STARTING/LOADING Sample Clauses

STARTING/LOADING. All starting is done automatically, with the operator given the opportunity to hold the start-up sequence at either the crank (pre-ignition) or fire (post-ignition, pre-accelerate) points of the start-up. An "Auto" mode selection results in a start without any holds. Either before issuing a start command, or during the start, the operator may make the following selections: 1. Select or disable the automatic synchronization capability of the Xxxx V control. Auto synch utilizes the proven microsynchronizer first introduced in the Xxxx XX generation of SPEEDTRONIC. The microsynchronizer provides extremely accurate and repeatable breaker closures based on phase angle, slip, the rate of change of slip and the response time of the breaker which is in the system memory.
Sample 1Sample 2
AutoNDA by SimpleDocs
STARTING/LOADING. All starting is done automatically, with the operator given the opportunity to hold the start–up sequence at either the crank (pre–ignition) or fire (post–ignition, pre–accelerate) points of the start–up. An “Auto” mode selection results in a start without any holds. Either before issuing a start command, or during the start, the operator may make the following selections: Select or disable the automatic synchronization capability of the SPEEDTRONIC Xxxx V control. Automatic synchronization utilizes the microsynchronizer to provide accurate and repeatable breaker closures based on phase angle, slip, the rate of change of slip, and the response time of the breaker which is in the system memory. Select preselected load, base load or peak load. If a selection is made the unit will automatically load to the selected point and control there. If no selection is made the unit will load to a low load referred to as “Spinning Reserve” automatically upon synchronization; be it automatic or manual. The turbine governor is automatically regulated to maintain the megawatt setting assigned to “Spinning Reserve”.
Sample 1

Related to STARTING/LOADING

  • Leave Loading The employer and the individual employee must have genuinely made the agreement without coercion or duress.

  • Annual Leave Loading During a period of annual leave an employee will receive a loading of 17.5 per cent calculated on the employee’s normal hourly rate of pay and the daily fares allowance if applicable. The loading will also apply to proportionate leave on lawful termination.

  • Shift and Weekend Premium (a) An employee shall be paid a shift premium of eighty-five cents (85¢) per hour for each hour worked between the hours of 1500-0700 hours. (b) Effective July 1, 2013, an employee shall be paid a weekend premium of one dollar ($1.00) per hour for each hour worked between 2300 hours Friday and 2300 hours Sunday, or such other forty-eight (48) hour period as the local parties may agree upon or as defined in the Collective Agreement. If an employee is receiving premium pay pursuant to a local scheduling regulation with respect to consecutive weekends worked, the employee will not receive weekend premium under this provision.

  • INTERIM MAINTENANCE PERIOD During the interim maintenance period between obtaining of the completion certificate of such Project and formation and operationalization of the Association the Promoter shall through itself or through a facility management company to run, operate, manage and maintain the Common Areas. The Promoter shall endeavour that the committee responsible for the maintenance and operation of the Common Areas will be required to provide manpower for maintaining the Common Areas, wherever required, and to collect maintenance charges and also guest charges and the user charges for the utilities being provided on “pay by use” basis, if any. The maintenance and management of Common Areas by the committee will primarily include but not limited to maintenance of water works, common electrical installations, DG Sets, landscaping, driveways, parking areas, lobbies, lifts and staircases, AMC’s etc. It will also include safety and security of the Project such as fire detection and protection and management of general security control of the Project. The Rules/ Bye Laws to regulate the use and maintenance of the Common Areas shall during the interim maintenance period shall be framed by the Promoter with such restrictions as may be necessary for proper maintenance and all the Allottees are bound to follow the same. After the Common Areas of the Project are handed over to the Association, the Association may adopt the Rules and the Bye laws framed by the Promoter, with or without amendments, as may be deemed necessary by the Association.

  • LESSOR'S ACCESS; SHOWING PREMISES; REPAIRS Lessor and Lessor's agents shall have the right to enter the Premises at any time, in the case of an emergency, and otherwise at reasonable times for the purpose of showing the same to prospective purchasers, lenders, or lessees, and making such alterations, repairs, improvements or additions to the Premises or to the Building, as Lessor may reasonably deem necessary. Lessor may at any time place on or about the Premises or Building any ordinary "For Sale" signs and Lessor may at any time during the last one hundred eighty (180) days of the term hereof place on or about the Premises any ordinary "For Lease" signs. All such activities of Lessor shall be without abatement of rent or liability to Lessee.

  • PRICING OF After Hours Coefficient What is your after hours coefficient for the RS Means Price Book for work performed after normal working hours?

  • Loading RPMG shall schedule the loading and shipping of all outbound corn oil purchased hereunder, but all labor and equipment necessary to load trucks and rail cars and other associated costs shall be supplied and borne by Producer without charge to RPMG. Producer shall handle the corn oil in a good and workmanlike manner in accordance with RPMG’s written requirements and normal industry practice. Producer shall maintain the truck and rail loading facilities in safe operating condition in accordance with normal industry standards and shall visually inspect all trucks and rail cars to assure (i) cleanliness so as to avoid contamination, and (ii) that such trucks and railcars are in a condition suitable for transporting the corn oil. RPMG and RPMG’s agents shall have adequate access to the Ethanol Facility to load Producer’s corn oil on an industry standard basis that allows RPMG to economically market Producer’s corn oil. RPMG’s employees shall follow all reasonable safety rules and procedures promulgated by Producer and provided to RPMG reasonably in advance and in writing. Producer shall supply product description tags, certificates of analysis, bills of lading and/or material safety data sheets that are applicable to all shipments. In the event that Producer fails to provide the labor, equipment and facilities necessary to meet RPMG’s loading schedule, Producer shall be responsible for all costs and expenses, including without limitation actual demurrage and wait time, incurred by RPMG resulting from or arising in connection with Producer’s failure to do so.

  • JOC - PRICING OF After Hours Coefficient What is your after hours coefficient for the RS Means Price Book for work performed after normal working hours? (FAILURE TO RESPOND PROHIBITS PART 2 JOC EVALUATION)

  • Use of Basement and Service Areas The basement(s) and service areas, if any, as located within the

  • Lease Period The lease period of the Finance Lease Agreement II is 36 months, which commenced on July 31, 2023. The lease period of the Finance Lease Agreement III is 36 months, which commenced on October 13, 2023. The lease period of the Finance Lease Agreement IV is 36 months, which shall commence on October 30, 2023.

Draft better contracts in just 5 minutes Get the weekly Law Insider newsletter packed with expert videos, webinars, ebooks, and more!