Transfer case means the sealed box used to transport voted ballots to the
Transfer case means the sealed box used to transport voted ballots to the 839 counting center.
Transfer case means a device that splits the engine power of a vehicle and directs it to the front and rear drive axles. It is mounted behind the transmission and both front and rear drive shafts connect to it. It comprises either a gearwheel set or a chain drive system in which the power is distributed from the transmission to the axles. The transfer case will typically have the ability to shift between standard drive mode (front or rear wheel drive), high range traction mode (front and rear wheel drive), low range traction mode and neutral;
Examples of Transfer case in a sentence
TRANSFER CASE: Transfer case and all internally Lubricated Parts.
TRANSFER CASE COMPONENTS: Transfer Case (only if damaged by internally lubricated parts) and all internal Lubricated Parts of the Transfer Case.
TRANSFER CASE All internal lubricated parts, plus the transfer case housing only if the damage results from the failure of an internal lubricated part.
TRANSFER CASE – All Internal Lubricated Parts within the transfer case including main shaft, output shafts, bearings, drive sprocket, synchronizers, planet carriers, shift forks, chain.
TRANSFER CASE (4x4 VEHICLES)* – All internal parts of the transfer case.
More Definitions of Transfer case
Transfer case means a container, prescribed by the Secretary of the State Election Board, which can be closed and sealed and is constructed so as to, when sealed, prevent accidental opening or opening by any other reasonable means, except by removing, breaking, tearing or otherwise damaging the seal so if opened by any means it would be obvious in the normal situation that the container had been subject to tampering; and
Transfer case. All internally lubricated parts of the 4 x 4 Transfer Case. Breakdown of the Transfer Case is covered if caused by the failure of an internally lubricated part. SEALS & GASKETS: Seals and gaskets are only covered when required in connection with the replacement or repair of a Covered Part. Any parts not listed in this section for coverage are not covered by this Contract, with the exception of “Add On” parts as selected on the Application Page of this Contract and defined in “Section VII. Add On Coverage Options”.
Transfer case. All internal parts; transfer case mounts; shift linkage; electronic shift control module; sensors and switches; all wheel drive engagement module and actuator. The transfer case is covered only if damaged by the failure of an internal part. DRIVE AXLE: (Front / Rear Wheel Drive) All internal parts; axle shafts; constant velocity joints (except any damage to the constant velocity joint due to the failure of the sealing boot is not covered); universal joints; propeller shafts; center support bearings; axle bearings; hubs and hub bearings; locking rings. The drive axle case is covered only if damaged by the failure of an internal part. STEERING: Gear housing, rack and pinion, internal steering rack seals, and all internal components; power steering pump and pump seal; power steering lines/hoses; tilt wheel mechanism; steering linkage; tie rod ends; xxxxxx arms, center link; steering dampener; steering column shafts, joints and couplings. SUSPENSION: (Front and Rear) Upper and lower control arms; control arm shafts and bushings; control arm linkage; ball joints; torsion bars and bushings; steering knuckles / spindles; stabilizer shaft linkage and bushings; wheel bearings; springs; MacPherson strut upper mount/bearing plate (strut shock absorber function is not covered).
Transfer case means the sealed box used to transport voted ballots to the 1236 counting center. 1237 (75) "Vacancy" means the absence of a person to serve in any position created by 1238 statute, whether that absence occurs because of death, disability, disqualification, resignation, 1239 or other cause. 1240 (76) "Valid voter identification" means: 1241 (a) a form of identification that bears the name and photograph of the voter which may 1242 include: 1243 (i) a currently valid Utah driver license; 1244 (ii) a currently valid identification card that is issued by: 1245 (A) the state; 1246 (B) a local government within the state; or 1247 (C) a branch, department, or agency of the United States; 1248 (iii) an identification card that is issued by an employer for an employee; 1249 (iv) a currently valid identification card that is issued by a college, university, technical 1250 school, or professional school that is located within the state; 1251 (v) a currently valid Utah permit to carry a concealed weapon; 1252 (vi) a currently valid United States passport; or 1253 (vii) a valid tribal identification card; or 1254 (b) two forms of identification that bear the name of the voter and provide evidence 1255 that the voter resides in the voting precinct, which may include: 1256 (i) a voter identification card; 1257 (ii) a current utility bill or a legible copy thereof; 1258 (iii) a bank or other financial account statement, or a legible copy thereof; 1259 (iv) a certified birth certificate; 1260 (v) a valid Social Security card; 1261 (vi) a check issued by the state or the federal government or a legible copy thereof; 1262 (vii) a paycheck from the voter's employer, or a legible copy thereof; 1263 (viii) a currently valid Utah hunting or fishing license; 1264 (ix) a currently valid United States military identification card; 1265 (x) certified naturalization documentation;
Transfer case. All internally oil lubricated parts contained within the transfer case. The transfer case housing is covered only if damaged by the failure of an internally oil lubricated covered part. DRIVE AXLE (FRONT & REAR): All internally lubricated parts contained within the drive axle housing; axle shafts; constant velocity joints; drive shafts; universal joints; drive shafts; wheel bearings; locking hubs, locking rings and retainers. Drive axle housing is covered only if damaged by the failure of an internally lubricated part. SUSPENSION (FRONT & REAR): Upper and lower control-arm shafts and bushings; kingpins; spindle and spindle supports; upper and lower ball joints; stabilizer bar; stabilizer links and bushings; torsion bars; radius arms and bushings.
Transfer case. All internal lubricated parts, plus the transfer case housing only if the damage results from the failure of an internal lubricated part; seals and gaskets. DRIVE AXLE ASSEMBLY (front or rear) - All internal lubricated parts contained within the drive axle housing; hub, axle and non-serviceable bearings, drive gears and clutches. Constant velocity joints, universal joints, axle shafts, drive shafts; seals and gaskets. The axle or transaxle housing, only if the damage results from the failure of an internal lubricated part. ENGINE COOLING/HEATING - Water pump including: Impeller shaft, bearings and bushings. Radiator, heater core, thermostat, xxx, xxx clutch, fan motor, controller module, coolant recovery unit, fan shroud, electric block heater; seals and gaskets.
Transfer case means a metal container used for transporting and storing voted ballot cards. The container shall be capable of being sealed with a metal seal and be approved in the manner ballot boxes are approved pursuant to section 24j of the act.