Sizing and Positioning Sample Clauses

Sizing and Positioning. General conditions for print: The Compliance Certification Xxxx xxx be sized proportionally and must maintain a minimum height of ¾”.
AutoNDA by SimpleDocs
Sizing and Positioning. General conditions for print: The Authorized Assessor Xxxx must be sized proportionally and be no taller than .5 inches.

Related to Sizing and Positioning

  • New Positions The Board, in consultation with the Association, shall prepare a new job description whenever a new position of special responsibility is created or whenever the duties of any such position are changed or increased. When such a position is created or changed, the allowance shall be subject to negotiations between the Board and the Association.

  • Skidding and Yarding Methods of skid- ding or yarding specified for particular areas, if any, are indicated on Sale Area Map. Outside Clearcutting Units and construction clearings, insofar as ground conditions permit, products shall not be skidded against reserve trees or groups of reproduction and tractors shall be equipped with a winch to facilitate skidding. B6.421 Rigging. Insofar as practicable, needed rigging shall be slung on stumps or trees desig- nated for cutting.

  • CUTTING AND PATCHING The Contractor shall be responsible for cutting, fitting or patching required to complete the Work or to make its parts fit together properly.

  • Felling and Bucking Felling shall be done to minimize breakage of Included Timber and dam- age to residual timber. Unless agreed otherwise, felling shall be done by saws or shears. Bucking shall be done to permit removal of all minimum pieces set forth in A2. B6.411 Felling in Clearings. Insofar as ground conditions, tree lean, and shape of clearings per- mit, trees shall be felled so that their tops do not extend outside Clearcutting Units, construction clearings, and ar- eas of regeneration cutting. B6.000 Xxxxx Xxxxxxx. Stumps shall not exceed, on the side adjacent to the highest ground, the maximum heights set forth in A6, except that occasional stumps of greater heights are acceptable when Purchaser determines that they are necessary for safe and efficient conduct of logging. Unless otherwise agreed, Purchaser shall re-cut high stumps so they will not exceed heights specified in A6 and shall dispose of severed portions in the same manner as other logging debris. The xxxxx heights shown in A6 were selected with the objective of maximum reasonable utilization of the timber, unless Sale Area Map shows special areas where xxxxx heights are lower for aesthetic, land treatment, or silvicultural rea- sons.

  • WINDOW CLEANING Tenant shall not clean, nor require, permit, suffer or allow any window in the Premises to be cleaned from the outside in violation of Section 202 of the Labor Law, or any other Requirement, or of the rules of the Board of Standards and Appeals, or of any other board or body having or asserting jurisdiction.

  • Moonlighting Employment as a physician in a professional capacity outside of what is outlined in this Agreement, whether temporary special medical activity (“TSMA”) or external moonlighting, must be approved in writing, in advance, by the Departmental Chair, Program Director and Director of Graduate Medical Education (or designee). Even if approved, professional and general liability insurance as outlined in Section 5.4 is not provided to Trainee engaged in external moonlighting. Trainee acknowledges he or she has the responsibility to obtain insurance for such engagement. TSMA and external moonlighting must be included and reported as part of Trainee's hours spent on clinical experience and education. Trainee shall not be required to engage in any outside work.

  • Ordering and Maintenance CBB shall use Verizon’s electronic Operations Support System access platforms to submit Orders and requests for maintenance and repair of Services, and to engage in other pre-ordering, ordering, provisioning, maintenance and repair transactions. If Verizon has not yet deployed an electronic capability for CBB to perform a pre-ordering, ordering, provisioning, maintenance or repair, transaction offered by Verizon, CBB shall use such other processes as Verizon has made available for performing such transaction (including, but not limited, to submission of Orders by telephonic facsimile transmission and placing trouble reports by voice telephone transmission).

  • – ORIENTATION AND IN SERVICE 20.01 An orientation and in service program will be provided to all employees. These programs shall be reviewed and discussed from time to time by members of the Union-Management Committee. 20.02 A newly employed employee shall not be placed in charge, until she has been fully oriented to the home. 20.03 The following minimums shall be observed in the orientation/familiarization of a newly hired employee: (a) She is to be familiarized with the physical aspects of the building, the applicable policies and procedures of the Employer, and the daily routine of employees in the Home. (b) The period of orientation/familiarization shall be for a minimum of five (5) days or such greater period that the Employer deems necessary. (c) She shall be an additional employee to the usual staffing pattern. (d) The employee or employees involved in the orientation/familiarization will confirm that it has been completed, and this will be noted on the newly hired employee's personnel file, which will be reviewed with such employee, and the employee shall also be able to comment. (e) The employee may request up to three (3) additional days of paid orientation. When making her request, the employee will specify her learning needs and discuss with the Director of Care the development of the orientation learning plan. This request will not be unreasonably denied. (f) Notwithstanding the above, orientation/familiarization when an employee is transferred to a new unit/shift will be provided as required. (g) The Employer may, at its discretion, provide orientation in other circumstances. 20.04 Both the Employer and the Union recognize the joint responsibility and commitment to provide, and participate in, in-service education. The Union supports the principle of its members' responsibility for their own professional development and the Employer will endeavour to provide programmes related to the requirements of the Home. Programmes will be publicized and related material will be made readily accessible to staff in a timely manner. Any problems in accessing this information will be reported to the Union- Management Committee for resolution. (a) When an employee is required by the Employer to attend any in-service program or e-learning within the Home during her or his regularly scheduled working hours the employee shall suffer no loss of regular pay. (b) When an employee is required by the Employer to prepare for in service or to attend meetings, in service and other work related functions outside her regularly scheduled working hours, and the employee does attend same, she shall be paid for all time spent on such attendance at her regular straight time hourly rate of pay or at the employee's option, she shall receive equivalent time off. When an employee is required by the Employer to complete an e-learning programme outside her regularly scheduled working hours, she shall be paid for all time spent completing such learning at her regular straight time hourly rate of pay or at the employee's option, she shall receive equivalent time off. Part-time employees will be credited with seniority and service for all such hours paid as provided above while in attendance at in-services, meetings, and completing e-learning. (c) The Employer will endeavour where practical to schedule in-services at times which will facilitate the attendance of employees working outside the day shift. 20.06 When required by a certifying body to update an employee's qualifications, except where this matter is covered by another provision of the collective agreement, the Employer shall grant leave of absence without pay which shall include the time required to write any examinations. 20.07 The Employer undertakes to notify the Union in advance, so far as practicable, of any technological changes which the Employer has decided to introduce which will significantly change the employment status of the employee(s) within the bargaining unit. The Employer agrees to discuss with the Union the effect of such technological changes on the employment status of the employee(s) and to consider practical ways and means of minimizing the adverse effect, if any, on the employee(s) concerned. Employees who are subject to layoff due to technological change will then be given notice of such layoff at the earliest reasonable time and in keeping with the requirements of the applicable legislation and the provisions of Article 9.11 to

