Process Analyzers and Analyzer Systems Sample Clauses

Process Analyzers and Analyzer Systems. All analyzers are to be completely piped, interconnected, and checked out for proper functional operating condition. Complex process stream analyzer systems shall be installed in a waterproof cabinet, enclosed house, or shelter. These shall include the following provisions: Enough working space shall be allowed for proper maintenance of the analyzers within the house. Analyzer houses and cabinets shall be of metal or fiberglass construction and equipped with a door, lock, and key. These enclosures shall be located as close to the process sample points as practical. More than one analyzer measuring and sample system may be installed in a single enclosure if the sample line length is within the analyzer manufacturer's specifications. All necessary calibration and operating gases shall be provided including gas cylinders and regulators. CEMS equipment shall be according to manufacturer’s recommendations. Analyzers requiring gases for continuous operation are to be provided with dual facilities for uninterrupted service. Calibration standards and facilities are to be supplied for zero and span check where specified. Protected outdoor storage racks adjacent to the analyzer houses shall be provided for the carrier and calibration gas cylinders (including inventory) and their associated regulators. Process sample regulators shall also be located on the outside of the analyzer houses. The sample systems are to be designed to deliver clean, representative samples to the analyzers at the proper temperatures, pressures, physical conditions, and flow rates. All wetted components are to be 316 stainless steel, or equivalent, unless other materials are required to minimize contamination and corrosion. Main line class pipe may be used in high temperature samples. Appropriate measures are to be taken to prevent plugging of sample lines due to freezing, condensation, or solids. Where sample recovery systems are required, provision for drains shall be made in the building design. Transportation time from sample point to analyzer is to be less than 2 minutes for chromatographs and less than 1 minute for other analyzer types. Fast circulating loops and/or bypass lines are to be used to achieve fast response times except where such a design would cause EPRI guidelines to be violated or sample composition to be changed. For gas samples, the pressure should be reduced at the sampling point to increase the velocity through the sample system and reduce time lag. Except in CEMS equ...
AutoNDA by SimpleDocs

Related to Process Analyzers and Analyzer Systems

  • SERVICE MONITORING, ANALYSES AND ORACLE SOFTWARE 11.1 We continuously monitor the Services to facilitate Oracle’s operation of the Services; to help resolve Your service requests; to detect and address threats to the functionality, security, integrity, and availability of the Services as well as any content, data, or applications in the Services; and to detect and address illegal acts or violations of the Acceptable Use Policy. Oracle monitoring tools do not collect or store any of Your Content residing in the Services, except as needed for such purposes. Oracle does not monitor, and does not address issues with, non-Oracle software provided by You or any of Your Users that is stored in, or run on or through, the Services. Information collected by Oracle monitoring tools (excluding Your Content) may also be used to assist in managing Oracle’s product and service portfolio, to help Oracle address deficiencies in its product and service offerings, and for license management purposes. 11.2 We may (i) compile statistical and other information related to the performance, operation and use of the Services, and (ii) use data from the Services in aggregated form for security and operations management, to create statistical analyses, and for research and development purposes (clauses i and ii are collectively referred to as “Service Analyses”). We may make Service Analyses publicly available; however, Service Analyses will not incorporate Your Content, Personal Data or Confidential Information in a form that could serve to identify You or any individual. We retain all intellectual property rights in Service Analyses. 11.3 We may provide You with the ability to obtain certain Oracle Software (as defined below) for use with the Services. If we provide Oracle Software to You and do not specify separate terms for such software, then such Oracle Software is provided as part of the Services and You have the non-exclusive, worldwide, limited right to use such Oracle Software, subject to the terms of this Agreement and Your order (except for separately licensed elements of the Oracle Software, which separately licensed elements are governed by the applicable separate terms), solely to facilitate Your use of the Services. You may allow Your Users to use the Oracle Software for this purpose, and You are responsible for their compliance with the license terms. Your right to use any Oracle Software will terminate upon the earlier of our notice (by web posting or otherwise) or the end of the Services associated with the Oracle Software. Notwithstanding the foregoing, if Oracle Software is licensed to You under separate terms, then Your use of such software is governed by the separate terms. Your right to use any part of the Oracle Software that is licensed under the separate terms is not restricted in any way by this Agreement.

