DRAWWORKS Sample Clauses

DRAWWORKS. One (1) Xxxxxx LTO-550 Single Drum CARRIER: Xxxxxx LTO-550 Self Propelled ENGINE: One (1) Detroit Series 60 MAST: One (1) Premco 112’, 300,000# Static Hook Load Mast w/(6) Sheave Crown and Racking Board, SUBSTRUCTURE: One (1) 10’H Box Type Substucture w/ Mud Boat Ramp 5’H x 30’L V-Door, Stairs & Safety Rails MUD PUMPS: Two (2) Xxxxxxx-Denver PZ-8 Triplex ENGINES: Two (2) (New) Detroit Series 60 GENERATORS: One (2) Detroit Series 60 Diesel Engines w/Marathon 350KW BLOCK / HOOK: One (1) XxXxxxxxx 150-Ton ROTARY TABLE: One (1) Xxxxxx 27-1/2” Rotary Table w/Master Bushing, SWIVEL: One (1) Xxxxxxx-Denver SW-200 200-Ton BOP RAMS: One (1) Xxxxxxxx 11’ 3000 PSI Double BOP ANNULAR: One (1) Xxxxxxxx 11” 3,000 PSI CHOKE MANIFOLD: 3,000 PSI MUD PITS: (New) 800 BBL SHALE SHAKER: (New) Xxxxxxx Linear Motion Shaker DESANDER: One (1) Mud Cleaner c/w 8 each Desilter Cones FUEL TANK: One (1) 6000 gallon WATER TANK: One (1) 280 bbl DOGHOUSE: One (1) Dog House 8’ x 8’ x 16’ DRILL PIPE: 6000 FT 4” E 14.40# DRILL COLLARS: (16) 6 1/2” MISCELLANEOUS: Pipe Spinner, Xxxxx Xxxxxxx, and Miscellaneous Handling Tools

DRAWWORKS. 3.1 Make UPETROM 3.2 Type TF-44-E 3.3 Max. intake power (HP) 3,000 3.4 Number of speeds 4 + 2 reverse 3.5 Max. single pull line capacity (tonnes) 44 w/ 12 lines; 38 w/ 10 lines 3.6 Hoisting drum grooved for line OD (in inch) 35 mm (1-3/8") 3.7 Drilling line guide (type) UPETROM 3.8 Make-up cathead (make) UPETROM 3.9 Break-out cathead (make) UPETROM 3.10 Low drum clutch (type) AD-2 950 3.11 Low drum clutch torque capacity (kgf) 2,900 3.12 High drum clutch (type) AVB 1120x300

DRAWWORKS. Make NOV Type SSGD 1,000-5,750 Motors make/type: Xxxxxx XX 628-TUT/ AC motor Quantity: no. 5 Maximun input power continuous: hp 5,750 Maximun output power intermittent: hp 5,750 Drum type: Xxxxx grooved Drum diameter: in 55 Drum Lenght in 82 Wire diameter: in 2 Maximum line pull 14 lines: lb 2,000,000 Maximum line pull 12 lines: lb 1,738,000 Spinning cathead type: None Breakout cathead type: NOV / Model CAR —P15-2 Hydraulic cathead — dual. Crown block safety device make/type: NOV-Hi-Tec integrated control system Independent fresh water cooling system for drawworks and electric brake: yes/no Drawworks lube oil cooling system and hydraulic brake cooling system.

DRAWWORKS. Make/type: Xxxxx model GH 4500 Motors make/type: GEB 22A2 / AC motor Quantity: no. no. 3 Rated input power continuous: hp hp 4500 hp Rated output power continuous: hp hp 1500 hp each Drum type: Xxxxx grooved Drum diameter: mm mm 1259mm Wire diameter: in in 2” Maximum line pull 16 lines: It It 1250 Ton (2,500,000 Ibs) Maximum line pull 14 lines: It It 1127 Ton (2,253,000 Ibs) Maximum line pull 12 lines: It It 1000 Ton (2,000,000 Ibs) Spinning cathead type: N/A Breakout cathead type: N/A Crown block safety device make/type: Xxxx Solutions Anti-collision system Independent fresh water cooling system for drawworks and electric brake: yes/no Yes

