Safety Glasses 10.3.1 Where a teacher is considered to be working in an “eye danger” area, the teacher shall receive a personal issue of standard neutral safety glasses which shall remain the property of the employer.
Safety Orientation All employees shall be certified in Safety Orientation. Safety Orientation shall consist of three parts: PART 1 - the CODC Interactive Rights and Responsibilities course; PART 2 - the XXXX course or equivalent, and PART 3 - Employer or Owner Project Specific Training. It is the responsibility of each employee to hold current certification and maintain certification in part 1 and Part 2. The Employer or Owner shall provide to each Employee before commencing work with PART 3 - Employer or Owner Project Specific Training. Each Employee shall be on the payroll and paid while receiving PART 3 training. As a condition of employment it is the sole responsibility of each and every employee to obtain, hold and maintain all current certification(s) in any and all legislated safety training requirements (i.e. WHMIS, Fall Arrest, etc.) that are trade specific. Supporting documentation of all legislated training must be provided by the employee to the Union prior to dispatch and to the employer upon hire and may be further requested by the employer at any time during the duration of their employment. Prior to the expiration of any certification, the Employer will notify the Employee of the pending expiration and give the Employee reasonable time to renew their certification. Further, prior to arriving at site, employees shall hold current qualification(s) for the specific tasks and equipment identified in the dispatch request. If the employee has to be trained after dispatch, all costs borne by the Employer shall be reimbursed by the Training Fund. The CODC Harassment Policy and Procedures, including the provisions regarding General Harassment and as amended from time to time shall be the minimum standard of this Agreement.
Safety Boots Each employee, after 3 months’ continuous service, will be reimbursed (on production of a receipt), the cost of one pair of safety boots (approved by the employer), in each year, to a maximum of $110.00. Wet Weather All protective clothing such as wet weather jackets, safety helmets, welding jackets, welding xxxxxxx, welding gauntlets, rubber boots, etc, (which remain the property of the Company), will be supplied on all occasions deemed necessary.
Prescription Safety Glasses Prescription safety glasses will be furnished by the employer. The employer retains the authority to establish reasonable rules and procedures regarding frequency of issue, replacement of damaged glasses, limits on reimbursement costs and coordination with the employer's vision plan.
Training and Orientation (a) No employee shall be required to work on any job or operate any piece of equipment until he/she has received proper training and instruction.
Health and Safety Grievances A. It is the policy of the State employer to enforce safety and health, policies, procedures, and work practices and protect employees from harm in connection with State operations.
CONTRACT WORK HOURS AND SAFETY STANDARDS As per the Contract Work Hours and Safety Standards Act (40 U.S.C. 3701-3708), where applicable, all Customer Purchase Orders in excess of ,000 that involve the employment of mechanics or laborers must include a provision for compliance with 40 U.S.C. 3702 and 3704, as supplemented by Department of Labor regulations (29 CFR Part 5). Under 40 U.S.C. 3702 of the Act, each contractor must be required to compute the wages of every mechanic and laborer on the basis of a standard work week of 40 hours. Work in excess of the standard work week is permissible provided that the worker is compensated at a rate of not less than one and a half times the basic rate of pay for all hours worked in excess of 40 hours in the work week. The requirements of 40 U.S.C. 3704 are applicable to construction work and provide that no laborer or mechanic must be required to work in surroundings or under working conditions which are unsanitary, hazardous or dangerous. These requirements do not apply to the purchases of supplies or materials or articles ordinarily available on the open market, or contracts for transportation or transmission of intelligence.
Contractor Work Hours and Safety Standards Contractor shall ensure compliance with all safety and hourly requirements for employees, in accordance with federal, state, and County safety and health regulations and laws.
UNIFORMS AND SAFETY EQUIPMENT 214. For employees required by the Appointing Officer to wear a uniform, beginning in fiscal year 2006-2007 and continuing for the duration of this Agreement, the City agrees to provide a uniform allowance each year in the amount of eight hundred fifty dollars ($850). The City will pay the uniform allowance in the payroll that includes September 1 of each year. Represented employees must be on duty status or approved leave on each September 1 to be eligible for the uniform allowance. Any eligible employee hired on or after March 1 will receive fifty percent (50%) of the uniform allowance that year.
OCCUPATIONAL HEALTH AND SAFETY 47 22.1 Statutory Compliance 47 22.2 Occupational Health and Safety Committee 47 22.3 Unsafe Work Conditions 49 22.4 Investigation of Accidents 49 22.5 Occupational First Aid Requirements and Courses 49 22.6 Occupational Health and Safety Courses 50 22.7 Injury Pay Provisions 50 22.8 Transportation of Accident Victims 50 22.9 Working Hazards 51 22.10 Video Display Terminals 51 22.11 Safety Equipment 51 22.12 Dangerous Goods, Special Wastes and Pesticides & Harmful Substances 51 22.13 Communicable Diseases 51 22.14 Workplace Violence 51 22.15 Pollution Control 52 22.16 Working Conditions 52 22.17 Asbestos 52 22.18 Employee Safety Travelling to and from Work 52 22.19 Strain Injury Prevention 52 ARTICLE 23 - TECHNOLOGICAL CHANGE 53 23.1 Definition 53 23.2 Notice 53 23.3 Commencing Negotiations 53 23.4 Failure to Reach Agreement 53 23.5 Training Benefits 53 23.6 Transfer Arrangements 54 23.7 Severance Arrangements 54 ARTICLE 24 - CONTRACTING OUT 54 24.1 Contracting Out 54 24.2 Additional Limitation on Contracting Out 54 ARTICLE 25 - HEALTH AND WELFARE 55 25.1 Basic Medical Insurance 55 25.2 Benefit Entitlement for Part-Time Regular Employees 55 25.3 Extended Health Care Plan 55 25.4 Dental Plan 56 25.5 Group Life 56 25.6 Accidental Death and Dismemberment 56 25.7 Business Travel Accident Policy 57 25.8 WorkSafeBC Claim 57 25.9 Employment Insurance 57 25.10 Medical Examination 57 25.11 Legislative Changes 57 25.12 Employee and Family Assistance Program 57 (v) 25.13 Health and Welfare Plans 57 25.14 Designation of Spouse 58 ARTICLE 26 - WORK CLOTHING 58 26.1 Protective Clothing 58 26.2 Union Label 58 26.3 Uniforms 58 26.4 Maintenance of Clothing 58 26.5 Lockers 58
