COMPLIANCE AND CERTIFICATION 25.1 Each Party shall comply at its own expense with all Applicable Laws that relate to that Party’s obligations to the other Party under this Agreement. Nothing in this Agreement shall be construed as requiring or permitting either Party to contravene any mandatory requirement of Applicable Law.
Audits and Certifications The parties agree that the audits described in Clause 5(f) and Clause 12(2) of the Standard Contractual Clauses shall be carried out in accordance with the following specifications: Upon Customer’s request, and subject to the confidentiality obligations set forth in the Agreement, VTEX shall make available to Customer (or Customer’s independent, third-party auditor) information regarding the VTEX Group’s compliance with the obligations set forth in this DPA in the form of the third-party certifications and audits set forth in the Security Practices Data Sheet. Customer may contact VTEX to request an on-site audit of VTEX's procedures relevant to the protection of Personal Data, but only to the extent required under applicable Data Protection Law. Customer shall reimburse VTEX for any time expended for any such on-site audit at the VTEX Group’s then-current rates, which shall be made available to Customer upon request. Before the commencement of any such on-site audit, Customer and VTEX shall mutually agree upon the scope, timing, and duration of the audit and any measures to protect the security of third party personal data or VTEX confidential information, in addition to the reimbursement rate for which Customer shall be responsible. All reimbursement rates shall be reasonable, taking into account the resources expended by VTEX. Customer shall promptly notify VTEX with information regarding any non-compliance discovered during the course of an audit, and VTEX shall use commercially reasonable efforts to address any confirmed non-compliance.
Certification of Compliance The Owner may permit the use, prior to sampling and testing, of certain materials or assemblies when accompanied by manufacturer's certificates of compliance stating that such materials or assemblies fully comply with the requirements of the contract. The certificate shall be signed by the manufacturer. Each lot of such materials or assemblies delivered to the work must be accompanied by a certificate of compliance in which the lot is clearly identified. Materials or assemblies used on the basis of certificates of compliance may be sampled and tested at any time and if found not to be in conformity with contract requirements will be subject to rejection whether in place or not. The form and distribution of certificates of compliance shall be as approved by the Owner. When a material or assembly is specified by "brand name or equal" and the Contractor elects to furnish the specified "brand name", the Contractor shall be required to furnish the manufacturer's certificate of compliance for each lot of such material or assembly delivered to the work. Such certificate of compliance shall clearly identify each lot delivered and shall certify as to:
Compliance Requirements K. If using volunteers as provided for in this Contract during FY19, which encompasses the Contract term of July 1, 2019 to June 30, 2020, then the Grantee must either:
Warranty Affirmations Assurances and Certifications 3.01 Federal Assurances Performing Agency further certifies that, to the extent Federal Assurances are incorporated into the Contract under the Signature Document, the Federal Assurances have been reviewed and that Performing Agency is in compliance with each of the requirements reflected therein.
Quality Assurance Requirements There are no special Quality Assurance requirements under this Agreement.
Representations and Certifications The CNA shall assist the AbilityOne participating NPAs in the information gathering and filing of the NPAs’ Annual Representations and Certifications (AR&C) in accordance with 41 CFR §§ 51-3.2 and 3.6.