DRAWWORKS. One (1) Xxxxxx LTO-550 Single Drum CARRIER: Xxxxxx LTO-550 Self Propelled ENGINE: One (1) Detroit Series 60 MAST: One (1) Premco 112e, 300,000# Static Hook Load Mast w/(6) Sheave Crown and Racking Board,

DRAWWORKS. ● Prepare to open the front cover of the drawworks for a drum & brake systems inspection. ● Prepare to open the gearbox for an intrusive inspection of the transmission. ● Prepare and test the crown-o-matic, floor saver devices and anti-collision systems. ● Provide the following documents: - Major overhaul reports. - NDT inspection reports

DRAWWORKS. Make/Type : Dreco/Hitec Drum type : Xxxxx Grooving, 2” drill line Spinning cathead type : Refer D 2.1.7 Breakout cathead type : N/A Crown block safety device : YES Make : Model : Rated input power continuous hp: 6900 Rated input power maximum hp: 8400 Drum Diameter inches: 73.5 Maximum line pull 14 lines st: 1000 Maximum line pull 12 Lines Maximum line pull 10 lines st: 600 Maximum line pull 8 lines st: Independent fresh water cooling system for drawworks yes/no: yes

DRAWWORKS. National 1625-UDBE with disc brakes, nominal depth rating 30,000 feet a. Three

DRAWWORKS. Make/Type Main NOV AHD-1250-9000-70-100-10.5-FMM-NE-CLAC Motors make/type General Electric B28A3 AC Drilling Motor Quantity 6 Rated input power continuous N/A HP - KW Rated output power continuous 9,000 - 6,712 HP - KW Rated input power maximum N/A HP - KW Rated output power maximum 12,600 - 9,396 HP - KW Drum type The drum is mounted directly to the main drive shaft and is dynamically balanced; a two-piece removable Xxxxx grooving sleeve is bolted to the drum bottom and welded together. Drum diameter 70 - 1,778 Inches - mm Drill line diameter 2-1/8 Inches Maximum line pull 16 lines 1,250 - 1,134 (16 lines, 2nd layer) stons - mtons Maximum line pull 14 lines 1,094 - 992 (14 lines, 2nd layer) stons - mtons Maximum line pull 12 lines N/A stons - mtons Maximum line pull 10 lines N/A stons - mtons Maximum line pull 8 lines N/A stons - mtons Spinning cathead type N/A Breakout cathead type N/A Crown block safety device make/type The drawworks control system software includes dynamic floor and crown saver system (KEMS). Independent fresh water cooling system for drawworks and electric brake yes/no: Yes Make/Type Aux NOV AHD-750-5750-63-82-10.5-CLAC Motors make/type General Electric B22A3 AC Drilling Motor Quantity 5 Rated input power continuous N/A HP - KW Rated output power continuous 5,750 - 4,288 HP - KW Rated input power maximum N/A HP - KW Rated output power maximum 8,050 - 6,003 HP - KW Drum type The drum is mounted directly to the main drive shaft and is dynamically balanced, a two piece removable Xxxxx grooving sleeve is bolted to the drum bottom and weekend together. Drum Diameter 63 - 1,600 Inches - mm Wire diameter 1-3/4 Inches Maximum line pull 14 lines 750 - 680 (14 lines, 2nd layer) stons - mtons Maximum line pull 12 lines N/A stons - mtons Maximum line pull 10 lines N/A stons - mtons Maximum line pull 8 lines N/A stons - mtons Spinning cathead type N/A Breakout cathead type N/A Crown block safety device make/type The drawworks control system software includes dynamic floor and crown saver system (KEMS). Independent fresh water cooling system for drawworks and electric brake yes/no: Yes

DRAWWORKS. Make KREMCO Nominal Rating 900 hp Depth rating 10,500' (4 1/2 D.P.) Drilling Line 0-0/0" Xxxxxxxx XXX Xxxxx (2) CATERPILLAR 3408 Catheads VARCO Auxiliary Brake DRECO SR 23 Brake Cooling System Closed loop with antifreeze fluid Crown Saver Yes Automatic Driller NIL