Power Supply and Distribution Sample Clauses

Power Supply and Distribution. The Employer provides access to the 220Vac power supply. Additional 24Vdc and 220Vac supplies for field equipment are needed to be specified by the Contractor, at tender stage. The Contractor is responsible for the cabling and installation of all power requirements. All permanent and temporary installations are subject to the statutory requirements as explained in SANS 10142-1:2012 for the wiring of premises, which includes the issuing of a certificate of compliance before the installation is commissioned or accepted by the Employer. The Contractor shall design, install, test and commission all the 220VAC and 24Vdc power cabling for the works. The design of the 220VAC and 24Vdc supply shall be subject to the Project Manager’s approval at the end of system engineering design.
Sample 1Sample 2Sample 3
AutoNDA by SimpleDocs
Power Supply and Distribution. The C&I power supply distribution is essential to the reliable operation of the overall C&I system. The reliability criterion of the power supply distribution shall be equal to that of the control system. This can be achieved by applying redundancy and functional distribution in the design. The power supply distribution design criterion is based primarily on the following requirements: • The power supply distribution to the C&I system shall be supplied from two independent sources with no common mode failure risk in order to support full redundancy e.g. supply A from board A and supply B from board B. • No single failure in the power supplies shall result in the loss of total functionality in the ashing system and hence a multiple unit trip. • Functional distribution should be maintained between power supplies so that any one failure will not cause a stopping of the ashing process.
Sample 1
Power Supply and Distribution a. Contractor shall be responsible for providing an electrical power and distribution system for each building composed of power and low voltage distribution panelboards, low voltage distribution transformers, conduits, fittings, wire and cable, terminations, light fixtures, etc. EXECUTION VERSION CONTRACT NUMBER 51008
Sample 1
Power Supply and Distribution. 1. An electrical power and distribution system shall be provided for each building composed of power and low voltage distribution panel boards, low voltage distribution transformers, conduits, fittings, wire and cable, terminations, light fixtures, etc.
Sample 1

Related to Power Supply and Distribution

  • Advisory Management and Distribution Arrangements 4.1 Advisory and Management Arrangements. Subject to the requirements of applicable law as in effect from time to time, the Trustees may in their discretion from time to time enter into advisory, administration or management contracts (including, in each case, one or more sub-advisory, sub-administration or sub-management contracts) whereby the other party to any such contract shall undertake to furnish the Trustees such advisory, administrative and management services, with respect to the Trust as the Trustees shall from time to time consider desirable and all upon such terms and conditions as the Trustees may in their discretion determine. Notwithstanding any provisions of this Declaration, the Trustees may authorize any advisor, administrator or manager (subject to such general or specific instructions as the Trustees may from time to time adopt) to effect investment transactions with respect to the assets on behalf of the Trustees to the full extent of the power of the Trustees to effect such transactions or may authorize any officer, employee or Trustee to effect such transactions pursuant to recommendations of any such advisor, administrator or manager (and all without further action by the Trustees). Any such investment transaction shall be deemed to have been authorized by all of the Trustees.

Time is Money Join Law Insider Premium to draft better contracts faster.