Windsurfing Equipment Sample Clauses

Windsurfing Equipment. Subject to the conditions and charges specified below, windsurfing boards will be accepted as Checked Baggage. For purposes of this provision, one windsurfing board not exceeding 115 inches in length and not exceeding 70 pounds (31.8kgs) with a boom and one mast and sail will be considered as one item of windsurfing equipment. a. Items of windsurfing equipment must be padded and enclosed in suitable packing to protect from scratches, dents or other damage resulting from normal handling. b. Windsurfing equipment provisions will apply to tandem boards. c. Windsurfing equipment will be subject to a service charge of USD 100/CAD 100 for domestic travel, and USD 200/CAD 200 for international travel, for each item of windsurfing equipment, whether or not presented as a single piece. d. Items of windsurfing equipment in excess of one per Ticketed Passenger will be accepted subject to payment of three times the applicable service charge specified above and will be carried subject to availability of space. Additional size or acceptance limitations may apply dependent upon aircraft type and configuration. e. Windsurfing equipment will not be accepted for transportation during an Excess Baggage Embargo.
AutoNDA by SimpleDocs
Windsurfing Equipment. Subject to the conditions and charges specified below, windsurfing boards will be accepted as Checked Baggage. For purposes of this provision, one windsurfing board not exceeding 115 inches in length and not exceeding 70 pounds (31.8 kgs) with one boom, one mast, one sail and necessary hardware will be considered as one item of windsurfing equipment. a) Windsurfing equipment must be padded and enclosed in suitable packing sufficient to protect from scratches or dents or other damage. b) Windsurfing equipment will be subject to a service charge of a 150 USD/ 150 CAD (each way) per item for travel between the U.S., Canada, Puerto Rico and the U.S. Virgin Islands and a 200 USD service charge for all other travel. c) Windsurfing equipment cannot be accommodated on any itinerary involving a United Express flight, and is not accepted during excess baggage embargos. Additional size or acceptance limitations may apply dependent upon aircraft type and configuration. d) Allow an extra 30 minutes at check-in.
Windsurfing Equipment. Windsurfing equipment is not required to be in a case and consists of one windsurfing board and one mast, boom, and sail. On Airbus aircraft, the maximum mast length is 15 feet. On Alaska flights operated by Horizon E175, Q400 or SkyWest XXX 000 aircraft on behalf of Alaska Airlines, the maximum single dimension is 8 ft.

Related to Windsurfing Equipment

  • Metering Equipment 13.01. Utility will furnish, install, own and maintain metering equipment capable of measuring the flow of kilowatt-hours (kWh) of energy. The Customer's service associated with the CRG will be metered at a single metering point. The metering equipment will measure energy delivered by Utility to Customer and also measure energy delivered by Customer to Utility. Customer agrees to provide safe and reasonable access to the premises for installation of this equipment and its future maintenance or removal.

  • Electrical Equipment Residents must use only CSA, UL-approved or Canadian-certified electrical equipment; the rated wattage of light fixtures must never be exceeded; and only replacement bulbs supplied by Waterloo maintenance staff may be used. Do not leave any unattended electrical equipment turned on (i.e. hair straighteners, lights etc.)

  • Capital Equipment Collaborator’s commitment, if any, to provide ICD with capital equipment to enable the research and development activities under the Research Plan appears in Appendix B. If Collaborator transfers to ICD the capital equipment or provides funds for ICD to purchase it, then ICD will own the equipment. If Collaborator loans capital equipment to ICD for use during the CRADA, Collaborator will be responsible for paying all costs and fees associated with the transport, installation, maintenance, repair, removal, or disposal of the equipment, and ICD will not be liable for any damage to the equipment.

  • Furniture, Fixtures and Equipment Sublessee shall have the right to use during the Term the office furnishings and equipment within the Subleased Premises that are identified on Exhibit C attached hereto, as such exhibit may be adjusted by mutual agreement of the parties prior to the Third Floor Premises Delivery Date (the “Furniture”), provided Sublessee may only use the Furniture located in the Second Floor Premises after the Second Floor Commencement Date. The Furniture is provided in its “AS IS, WHERE IS” condition, without representation or warranty whatsoever. Sublessee shall insure the Furniture under the property insurance policy required under the Master Lease, as incorporated herein, and pay all taxes with respect to the Furniture. Sublessee shall maintain the Furniture in good condition and repair, reasonable wear and tear excepted, and shall be responsible for any loss or damage to the same occurring during the Term. Sublessee shall surrender the Furniture to Sublessor upon the termination of this Sublease in the same condition as exists as of the applicable Delivery Date, reasonable wear and tear excepted. Sublessee shall not remove any of the Furniture from the Subleased Premises. Notwithstanding anything to the contrary herein, Sublessee may provide Sublessor with written notice one (1) time not less than forty-five (45) days prior to the Third Floor Premises Delivery Date that lists any items of Furniture that Sublessee does not want to use and Sublessor shall, at no cost to Sublessee, remove such items from the Subleased Premises prior to the Third Floor Premises Delivery Date and such items shall no longer be considered Furniture hereunder. Notwithstanding the foregoing, provided Sublessee is not in default beyond the expiration of any applicable cure or grace period as of the date of the expiration or earlier termination of this Sublease, which condition may be waived by Sublessor in its sole discretion, then upon the expiration or earlier termination of this Sublease, the Furniture shall become the property of Sublessee, and Sublessee shall accept the same in its “AS IS, WHERE IS” condition, without representation or warranty whatsoever except as provided in the Bill of Sale referred to in the following sentence. In the event the Furniture is to become the property of Sublessee upon the expiration or earlier termination of this Sublease pursuant to the terms of the immediately preceding sentence, then Sublessor agrees to execute and deliver to Sublessee a Bill of Sale in the form of Exhibit D attached hereto conveying and transferring to Sublessee the Furniture.

