Condenser Sample Clauses

Condenser i. Clean the condenser after dismantling the nuts and bolts properly. ii. Use standard chemical or acid to remove the seal, mud and dust settled on the internal pipes and its pit too. iii. Replace the joint kit, if necessary, after dismantling and refitting.
AutoNDA by SimpleDocs
Condenser. Clean the condenser after dismantling the nuts and bolts properly.
Condenser. Seller shall provide either a conventional steam surface condenser or air cooled condenser (ACC) that meets the following operational requirements: The condenser shall be sized and designed to— Provide continuous operation at full steam load under all ambient conditions; Provide continuous operation with full steam turbine bypass under base load operating conditions without duct firing; Maintain condenser pressure within allowable operating limits with full steam turbine bypass under base load operating conditions with full duct firing, assuming duct-firing is discontinued at initiation of bypass operation. A steam surface condenser shall be designed for continuous operation based on a 85% cleanliness factor and in accordance with Heat Exchanger Institute (HEI) standards. Tubing shall be titanium with no tube gauge thinner than 24 gauge. Outer tubes shall be 18 gauge to protect inner tubes. Tube design shall consider vibration effects and tubes shall be properly and adequately supported. Tube sheets shall be titanium or titanium clad. All other condenser material shall be selected appropriately to match the Facility cooling water quality, i.e., fresh water, gray water and seawater. The condenser shall be of all-welded construction with bolts only permitted at access manholes, water boxes, and flanged expansion joints. Condenser shall be capable of absorbing the energy associated with operating continuously in the maximum steam bypass mode. The condenser shall be a single- or two-pass design, per Seller’s preference. The condenser shall be designed with the following features: Condenser tube leakage troughs Man-ways to water boxes, hotwell, and turbine exhaust hood (note: All man-way covers shall be marked and identified as “Confined Space Entries.) Air leakage meter Hogging and two 100% regular operation steam ejector or liquid ring vacuum pumps sized with capacity no less than specified by HEI Hotwell temperature indicator Armored hotwell level gauge glass Two 100% capacity liquid-ring vacuum pumps and related appurtenances as well as fully redundant steam hogging and holding systems adequately sized for start up and on line operation (including automated steam pressure control). One motor-operated vacuum breaker valve Over-pressurization rupture disc Water box cathodic protection – impressed current type (note: coal tar epoxy inside water box covers if necessary) Split condenser water boxes with inlet and outlet entry doors adequately sized and located f...
Condenser 

Related to Condenser

  • Electrical Provide drawings for the following systems: .1 Lighting including circuiting and luminaire identification and switching. Also provide illuminance computer printout for all indoor typical indoor spaces and parking lots. .2 Convenience outlets and circuiting, special outlets and circuiting, television outlets, and power systems and equipment. Provide riser diagrams for all electrical systems including master clock, intercom, fire alarm, ITV, computer networking/telephone. Also, provide for emergency and normal power distribution. Provide luminaire schedule. .3 Panel schedule may be in preliminary form but circuitry must be included. .4 Applicable installation details. .5 General legend and list of abbreviations. .6 Voltage drop computation for all main feeders. .7 Short circuit analysis .8 Provide 1/2" scale floor plan and wall elevations for all electrical rooms.

  • Heating The Hirer shall ensure that no unauthorised heating appliances shall be used on the premises when open to the public without the consent of the management committee. Portable Liquefied Propane Gas (LPG) heating appliances shall not be used.

  • Electric If Customer has selected an Electricity Fixed Rate on the Application, Customer’s Price will be based on the Fixed Rate(s) which includes Local and State taxes, Gross Receipts Tax (GRT), PJM Adjustment (defined below) charges and adjustments and Utility applied charges and/or fees related to generation, plus the Administration Charge, which includes, Electricity Balancing Amount and third party utility and billing charges.

  • Generators Temporary installation of generators, and permanent installation of generators that are placed inside existing non-residential buildings or that occupy an area under 50 square feet behind the building they serve.

