Flashing arrow signs, of the appropriate type per the "Manual of Traffic of Traffic Controls", latest edition, will be provided for all lane closures on all arterial highways and collector streets.
Flashing. Roof edges, projections through the roof and changes in roof planes shall be flashed. The seam between the flashing and the membrane shall be completed before the flashing is bonded to vertical surfaces. The seam shall be sealed a minimum of 3 inches beyond the fasteners which attach the membrane to nailers. The installed flashings shall be secured at the top of the flashing a maximum of 12 inches on centers under the counterflashing or cap. Where possible, prefabricated components shall be used for pipe seals and flashing accessories.
Flashing. ASTM A167, Xxx 000, xxal soft fully annealed, 0.015 in. unless greater thickness required.
Flashing. Galvanized steel sheet (minimum 0.33 mm thickness); Prefabricated flashing for plumbing and radon roof vent pipes to be P.V.C. conforming to CSA B272-93.
Flashing. Pre-finished brake formed sheet metal
1. Glass storefront on the ground level and glass curtain wall at center area of building on north and south facades beyond the roof line
Flashing. Fire Alarm Warning Lights" shall be installed at Xxxxx College in the cafeteria, B-259, and the Disabled Student's Center for the safety of hearing impaired students and staff.
20.8.1 Fire alarm and evacuation drill procedures shall be amended to include provisions for people in wheelchairs and other disabled people. Toward this end, a committee of three (3) represented staff from the Disabled Student's Center at Xxxxx College shall meet with the Risk Manager to draft recommendations.
Flashing your radio does not currently have access to a network. It is attempting to find a site it is authorised to use, or it may be out of range of a network signal. Off: your radio is in conventional mode.
Flashing. (32) “Warning Sign” means a sign device, located on permitted vehicle and escort vehicles, used to warn all approaching traffic of a possible safety hazard.
Flashing. 1 Where pipes or ducts go through a roof or wall, they should be boxed-in and flashed.
Flashing. 1. Fabricate of size required to install one step flashing per course of shingles, lapping each flashing 2 inches minimum and extending 2.5 inches onto roof surface and 2.5 inches up the wall.
2. Fabricate from the following material:
a. Aluminum: 0.012 inch thick Multi-Site Roof Replacement Project Village of Buffalo Grove IRS Project 18190 07 62 00 - 4 Sheet Metal Flashing and Trim Four (4) Separate Buildings