  • Sampling and Analysis The Seller has sole responsibility for quality control of the coal and shall forward its “as loaded” quality to the Buyer as soon as possible. The sampling and analysis of the coal delivered hereunder shall be performed by Buyer and the results thereof shall be accepted and used for the quality and characteristics of the coal delivered under this Agreement. All analyses shall be made in Buyer’s laboratory at Buyer’s expense in accordance with ASTM standards where applicable, or using standards mutually acceptable to both parties. Samples for analyses shall be taken by any ASTM standards or standards mutually acceptable to both parties, and may be composited and shall be taken with a frequency and regularity sufficient to provide reasonably accurate representative samples of the deliveries made hereunder. Seller represents that it is familiar with Buyer’s sampling and analysis practices, and finds them to be acceptable. Buyer shall notify Seller in writing of any significant changes in Buyer’s sampling and analysis practices. Any such changes in Buyer’s sampling and analysis practices shall, except for ASTM or mutually agreeable changes in practices, provide for no less accuracy than the sampling and analysis practices existing at the time of the execution of this Agreement, unless the Parties otherwise mutually agree. (1) part shall be used for analysis by Buyer; one (l) part shall be used by Buyer as a check sample, if Buyer in its sole judgment determines it is necessary; one (1) part shall be retained by Buyer (LG&E) until the twenty-fifth (25th) of the month following the month of unloading (the “LG&E Disposal Date”) or Buyer (KU) until thirty (30) days after the sample is taken (the “KU Disposal Date”), the LG&E Disposal Date and the KU Disposal Date are collectively the “Disposal Date”), and shall be delivered to Seller for analysis if Seller so requests before the Disposal Date; and one part (“Referee Sample”) shall be retained by Buyer until the Disposal Date. Seller shall be given copies of all analyses made by Buyer by the tenth (10th) business day of the month following the month of unloading. Seller, on reasonable notice to Buyer shall have the right to have a representative present to observe the sampling and analyses performed by Buyer. Unless Seller requests a Referee Sample analysis before the Disposal Date, Buyer’s analysis shall be used to determine the quality of the coal delivered hereunder. The Monthly Weighted Averages shall be determined by utilizing the individual shipment analyses. If any dispute arises before the Disposal Date, the Referee Sample retained by Buyer shall be submitted for analysis to an independent commercial testing laboratory (“Independent Lab”) mutually chosen by Buyer and Seller. For each coal quality specification in question, a dispute shall be deemed not to exist and Buyer’s analysis shall prevail and the analysis of the Independent Lab shall be disregarded if the analysis of the Independent Lab differs from the analysis of Buyer by an amount equal to or less than: (i) 0.50% moisture (ii) 0.50% ash on a dry basis (iii) 100 Btu/lb. on a dry basis (iv) 0.10% sulfur on a dry basis. For each coal quality specification in question, if the analysis of the Independent Lab differs from the analysis of Buyer by an amount more than the amounts listed above, then the analysis of the Independent Lab shall prevail and Buyer’s analysis shall be disregarded. The cost of the analysis made by the Independent Lab shall be borne by Seller to the extent that Buyer’s analysis prevails and by Buyer to the extent that the analysis of the Independent Lab prevails.

  • Technology Research Analyst Job# 1810 General Characteristics

  • Risk Analysis The Custodian will provide the Fund with a Risk Analysis with respect to Securities Depositories operating in the countries listed in Appendix B. If the Custodian is unable to provide a Risk Analysis with respect to a particular Securities Depository, it will notify the Fund. If a new Securities Depository commences operation in one of the Appendix B countries, the Custodian will provide the Fund with a Risk Analysis in a reasonably practicable time after such Securities Depository becomes operational. If a new country is added to Appendix B, the Custodian will provide the Fund with a Risk Analysis with respect to each Securities Depository in that country within a reasonably practicable time after the addition of the country to Appendix B.