  • HVAC Heating, ventilating and air conditioning.

  • Lighting A system of fixtures providing or controlling the light sources used on or near the airport or within the airport buildings. The field lighting includes all luminous signals, markers, floodlights, and illuminating devices used on or near the airport or to aid in the operation of aircraft landing at, taking off from, or taxiing on the airport surface.

  • Electricity 14.01 Tenant shall obtain electricity for the Demised Premises on a direct meter basis, Tenant shall be responsible for and pay to the applicable utility all charges for electricity as measured by such meter. Landlord shall not in any way be liable or responsible to Tenant for any loss or damage or expense which Tenant may sustain or incur if either the quantity or character of electric service is changed or is no longer available or suitable for Tenant’s requirements. Any additional riser or risers to supply Tenant’s electrical requirements, upon written request to Tenant, will be installed by Landlord, at the sole cost and expense of Tenant, unless, in Landlord’s reasonable judgment, the same will cause permanent damage or injury to the Building or the Demised Premises or cause or create a dangerous or hazardous condition or interfere with or disturb other tenants or occupants. In addition to the installation of such riser or risers, Landlord will also at the sole cost and expense of Tenant, install all other equipment proper and necessary in connection therewith subject to the aforesaid terms and conditions. Tenant covenants and agrees that at all times its use of electric current shall never exceed the capacity of the feeders to the Building or the risers or wiring installation which Landlord represents is sufficient for ordinary office use. It is further covenanted and agreed by the Tenant that all the aforesaid costs and expenses are chargeable and collectible as Additional Rent and shall be paid by the Tenant to the Landlord within ten (10) days after the rendering of any xxxx or statement to the Tenant therefor. Tenant shall make no alterations or additions to the electric equipment and/or appliances without the prior written consent of Landlord in each instance, which consent shall not be unreasonably withheld, conditioned or delayed. Notwithstanding anything to the contrary herein, should electric service be interrupted for a period of more than five (5) consecutive business days through the sole fault of Landlord so as to prevent Tenant from using at least seventy-five (75%) percent of the Demised Premises, Fixed Rent shall xxxxx until such service resumes and Tenant is able to resume the use of at least seventy-five (75%) percent of the Demised Premises. Should such service interruption prevent Tenant from using at least seventy-five (75%) of the Demised Premises for more than sixty (60) days and be due to the sole fault of Landlord, Tenant shall have the right to terminate this Lease by giving written notice to Landlord no later than the seventieth (70th) consecutive day and vacating no later than the ninetieth (90th) consecutive day. TIME BEING OF THE ESSENCE for Tenant as to both dates. 14.02 Tenant agrees not to connect any additional electrical equipment of any type to the Building electric distribution system, beyond that on Tenant’s approved plans for initial occupancy, other than lamps, computers and other small office machines which consume comparable amounts of electricity, without Landlord’s prior written consent, not to be unreasonably withheld, conditioned or delayed, in each instance. In no event shall Tenant use or install any fixtures, equipment or machines the use of which in conjunction with other fixtures, equipment and machines in the Demised Premises would result in an overload of the electrical circuits servicing the Demised Premises or the Building.

  • Water Provide hot water for lavatory purposes and cold water for drinking, lavatory and toilet purposes.

  • Fuel The Vehicle must be returned with the amount of fuel equal to that at the time of the commencement of the rental. If the Vehicle is returned with less fuel, the difference will be charged to You at a rate of $5.00 per litre (which includes a service component).

  • Ventilation Where noxious or poisonous gases may accumulate, the City shall provide proper protection and ventilation. Proper lighting and ventilation shall be provided for all enclosed working spaces. All work in enclosed and confined spaces shall be performed in accordance with applicable Federal, State and local regulations. Spray painting shall be done only by qualified painters.

Draft better contracts in just 5 minutes Get the weekly Law Insider newsletter packed with expert videos, webinars, ebooks, and more!