Performance while Dispute is Pending Notwithstanding the existence of a dispute, the Supplier must continue without delay to carry out all of its responsibilities under the Contract that are not affected by the dispute. If the Supplier fails to continue without delay to perform its responsibilities under the Contract, in the accomplishment of all undisputed work, the Supplier will bear any additional costs incurred by Sourcewell and/or its Participating Entities as a result of such failure to proceed.
ADJUSTMENT OF DISPUTES The Employer and the Union recognize that grievances may arise in each of the following circumstances:
Settlement of Dispute The parties shall strive to settle any dispute arising from, out of or in connection with the interpretation or performance of this Agreement through friendly negotiation. In case no settlement can be reached through negotiation within six months, each party can submit such matter to China International Economic and Trade Arbitration Commission (the "CIETAC"). The arbitration shall follow the current rules of CIETAC. The arbitration award shall be final and binding upon the parties and shall be enforceable in accordance with its terms.
Settlement of Disputes between the contracting parties
1. Any dispute between the Contracting Parties concerning the interpretation or application of this Agreement shall, if possible, be settled through diplomatic channels.
2. If any dispute between the Contracting Parties cannot be settled within six months (6) It shall upon the request of either Contracting Party, be submitted to an arbitral tribunal.
3. Such an arbitral tribunal shall be constituted for each individual case in the following way. Within two (2) months of the receipt of the request for arbitration, each Contracting Party shall appoint one member of the Tribunal. The two members shall then select a national of a third State, who on approval by the two Contracting Parties shall be appointed Chairman of the Tribunal. The Chairman shall be appointed within two (2) months from the date of appointment of the other two members.
4. If within the periods specified in paragraph 3 of this article the necessary appointments have not been made, either Contracting Party may, in the absence of any other agreement, invite the President of the International Court of Justice to make the necessary appointments. If the President is a national of either Contracting Party or if he is otherwise prevented from discharging the said function, the Vice-President shall be invited to make the necessary appointments. if the Vice- President is a national of either Contracting Party or if he is also prevented from discharging the function, the said member of the International Court of Justice the oldest who is not a national of either Contracting Party shall be invited to make the necessary appointments.
5. The arbitral tribunal shall reach its decisions by a majority of votes and shall be binding on both contracting parties. each Contracting Party shall assume the costs of its own member of the Tribunal and of its representation in the arbitral proceedings; the cost of the Chairman and the remaining costs shall be borne in equal parts by the contracting parties. The Tribunal may, however, in its decision that a higher proportion of direct costs shall be borne by one of the two contracting parties, and this decision shall be binding on both contracting parties. the tribunal shall determine its own rules of procedure for all other matters.
6. The arbitral tribunal shall make its decision on the basis of this Agreement and any agreement in force between the two parties and international law in general and take into account, as appropriate, the domestic law of the Contracting Party where the investment concerned is located.
Contract Disputes The Parties shall deal in good faith and attempt to resolve potential disputes informally. If the dispute concerning a question of fact arising under the terms of this Contract is not disposed of in a reasonable period of time by the Contractor’s Supervisor and the County‘s project manager as specified in Article 25. Notices by way of the following process, such matter shall be brought to the attention of the County DPA by way of the following process:
i. The Contractor shall submit to the County DPA a written demand for a final decision regarding the disposition of any dispute between the Parties arising under, related to, or involving this Contract, unless the County, on its own initiative, has already rendered such a final decision.
ii. The Contractor’s written demand shall be fully supported by factual information, and, if such demand involves a cost adjustment to the Contract, the Contractor shall include with the demand a written statement signed by a senior official indicating that the demand is made in good faith, that the supporting data are accurate and complete, and that the amount requested accurately reflects the Contract adjustment for which the Contractor believes the County is liable.
iii. Pending the final resolution of any dispute arising under, related to, or involving this Contract, the Contractor agrees to diligently proceed with the performance of this Contract, including the delivery of goods and/or provision of services. The Contractor’s failure to diligently proceed shall be considered a material breach of this Contract. Any final decision of the County shall be expressly identified as such, shall be in writing, and shall be signed by the County DPA or his designee. If the County fails to render a decision within 90 days after receipt of the Contractor’s demand, it shall be deemed a final decision adverse to the Contractor’s contentions. The County’s final decision shall be conclusive and binding regarding the dispute unless the Contractor commences action in a court of competent jurisdiction to contest such decision within 90 days following the date of the County’s final decision or one year following the accrual of the cause of action, whichever is later.