  • Technical Specifications The Technical Specifications furnished on the CD are intended to establish the standards for quality, performance and technical requirements for all labor, workmanship, material, methods and equipment necessary to complete the Work. When specifications and drawings are provided or referenced by the County, these are to be considered part of the Scope of Work, and to be specifically documented in the Detailed Scope of Work. For convenience, the County supplied specifications, if any, and the Technical Specifications furnished on the CD.

  • Quantitative Analysis Quantitative analysts develop and apply financial models designed to enable equity portfolio managers and fundamental analysts to screen potential and current investments, assess relative risk and enhance performance relative to benchmarks and peers. To the extent that such services are to be provided with respect to any Account which is a registered investment company, Categories 3, 4 and 5 above shall be treated as “investment advisory services” for purposes of Section 5(b) of the Agreement.”

  • Technology Upgrades Notwithstanding any other provision of this Agreement, Verizon shall have the right to deploy, upgrade, migrate and maintain its network at its discretion. The Parties acknowledge that Verizon, at its election, may deploy fiber throughout its network and that such fiber deployment may inhibit or facilitate PNG’s ability to provide service using certain technologies. Nothing in this Agreement shall limit Verizon's ability to modify its network through the incorporation of new equipment or software or otherwise. PNG shall be solely responsible for the cost and activities associated with accommodating such changes in its own network.

  • Technical Specifications and Drawings a) The Goods and Related Services supplied under this Contract shall conform to the technical specifications and standards mentioned in Section VI, Schedule of Requirements and, when no applicable standard is mentioned, the standard shall be equivalent or superior to the official standards whose application is appropriate to the Goods' country of origin. b) The Supplier shall be entitled to disclaim responsibility for any design, data, drawing, specification or other document, or any modification thereof provided or designed by or on behalf of the Procuring Entity, by giving a notice of such disclaimer to the Procuring Entity. c) Wherever references are made in the Contract to codes and standards in accordance with which it shall be executed, the edition or the revised version of such codes and standards shall be those specified in the Schedule of Requirements. During Contract execution, any changes in any such codes and standards shall be applied only after approval by the Procuring Entity and shall be treated in accordance with GCC Clause 33.

  • Research Analyst Independence The Company acknowledges that the Underwriters’ research analysts and research departments are required to be independent from their respective investment banking divisions and are subject to certain regulations and internal policies, and that such Underwriters’ research analysts may hold views and make statements or investment recommendations and/or publish research reports with respect to the Company and/or the offering that differ from the views of their respective investment banking divisions. The Company hereby waives and releases, to the fullest extent permitted by law, any claims that the Company may have against the Underwriters with respect to any conflict of interest that may arise from the fact that the views expressed by their independent research analysts and research departments may be different from or inconsistent with the views or advice communicated to the Company by such Underwriters’ investment banking divisions. The Company acknowledges that each of the Underwriters is a full service securities firm and as such from time to time, subject to applicable securities laws, may effect transactions for its own account or the account of its customers and hold long or short positions in debt or equity securities of the companies that may be the subject of the transactions contemplated by this Agreement.

  • Evaluation Software If the Software is an evaluation version or is provided to You for evaluation purposes, then, unless otherwise approved in writing by an authorized representative of Licensor, Your license to use the Software is limited solely for internal evaluation purposes in non-production use and in accordance with the terms of the evaluation offering under which You received the Software, and expires 90 days from installation (or such other period as may be indicated within the Software). Upon expiration of the evaluation period, You must discontinue use of the Software, return to an original state any actions performed by the Software, and delete the Software entirely from Your system and You may not download the Software again unless approved in writing by an authorized representative of Licensor. The Software may contain an automatic disabling mechanism that prevents its use after a certain period of time. RESTRICTIONS

Draft better contracts in just 5 minutes Get the weekly Law Insider newsletter packed with expert videos, webinars, ebooks, and more!