Inspection of Meters. Each Meter shall be inspected annually and an inspection report shall be prepared at the conclusion of each inspection detailing the condition and accuracy of each Meter. Each inspection shall be performed by a representative of the manufacturer or other certified, competent entity agreeable to the Cooperative and the Project Participants and a copy of each inspection report shall be furnished to all Project Participants. Upon request of a Project Participant, the Cooperative shall make arrangements for a test of the Meter installed at the Project Participant’s Point of Connection by an independent testing entity. The Cooperative shall be responsible for selecting and engaging the independent testing entity. All costs and expenses shall be borne by the Project Participant requesting the test, unless the Meter is found to be inaccurate beyond the manufacturer’s guaranteed range of accuracy, in whichcase, the cost and expense of the test shall be borne by the Cooperative and such cost may not bepassed along to the Project Participant requesting the test, as part of the Water Charge.
Inspection of Meters. The Buyer shall be granted reasonable access during normal business hours to inspect or read the Measuring Equipment.
Inspection of Meters. All meters used to determine the billing hereunder shall be sealed and the seals shall be broken only upon occasions when the meters are to be inspected, tested or adjusted. Either Party shall have the right to inspect and test all meters upon their installation and in accordance with the ANSI standards regarding meter testing. Either Party may inspect or test a meter more frequently than required hereunder, and the expense of such inspection or test shall be borne equally by the Parties in accordance with the prevailing provisions and fees of applicable PUC regulations on meter testing. Such Party shall give reasonable notice to the other Party of the time when any inspection or test shall take place, and said other Party may have representatives present at the test or inspection. If any meter is found to be defective or operating outside the permissible tolerances, it shall be adjusted, calibrated, repaired or replaced by TU Electric, after Cogenron's concurrence, at Cogenron's expense. If a meter or other measuring equipment fails to register or, upon test, is found not to be within the accuracy standards established by the ANSI, an adjustment, mutually agreeable to the Parties, shall be made correcting all measurements made by such inaccurate meter or measuring equipment for:
Inspection of Meters. The Superintendent or such other person as may be authorized by the City shall have the right to enter and have free access to premises at all reasonable hours, for the purpose of conducting meter readings, and to inspect, maintain, repair or replace such meters.
