Meal Periods (a) Meal periods shall be scheduled as close as possible to the middle of the scheduled hours of work. The length of the meal period shall be agreed to at the local level and shall be not less than 30 minutes nor more than 60 minutes. (b) An employee shall be entitled to take their meal period away from the workstation. Where this cannot be done, the meal period shall be considered as time worked.
Break Periods There will be no rest periods, organized coffee breaks or other non-working time established during working hours. Individual coffee containers will be permitted at the employee’s work location.
Preparation Periods 31-1 The School District agrees to maintain daily preparation periods during the student day in all junior and senior high schools. At schools where block scheduling is in effect, the total preparation time provided shall be equal to the preparation time provided at schools not operating on a block schedule. 31-2 The School District shall maintain at each elementary school a minimum of two hundred and fifty (250) minutes preparation time per week per teacher, during the students’ instructional day, in not less than forty- (40) minute blocks. Each elementary school shall be allocated and assigned library aide hours per school day in accordance with the following schedule: This aide time is provided in addition to the assigned media clerk time. Library aide time is guaranteed for the school year once set on a school year basis. There will be no changes in library aide time allocated due to fluctuation in enrollment. This provision for allocating library aide time will only remain as part of this Agreement if librarians are used to provide preparation time to elementary teachers. 31-3 Preparation time provided for in this Article shall be utilized by teachers in a manner which enables further development and refinement of professional skills and for instructional effectiveness. 31-4 Although it does not relate to any mandatory subject of bargaining, the School District states that it is its aim and objective to establish a maximum class load of thirty (30) students in grades 4, 5, and 6. 00-0 Xxx Xxxxxxxx may direct use of teacher preparation periods if such directed use is infrequent, advance notice is given and the District’s use of the teacher’s preparation period must not consume an entire period.
Rest and Meal Periods Employees shall be entitled to relief periods during the shift on the basis of fifteen
Waiting Periods All applicable waiting periods, if any, under the HSR Act shall have expired or been terminated.
Grace Periods The related Mortgage or Mortgage Note provides a grace period for Monthly Payments no longer than ten (10) days from the applicable Due Date.
Modifications and Updates to the Wire Center List and Subsequent Transition Periods 5.4.6.1 In the event AT&T identifies additional wire centers that meet the criteria set forth in Sections 5.4.2.1 or 5.4.2.2 above, but that were not included in the Master List of Unimpaired Wire Centers or AT&T’s List of Unimpaired Wire Centers, AT&T shall include such additional wire centers in a CNL. Each such list of additional wire centers shall be considered a Subsequent Wire Center List. AT&T will follow any limitations on the frequency with which it may issue such lists and notification procedures set forth in applicable Commission orders. 5.4.6.2 TWTC shall have thirty (30) business days to dispute the additional wire centers listed on AT&T’s CNL. Absent such dispute, effective thirty (30) business days after the date of a AT&T CNL providing a Subsequent Wire Center List, AT&T shall not be required to provide DS1 and DS3 Dedicated Transport, as applicable, in such additional wire center(s), except pursuant to the self-certification process as set forth in Section 1.9.1 of this Attachment. 5.4.6.3 For purposes of Section 5.4.6.1 above, AT&T shall make available DS1 and DS3 Dedicated Transport that were in service for TWTC in a wire center on the Subsequent Wire Center List as of the thirtieth (30th) business day after the date of AT&T’s CNL identifying the Subsequent Wire Center List (Subsequent Embedded Base) until one hundred eighty (180) days after the thirtieth (30th) business day Version: 4Q06 Standard ICA 11/30/06 from the date of AT&T’s CNL identifying the Subsequent Wire Center List (Subsequent Transition Period). 5.4.6.4 The rates set forth in Exhibit B shall apply to the Subsequent Embedded Base during the Subsequent Transition Period. 5.4.6.5 No later than one hundred eighty (180) days from AT&T’s CNL identifying the Subsequent Wire Center List, TWTC shall submit an LSR(s) or spreadsheet(s) as applicable, identifying the Subsequent Embedded Base of circuits to be disconnected or converted to other AT&T services. 