Technical Specifications The Technical Specifications furnished on the CD are intended to establish the standards for quality, performance and technical requirements for all labor, workmanship, material, methods and equipment necessary to complete the Work. When specifications and drawings are provided or referenced by the County, these are to be considered part of the Scope of Work, and to be specifically documented in the Detailed Scope of Work. For convenience, the County supplied specifications, if any, and the Technical Specifications furnished on the CD.
Quality Specifications SANMINA-SCI shall comply with the quality specifications set forth in its Quality Manual, incorporated by reference herein, a copy of which is available from SANMINA-SCI upon request.
Product Specifications The Company agrees that all Products sold to Xxxx hereunder shall conform to the respective specifications set forth on Schedule A or to such other specifications as are from time to time agreed upon by the Parties.
Base Building “Base Building” means the Building Structure and Mechanical Systems, collectively, defined as follows:
Base Building Work Landlord shall construct the Base Building Work as further set forth on Exhibit 10.03, attached.
Building Signage So long as the Sign Conditions continue to prevail, Tenant shall have the exclusive right, at Tenant’s sole cost and expense, subject to Applicable Law, the terms of this Lease and Landlord’s approval rights, to install and maintain two (2) exterior signs on each Building (each hereinafter, “Building Sign”). The location, size, construction, mounting and design of each Building Sign shall be subject to Landlord’s approval (which approval shall not be unreasonably withheld or delayed). Tenant shall obtain, at its expense, all permits and approvals required for the installation of each Building Sign prior to the installation thereof (but shall not be permitted to seek any zoning or similar relief for Building’s Sign without Landlord’s consent, which may be withheld in Landlord’s sole discretion), and shall keep all such perm its and approvals in full force and effect throughout the Term. Tenant acknowledges that each such Building Sign shall be at Tenant’s risk and Tenant shall perform all maintenance and repairs to each Building Sign required to keep it in good condition. The installation, repair, maintenance and removal of any Building Sign shall be subject to the applicable provisions of the Lease and Landlord’s other reasonable requirements. Tenant shall promptly notify Landlord any proposed changes in the Building Sign, including the addition of signage for any Transferee permitted hereunder, and any estimated costs thereof, and such changes shall be subject to Landlord’s approval, such approval not to be unreasonably withheld, conditioned or delayed. Any changes to the Building Sign shall be at Tenant’s sole cost and expense. Upon the expiration or earlier termination of the Term of this Lease, and upon any event pursuant to which the Sign Conditions cease to prevail, Tenant shall remove each Building Sign (and all associated hardware) from the applicable Building and shall fill all holes and repair all damage caused by such removal and restore the affected area to a condition and appearance which is consistent with the finishes (e.g. paint) in close proximity to such area.
Building Services Labor Law Article 9 applies to Contracts for building service work over $1,500 with a public agency, that: (i) involve the care or maintenance of an existing building, or (ii) involve the transportation of office furniture or equipment to or from such building, or (iii) involve the transportation and delivery of fossil fuel to such building, and (iv) the principal purpose of which is to furnish services through use of building service employees.
Specification Changes Upon any change in the Product Specifications, stability protocols, QC laboratory methods raw material specification or Packaging Specifications (whether initiated by Horizon or made in response to a request by sanofi-aventis that is agreed to by Horizon), including the addition of new packaging configurations, new SKUs, new formulations, or a change in either raw materials or Packaging Component supply, Horizon shall promptly advise sanofi-aventis in writing of such changes, and sanofi-aventis shall promptly advise Horizon as to any scheduling and/or price adjustments which may result from such changes. Prior to implementation of such changes, the Parties shall negotiate in good faith in an attempt to reach agreement on (a) the new Product Price for any Product which embodies such changes, (b) any amounts to be reimbursed by Horizon to sanofi-aventis as described in the next sentence of this paragraph, and (c) any other amendments to this Agreement which may be necessitated by such changes (i.e., an adjustment to the lead time for purchase orders). Horizon shall reimburse sanofi-aventis for the mutually agreed upon reasonable expenses incurred by sanofi-aventis as a result of such changes, including, but not limited to, reimbursing sanofi-aventis for its mutually agreed validation and development costs, capital expenditure costs, costs for any Packaging Components or other materials rendered unusable as a result of such changes, and cost of required stability to support a change. If during the Term Horizon amends the Product Specifications or Packaging ***Confidential Treatment Requested MANUFACTURING AND SUPPLY AGREEMENT PAGE 7 Specifications (whether voluntarily or as required by law) so as to render obsolete quantities of the Active Ingredient, Excipients and/or Packaging Components for the Product on hand at sanofi-aventis, Horizon shall (i) accept the return of all such obsolete Active Ingredient and (ii) purchase from sanofi-aventis, at sanofi-aventis’ Acquisition Cost, all such obsolete Excipients and Packaging Components obtained by sanofi-aventis pursuant to its normal procurement policies to manufacture quantities of the Product pursuant to Horizon forecasts under Section 6.1. Sanofi-aventis’ normal procurement policies for purposes of the preceding sentence of this Article 5 shall be considered to be quantities of Excipients and Packaging Components corresponding to the immediately following […***…] months of Horizon’s most recent forecasted Product demand. If a change in Specifications is initiated by sanofi-aventis and approved by Horizon, any cost associated with said change shall be borne by sanofi-aventis. In the event that a change in Specifications is initiated by Horizon or driven by a regulatory or business change, the costs associated with qualification of the change shall be paid by Horizon. The amount of the change shall be reasonable and customary and subject to written approval by Horizon, such approval not to be unreasonably withheld. Sanofi-aventis, with written agreement and approval from Horizon, will be responsible for the appropriate (cGMP) destruction of any materials covered under this Article 5, and sanofi-aventis shall be reimbursed by Horizon at the reasonable and customary approved rate.
