Snap-on Receipt of the PSW. The assigned Snap-on Quality, Purchasing, or Engineering representative will coordinate the review of the supplier PSW and samples. The Snap-on representative will work with the supplier to verify that proper corrective actions are in place for each non-conforming category requirement prior to start of production. Disposition of the Supplier PSW By signing and dating the PSW form, the assigned Snap-on representative will provide one of the following dispositions: Approved for Production Approval will be granted if all applicable requirements are met and permanent corrective actions are implemented for all non-conforming category requirements. Samples must meet all form, fit, function, visual, and any reliability test requirements. Conditional Approval In the event that a dimensional specification, test result, material specification, or any other PPAP requirement has not been met, “Conditional Approval” may be granted as long as samples meet minimum form, fit, function and reliability requirements. Conditional approval cannot be granted unless temporary corrective actions are in place for all nonconforming category requirements or Snap-on Design Engineering agrees that the non-conformance will not create a customer complaint or safety concern. A conditional approval expiration date must be given to notify the supplier that a resubmission for final approval must be complete to finalize “Approval” of the part. Rejected A rejection will be issued to the supplier if samples do not meet all form, fit, function and applicable reliability or dimensional requirements. Temporary and / or permanent corrective actions for non-conformances must be submitted to the assigned Quality/Purchasing representative to gain either Conditional or Full Part Approval.
