MEASUREMENT REQUIREMENTS Sample Clauses

MEASUREMENT REQUIREMENTS. All Delivery Points must have one Measurement Device installed that meets the following minimum requirements.
Sample 1Sample 2Sample 3See All (7)
AutoNDA by SimpleDocs
MEASUREMENT REQUIREMENTS. NDWR performs a yearly pumpage inventory for Nevada’s portion of the Lake Tahoe Basin based on the water year (October 1, 2018 through September 30, 2019). In order to gather annual inventory data, NDWR staff visit points of diversions, read meters, perform crop inventories, and gather and verify pumpage reporting from water purveyors, snowmaking operations, and public agencies per section 6.D.2.
Sample 1See All (4)
MEASUREMENT REQUIREMENTS. The following table lists the measurement requirements for the O2 sensor. These requirements should be maintained over the operating conditions described in Sec. 3.1. Partial Pressure of Oxygen(5) [*] [*] [*] mm Hg Measurement Accuracy(6) — — [*] % of reading Response Time(7) [*] [*] [*] ms
Sample 1Sample 2

Related to MEASUREMENT REQUIREMENTS

  • Project Requirements 1. Project must conform to regulations under 24 CFR Part 92, commonly known as the HOME Regulations.

  • Performance Requirements A. There is no guaranteed minimum amount of work which will be ordered under this Contract. B. The total Contract amount will not exceed $4,900,000. C. This is a Contract for work specified in individual Job Orders. Work ordered prior to but not completed by the expiration of the Contract period, and any additional work required as a result of unforeseen conditions encountered during construction up to six (6) months after the contract expiration date, will be completed with all provisions of this Contract still in force. Performance time for each Job Order issued under this Contract will be determined in accordance with the Contract. This performance time will be determined and agreed upon by both Parties for each individual Job Order. Contractor must self-perform 20% of the Work under this Contract for ‘A’ and ‘B’ licenses. Contractor must self-perform 75% of the Work under this Contract, unless otherwise approved by the County, for ‘C’ licenses. D. This is an indefinite-quantity Contract for the supplies or services specified and effective for the period stated. Work or performance shall be made only as authorized by Job Orders issued in accordance with the ordering procedures clause. The Contractor agrees to furnish to the County when and if ordered, the supplies or services specified in the Contract up to and including the quantity designated in the Job Orders issued as the maximum designated in the Contract.

  • Testing Requirements 12.1. Workplaces - 12.2. On workplaces where the value of the Commonwealth’s contribution to the project that includes the building work is at least $5,000,000, and represents at least 50% of the total construction project value or the Commonwealth’s contribution to the project that includes the building work is at least $10,000,000 (irrespective of its proportion of the total construction project value) the following minimum testing requirements must be adhered to.

Draft better contracts in just 5 minutes Get the weekly Law Insider newsletter packed with expert videos, webinars, ebooks, and more!