Tenant Improvement Plans Any work proposed by Tenant (the “Tenant Improvements”) shall be subject to Landlord’s reasonable prior approval and shall be subject to the other terms and conditions of this Exhibit C; provided that it will be reasonable for Landlord to withhold its approval or consent (as and when applicable under this Exhibit C) if Landlord’s Mortgagee has not consented to the matter that is the subject of such approval or consent. All architectural, engineering and other design fees shall be paid by Tenant. Tenant shall use its architect, engineers and other design professionals, all of whom shall comply with any applicable licensing or governmental requirements of the City of Seattle and the State of Washington; Tenant’s architect shall be approved by Landlord (“Tenant’s Architect”), which approval shall not be unreasonably withheld, conditioned or delayed. Landlord shall also be entitled to receive a copy of the agreement between Tenant and Tenant’s Architect (the “Architect Agreement”). Tenant shall cause Tenant’s Architect to prepare a draft space plan (the “Space Plan”) for the Tenant Improvements and shall submit the proposed Space Plan to Landlord for the latter’s approval (not to be unreasonably withheld) in a time period to allow Tenant to timely complete its Tenant Improvements under this Lease. Landlord shall deliver to Tenant any written objections, questions or comments of Landlord with regard to the Space Plan within ten (10) business days of receipt; Landlord’s consent thereto shall be deemed given if not denied in writing within said ten (10) business day period. If Landlord denies its approval, it shall specify the reasons for doing so in detail. Tenant shall cause the Space Plan to be revised to address such written comments and shall resubmit said Space Plan to Landlord for approval. Such process shall continue until Landlord has approved the Space Plan. Tenant’s Architect shall then prepare working drawings and specifications for the Tenant Improvements, including architectural, structural, plumbing, mechanical, electrical, and fire protection drawings as required, suitable for permit application (the “Working Drawings”) and shall submit the proposed Working Drawings to Landlord for the latter’s approval in a time period to allow Tenant to timely complete its Tenant Improvements under this Lease. The Space Plan and Working Drawings shall be subject to Landlord’s approval, which Landlord agrees shall not be unreasonably withheld, conditioned, or delayed. Landlord shall not be deemed to have acted unreasonably if it withholds its approval thereof because, in Landlord’s reasonable opinion, the work, as described in any such item: (i) is likely to adversely affect Building Systems, the structure of the Building or the safety of the Building and/or their occupants; (ii) might impair Landlord’s ability to furnish services to Tenant or other tenants in the Building; (iii) would materially increase the cost of operating the Building; (iv) would violate any governmental laws, rules or ordinances (or interpretations thereof); (v) contains or uses hazardous or toxic materials or substances; (vi) would negatively affect the appearance of the Building; (vii) is reasonably likely to adversely affect another tenant’s premises; or (viii) is prohibited by any ground lease affecting the Building or any mortgage, trust deed or other instrument encumbering the Building. Landlord shall deliver to Tenant any written objections, questions or comments of Landlord with regard to the Working Drawings, within ten (10) business days of Landlord’s receipt of the Working Drawings; Landlord’s consent thereto shall be deemed given if not denied in writing within said ten (10) business day period. If Landlord denies its approval, it shall specify the reasons for doing so in detail. Tenant shall cause the Working Drawings to be revised to address such written comments and shall resubmit said Working Drawings to Landlord for approval. Landlord may, when approving the Tenant Improvement Plans, elect to require Tenant to remove any Non-Standard Improvements which are made to the Premises. If Landlord so elects, Tenant shall, at its own cost, restore the Premises to the condition designated by Landlord in its election, before the last day of the Term. Such process shall continue until both parties have approved the Working Drawings. Landlord’s approval of the Space Plan and/or the Working Drawings shall not be deemed any representation or warranty that the same comply with applicable codes.
