EventID Sample Clauses

EventID. The EventID indicate a category of event that has happened at the unit. The final EventID’s must be defined by the seller and is to be coordinated with the warning list. It is important to group the detailed events on the Unit in the below mentioned EventID Range. EventID will be initiated in a Acting State (See white colored boxes at figure 6) and the EventID will stay on also in the Dual State (See green colored boxes at figure 6), and Wait States (See blue, orange and red colored boxes at figure 6). Category EventID Range Category description Predefined EventIDs OT 1-10 Operating Time OT covers on figure 7 Full production time, Quality loss and Speed loss EventID = 1; Unit is producing EventID = 2; Unit is producing with reduced speed (Optional, if available on unit) MF 11-20 Machine Failures – technical stops EventID = 11: Unit failure. The unit EventIDs in this group must be coordinated with error and warning list. The EventIDs can be group by unit construction elements. For example EventID=11: Infeed; EventID=12: Left side; EventID=13: Right side; EventID=14: Outfeed, etc. LF 21-30 Line Failure – externals stops EventID = 21; Unit is in saturation EventID = 22; Unit is in starvation. PF 31-40 Operator Failure EventID = 31; Operator related failures. ST 41-50 Setup time EventID = 41; Setup time and changeover time from one product to another. PRE 91-99 Preparation EventID = 91; Preparation time on the unit before startup after a short down. (Optional, if available on unit) CL 51-60 Cleaning, CIP, etc. EventID = 51; Unit clean mode is active. (Optional, if available on unit) EventID = 52; Unit is in CIP mode. (Optional, if available on unit) MA 61-70 Planned maintenance. EventID = 61; Unit maintenance mode is active. (Optional, if available on unit) RPD 71-80 Removable Planned Down time: Planned Breaks, meetings, waiting for orders, … EventID = 71; Operator Break. NWT 81-90 Non working time EventID = 81; Non working time (Optional, if available on unit) Table 11: EventID range defintion
AutoNDA by SimpleDocs

Related to EventID

  • Force Majeure If by reason of Force Majeure, either party hereto shall be rendered unable wholly or in part to carry out its obligations under this Agreement then such party shall give notice and full particulars of Force Majeure in writing to the other party within a reasonable time after occurrence of the event or cause relied upon, and the obligation of the party giving such notice, so far as it is affected by such Force Majeure, shall be suspended during the continuance of the inability then claimed, except as hereinafter provided, but for no longer period, and such party shall endeavor to remove or overcome such inability with all reasonable dispatch. Choice of Law The Agreement between the Vendor and TIPS/ESC Region 8 and any addenda or other additions resulting from this procurement process, however described, shall be governed by, construed and enforced in accordance with the laws of the State of Texas, regardless of any conflict of laws principles. Venue, Jurisdiction and Service of Process Any Proceeding arising out of or relating to this procurement process or any contract issued by TIPS resulting from or any contemplated transaction shall be brought in a court of competent jurisdiction in Camp County, Texas and each of the parties irrevocably submits to the exclusive jurisdiction of said court in any such proceeding, waives any objection it may now or hereafter have to venue or to convenience of forum, agrees that all claims in respect of the Proceeding shall be heard and determined only in any such court, and agrees not to bring any proceeding arising out of or relating to this procurement process or any contract resulting from or any contemplated transaction in any other court. The parties agree that either or both of them may file a copy of this paragraph with any court as written evidence of the knowing, voluntary and freely bargained for agreement between the parties irrevocably to waive any objections to venue or to convenience of forum. Process in any Proceeding referred to in the first sentence of this Section may be served on any party anywhere in the world. Venue for any dispute resolution process, other than litigation, between TIPS and the Vendor shall be located in Camp or Xxxxx County, Texas.

  • Scope of Services The specific scope of work for each job shall be determined in advance and in writing between TIPS Member, Member’s design professionals and Vendor. It is permitted for the TIPS Member to provide a general scope description, but the awarded vendor should provide a written scope of work, and if applicable, according to the TIPS Member’s design Professional as part of the proposal. Once the scope of the job is agreed to, the TIPS Member will issue a PO and/or an Agreement or Contract with the Job Order Contract Proposal referenced or as an attachment along with bond and any other special provisions agreed by the TIPS Member. If special terms and conditions other than those covered within this solicitation and awarded Agreements are required, they will be attached to the PO and/or an Agreement or Contract and shall take precedence over those in this base TIPS Vendor Agreement.

  • Safety Where an employee is prevented from working at the employee’s particular function as a result of unsafe conditions caused by the inclement weather, the employee may be transferred to other work in the employee’s classification on site, until the unsafe conditions are rectified. Where such alternative is not available and until the unsafe conditions are rectified, the employee shall remain on site. The employee shall be paid for such time without reduction of the employees’ inclement weather entitlement.

  • Probationary Period A new employee will be considered on probation until he has completed forty-five (45) days of work (or 337.5 hours of work for employees whose regular hours of work are other than the standard work day), within any twelve (12) calendar months. Upon completion of the probationary period he shall be credited with seniority equal to forty-five (45) working days. With the written consent of the Hospital, the probationary employee and the President of the Local Union or designate, such probationary period may be extended. Any extensions agreed to will be in writing and will specify the length of the extension. The release or discharge of an employee during the probationary period shall not be the subject of a grievance or arbitration.

  • Training a. The employer, in consultation with the local, shall be responsible for developing and implementing an ongoing harassment and sexual harassment awareness program for all employees. Where a program currently exists and meets the criteria listed in this agreement, such a program shall be deemed to satisfy the provisions of this article. This awareness program shall initially be for all employees and shall be scheduled at least once annually for all new employees to attend.

  • HEALTH AND SAFETY 16.01 The Employer, Union and the employees shall comply with the provisions of the Occupational Health and Safety Act where and when applicable. The Employer shall provide working conditions at all times which are not prejudicial to the health or efficiency of the workers. Employees are required to report to their Employer any unsafe work conditions, or violation of any safe work policies or procedures established by the Employer, or any violation of relevant safe work legislation.

  • GRIEVANCE PROCEDURE 7.01 For purposes of this Agreement, a grievance is defined as a difference arising between the parties relating to the interpretation, application, administration or alleged violation of the Agreement including any question as to whether a matter is arbitrable.

  • Dimensions Education Bachelor’s Degree in Computer Science, Information Systems, or a related field. Or equivalent work experience. Experience: A minimum of 3 years of IT work experience in production and operations support.

  • Bereavement Leave (a) Upon the death of an employee's spouse, spouse to include same sex partner, child or stepchild, an employee shall be granted leave up to a maximum of five (5) continuous calendar days without loss of pay. One of the days of leave shall include the day of the funeral or equivalent service. Additional days off with or without pay may be granted by the Employer. Part-time employees will be credited with seniority and service for all such leave. In the event of a delayed interment or ceremony for reason of religion or other protected grounds under the Ontario Human Rights Code, an Employee may save one of the days identified above without loss of pay to attend the interment or ceremony.

  • Default H-GAC may, by written notice of default to the Contractor, terminate the whole or any part of the Agreement, in any one of the following circumstances:

Time is Money Join Law Insider Premium to draft better contracts faster.