  • Testing of Metering Equipment Connecting Transmission Owner shall inspect and test all of its Metering Equipment upon installation and at least once every two (2) years thereafter. If requested to do so by NYISO or Developer, Connecting Transmission Owner shall, at Developer’s expense, inspect or test Metering Equipment more frequently than every two (2) years. Connecting Transmission Owner shall give reasonable notice of the time when any inspection or test shall take place, and Developer and NYISO may have representatives present at the test or inspection. If at any time Metering Equipment is found to be inaccurate or defective, it shall be adjusted, repaired or replaced at Developer’s expense, in order to provide accurate metering, unless the inaccuracy or defect is due to Connecting Transmission Owner’s failure to maintain, then Connecting Transmission Owner shall pay. If Metering Equipment fails to register, or if the measurement made by Metering Equipment during a test varies by more than two percent from the measurement made by the standard meter used in the test, Connecting Transmission Owner shall adjust the measurements by correcting all measurements for the period during which Metering Equipment was in error by using Developer’s check meters, if installed. If no such check meters are installed or if the period cannot be reasonably ascertained, the adjustment shall be for the period immediately preceding the test of the Metering Equipment equal to one-half the time from the date of the last previous test of the Metering Equipment. The NYISO shall reserve the right to review all associated metering equipment installation on the Developer’s or Connecting Transmission Owner’s property at any time.

  • Equipment Cleaning (a) Areas, known by Forest Service prior to timber sale advertisement, that are infested with invasive species of concern are shown on Sale Area Map. A current list of invasive species of concern and a map showing the extent of known infestations is available at the Forest Supervisor’s Office. For purposes of this provision, “Off-Road Equipment” includes all logging and construction machinery, except for log trucks, chip vans, service vehicles, water trucks, pickup trucks, cars, and similar vehicles.

  • Computer Equipment Recycling Program If this Contract is for the purchase or lease of computer equipment, then Contractor certifies that it is in compliance with Subchapter Y, Chapter 361 of the Texas Health and Safety Code related to the Computer Equipment Recycling Program and the Texas Commission on Environmental Quality rules in 30 TAC Chapter 328.

  • Fixtures and Equipment Each of the Company and its Subsidiaries (as applicable) has good title to, or a valid leasehold interest in, the tangible personal property, equipment, improvements, fixtures, and other personal property and appurtenances that are used by the Company or its Subsidiary in connection with the conduct of its business (the “Fixtures and Equipment”). The Fixtures and Equipment are structurally sound, are in good operating condition and repair, are adequate for the uses to which they are being put, are not in need of maintenance or repairs except for ordinary, routine maintenance and repairs and are sufficient for the conduct of the Company’s and/or its Subsidiaries’ businesses (as applicable) in the manner as conducted prior to the Closing. Each of the Company and its Subsidiaries owns all of its Fixtures and Equipment free and clear of all Liens except for (a) liens for current taxes not yet due and (b) zoning laws and other land use restrictions that do not impair the present or anticipated use of the property subject thereto.

  • Special Equipment The Employer agrees to provide specialty tools, emergency supplies/equipment, testing equipment and safety equipment as needed to perform required duties as determined and authorized by the Chief or designee. The emergency supplies/equipment will include appropriate survival provisions and equipment for each permanent Maintenance Mechanic 4 and the Law Enforcement Communications Systems Supervisor when they are performing duties that would require such provisions and equipment. When necessary, the employer will replenish used or expired survival provisions and damaged and unusable equipment. All supplies and equipment will be returned to the employer when the employee is no longer performing the duties that would require the survival provisions and/or equipment.

  • Additional Equipment Additional Equipment may from time to time be added as the subject matter of this Agreement as agreed on by the parties. Any additional property will be added in an amendment describing the property, the monthly rental, security deposit, and stipulated loss value of the additional Equipment. All amendments must be in writing and signed by both parties. Other than by this amendment procedure, this Agreement may not be amended, modified, or altered in any manner except in writing signed by both parties.

Draft better contracts in just 5 minutes Get the weekly Law Insider newsletter packed with expert videos, webinars, ebooks, and more!