  • VACANCIES AND NEW POSITIONS 3.3.1 During the work year, written notices of vacancies and new positions within the bargaining unit will be posted on the District jobs website for not less than five (5) working days. For an applicant to be considered for a vacant or new position, they must: a. Submit their online application and all other required application materials no later than five (5) working days from the first day of the posting, and b. Possess the minimum skills and qualifications applicable to the vacant or new position. 3.3.2 A vacancy is an open position within the bargaining unit or non represented groups over 10 hours per week (i.e., 2.1 hours per day). Employees who meet the posted qualifications will receive an interview for the position upon application. Applicants not receiving an interview or offer of position will be given feedback, upon request. Skill tests will not normally be required if the skill requirements of the new position are not greater than the applicant's current assignment unless the skill test is deemed necessary to determine the most qualified applicant. Positions will be filled by any present or prospective employee based upon affirmative action requirements, experience, and job qualifications for the position. If two finalists are considered equal, then the applicant from within the district with the most bargaining unit seniority will be selected for bargaining unit positions. 3.3.3 Employees transferred to new positions in the bargaining unit will receive salary credit at full value for all prior experience gained within the bargaining unit. 3.3.4 Current employees within the bargaining unit who are accepted for a position under Section 3.3.2 above will be given a thirty (30) work day work trial. If the employee's performance on the new job is not satisfactory, she/he will be returned to her/his former position or to another suitable position. Absent just cause for termination, such employee will not be terminated due to her/his unsatisfactory performance during the thirty (30) day trial period. 3.3.5 Increased hours at the worksite will be offered first to the most senior employees within the classification, if qualified as determined by the supervisor at the worksite, providing they have a work schedule which can accommodate the additional hour(s) within a normal work week. The number of hours per week may be offered up to ten (10) hours, but may not result in a combined assignment of more than forty (40) hours per week. Employees wishing more hours of work will notify their supervisor/building administrator in writing. 3.3.6 Summer school assignments will be offered on a seniority basis, except that those employees who carry out the job during the course of the regular work year will receive first choice of refusal. 3.3.7 If the school district uses a numerical staffing formula to assign employees to schools based on enrollment, employee hours will be adjusted in October of the school year to reflect actual enrollment. The formula results and adjusted hours will be provided to the association president(s) by October 15. 3.3.8 The district will provide at least a two (2) week written notice of paraeducator hour reduction due to a decreased student overload factor. 3.3.9 An employee involuntarily transferred to a new position with a different job title will suffer no loss in hourly rate of pay. The transferred employee will be placed on the same experience step as in the previous position. An employee transferred to a position with a lower hourly rate of pay will be required to seek to restore lost pay by applying for open positions within the department for which he/she is qualified. An employee may choose to decline up to three (3) positions that will make him/her whole. Following the third (3rd) decline, any enhanced pay, travel time, and/or mileage reimbursements will end. 3.3.10 When reassignments are too numerous to fill individually, the district will schedule a reassignment meeting. The district will display all open positions and the current seniority list. Employees facing reassignment will be required to attend either in person or by proxy. By seniority, employees must select from any open position for which they are qualified to restore any lost hours. Such restoration cannot exceed thirty (30) additional minutes over lost hours. If hours cannot be restored with open positions by seniority, employees may bump the least senior person. Bumping will occur in the following order, first by the department in which they have lost hours and then by any other departments in which they retain seniority. Multiple reassignment meetings may be necessary. 3.3.11 Employees who have been reassigned will have priority rights, by seniority, to open positions for which they are qualified for up to twenty-four months. Reassigned employees will be required to communicate in writing, in person, by proxy, or by email their interest in a position in the pool no later than 4:00 PM of the day the position closes, if the position will make them whole. If employees have not responded by 4:00 PM of the day the position closes, they have declined the position. Notice of assignment will be provided via phone and follow-up letter within five (5) working days.

  • Deployment (a) In filling a position vacancy at a location NAV CANADA may proceed by the transfer of an employee at the same level. (b) For the purposes of this Article, a “transfer” shall be considered to be a lateral change in position. (c) Transfer requiring relocation under the NCJC Travel Program shall be subject to the employee’s written consent.

Draft better contracts in just 5 minutes Get the weekly Law Insider newsletter packed with expert videos, webinars, ebooks, and more!