5.4.6.5.1 In the case of disconnection, the applicable disconnect charges set forth in this Agreement shall apply. 5.4.6.5.2 If TWTC chooses to convert DS1 and/or DS3 Dedicated Transport to special access circuits in existence as of the Effective Date of this Agreement, AT&T will include such DS1 and/or DS3 Dedicated Transport within TWTC’s total special access circuits, and apply any discounts to which TWTC is entitled from the transition period of 3/11/2006 to the conversion date. Conversions will be subject to the switch-as-is charge set forth in Exhibit A to this Attachment 2. 5.4.6.5.3 AT&T shall not impose disconnect or nonrecurring installation charges when transitioning the Subsequent Embedded Base of DS1 and DS3 Dedicated Transport in existence as of the Effective Date of this Agreement. 5.4.6.6 If TWTC fails to submit the LSR(s) or spreadsheet(s) for all of its Subsequent Embedded Base by one hundred eighty (180) days after the date of AT&T’s CNL identifying the Subsequent Wire Center List, AT&T will identify TWTC’s remaining Subsequent Embedded Base, if any, and will transition such circuits to the equivalent tariffed AT&T service(s), or in the case of Georgia, to the equivalent 271 service(s) set forth in Exhibit 1. In the states of Florida, Kentucky, Mississippi and South Carolina, those circuits identified and transitioned by AT&T shall be subject to the applicable disconnect charges as set forth in this Agreement and the full nonrecurring charges for installation of the equivalent tariffed AT&T service as set forth in AT&T’s tariffs. In the states of Alabama, Georgia, North Carolina and Tennessee, those circuits identified and transitioned by AT&T shall be subject to the applicable switch-as-is rates set forth in Exhibit A of Attachment
Limitation Periods To the extent that any limitation period applies to any claim for payment of the Obligations or remedy for enforcement of the Obligations, the Obligor agrees that: (a) any limitation period is expressly excluded and waived entirely if permitted by applicable law; (b) if a complete exclusion and waiver of any limitation period is not permitted by applicable law, any limitation period is extended to the maximum length permitted by applicable law; (c) any applicable limitation period shall not begin before an express demand for payment of the Obligations is made in writing by the Credit Union to the Obligor; and (d) any applicable limitation period shall begin afresh upon any payment or other acknowledgment of the Obligations by the Obligor.
Review Periods Owner shall have up to ten (10) Business Days from its receipt of the documents listed in Sections 1.3 and 1.4 above, to issue to Contractor written comments on such documents, Drawings and Specifications. The Owner’s approval rights only apply to documents listed in Section 1.3. If comments are not received for items listed in Section 1.3 in ten (10) Business Days, the Contractor may proceed with the development of the Drawings and Specifications with the design reflected in the uncommented document. Owner will annotate the Drawings and Specifications as appropriate and return to Contractor. In the event that Owner disapproves the Drawings or Specifications, Owner shall provide Contractor with a written statement of the reasons for such rejection within the time period required for Owner’s response, and Contractor shall provide Owner with agreed to revised and corrected Drawings and Specifications as soon as possible thereafter.
Method of Selecting Types and Interest Periods for New Advances The Borrower shall select the Type of Advance and, in the case of each Eurodollar Advance, the Interest Period applicable thereto from time to time. The Borrower shall give the Administrative Agent irrevocable notice (a "Borrowing Notice") not later than 11:00 a.m. (Chicago time) on the Borrowing Date of each Floating Rate Advance and not later than 11:00 a.m. (Chicago time) three Business Days before the Borrowing Date for each Eurodollar Advance, specifying: (i) the Borrowing Date, which shall be a Business Day, of such Advance, (ii) the aggregate amount of such Advance, (iii) the Type of Advance selected, and (iv) in the case of each Eurodollar Advance, the Interest Period applicable thereto. Not later than noon (Chicago time) on each Borrowing Date, each Lender shall make available its Loan or Loans in funds immediately available in Chicago to the Administrative Agent at its address specified pursuant to Article XIII. The Administrative Agent will make the funds so received from the Lenders available to the Borrower at the Administrative Agent's aforesaid address.
