. ST-220-TD must be filed with DTF. Form ST-220-CA must be submitted to OGS. This form provides the required certification that the Contractor filed the ST-220-TD with DTF. This form can be found at xxxx://xxx.xxx.xx.xxx/pdf/current_forms/st/st220ca_fill_in.pdf. Vendors may call DTF at 000-000-0000 for any and all questions relating to §5-a of the Tax Law and relating to a company's registration status with the DTF. For additional information and frequently asked questions, please refer to the DTF web site: xxxx://xxx.xxx.xx.xxx.
Section 11.2 Governing Law..................................................14 SECTION 113. Legal Holidays.................................................14
Section 11.3 No Personal Liability of Directors, Officers, Employees, Stockholders or Incorporators........................... 31
Reciprocal Compensation Arrangements Pursuant to Section 251(b (5) of the Act
Section 10.7 Conflict with Trust Indenture Act..............................12
Section 7.3 42 Each employee shall be assigned to a definite shift with designated times of beginning and ending.
Termination/Changes We reserve the right, in our sole discretion, to discontinue the provision of your electronic Communications, or to terminate or change the terms and conditions on which we provide electronic Communications. We will provide you with notice of any such termination or change as required by law.
Termination of Collocation Arrangement CLEC may terminate a completed Collocation arrangement by a Collocation Decommission or a Collocation Transfer of Responsibility. A Collocation site is only eligible for Collocation Decommission or a Collocation Transfer of Responsibility after the site is built-out and accepted by CLEC. Abandoned equipment shall be handled as detailed in Section 8.2.1.22.3.
Section 7.4 43 In the event an employee is assigned to a shift less than the normal work shift previously 44 defined in this Article, the employee shall be given a fifteen (15) minute rest period for each 45 consecutive/continuous four (4) hours of work. Employees assigned six (6) or more hours shall 46 be given two (2) 15-minute rest periods and an unpaid lunch period.