GENERAL WORKING CONDITIONS Section 18-1. Employment begins and ends at each project site.
Section 18-2. The selection of craft foremen and/or general foremen and the number of foremen required shall be entirely the responsibility of the Employer, it being understood that in the selection of such foremen and/or general foremen the Employer will give primary consideration to the qualified individuals available in the local area. After giving such consideration, the Employer may select such individuals from other areas. All foremen shall take orders from the designated Employer representatives. Craft foremen shall be designated working foremen at the request of the Employer.
Section 18-3. There shall be no limit on production by employees nor restrictions on the full use of tools or equipment. Employees using tools shall perform any of the work of the trade and shall work under the direction of the craft foremen. There shall be no restrictions on efficient use of manpower other than as may be required by safety regulations.
Section 18-4. Employees shall be at their place of work at the starting time and shall remain at their place of work performing their assigned functions under the supervision of the Employer until quitting time. The parties reaffirm their policy of a fair day’s work for a fair day’s wage.
Section 18-5. All equipment assigned to a project shall be under the control of the Employer. The Employer shall have the right to determine how many pieces of equipment an individual employee shall operate. In an emergency, foremen shall operate any equipment assigned by the Employer, and there shall be no restriction on foremen in the use of the tools of his or her craft in such emergency. The foremen shall be from the craft normally operating the equipment. In accordance with currently recognized craft jurisdiction, the Employer shall determine the assignment of employees to start, stop, and maintain small portable construction equipment. Such work may be assigned to craft employees within a reasonable distance of their primary duties or an employee may be assigned full time to start, stop and maintain the Employer’s small, portable equipment on the job site. There shall be no over xxxxxxx of this type of equipment. The number of employees assigned to rigging and scaffolding operations shall be at the sole discretion of the Employer. The ratio of journeyperson to welders shall be determined solely by the Employer.
Section 18-6. The Employer may utilize the most efficient methods or techniques of construction, tools or other labor saving devices to accomplish the work. Practices not a part of the terms and conditions of this Agreement, stand by crews and feather bedding practices will not be recognized.
Section 18-7. It is recognized that specialized or unusual equipment may be installed and/ or serviced by individuals who have special training, skill, or qualifications and are not covered by this Agreement. Testing, inspection, or service performed on plant equipment under warranty may be performed by the vendor’s personnel.
Section 18-8. Neither the Union nor its local unions shall coerce or in any way interfere with the Owner’s personnel, operation or facilities at the plant site. The Owner’s right to contract directly with other companies for work at the plant site shall not be limited, and the Union shall cooperate and not interfere with the Employer’s operations.
Section 18-9. It is agreed that overtime is undesirable and not in the best interest of the industry or the employees; therefore, except in unusual circumstances, overtime will not be worked. Where unusual circumstances do exist, however, the Employer will have the right to assign specific employees and/or crews to perform such overtime work as is necessary to accomplish the job.
Section 18-10. There will be no rest periods, organized coffee breaks or other non-working time established during working hours.
Section 18-11. Individual seniority shall not be recognized or applied to employees working on projects under this Agreement.
Section 18-12. The Employer shall establish such reasonable project rules as the Employer deems appropriate. These rules will be reviewed at the pre-job conference and posted at the project site by the Employer, and may be amended thereafter as necessary.
Mediation of Disputes The parties shall endeavor in good faith to settle within 90 days any controversy or claim arising out of or relating to this Agreement or the breach thereof through mediation with JAMS, Endispute or similar organizations. If the controversy or claim is not resolved within 90 days, the parties shall be free to pursue other legal remedies in law or equity.
Calculation Disputes If the Defaulting Party disputes the Non-Defaulting Party’s calculation of the Settlement Amount or Termination Payment, in whole or in part, the Defaulting Party will, within two Business Days of receipt of Non-Defaulting Party’s calculation, provide to the Non- Defaulting Party a detailed written explanation of the basis for such dispute; provided, however, that the Defaulting Party must first transfer Performance Assurance to the Non-Defaulting Party in an amount equal to the full Settlement Amount or Termination Payment, as applicable. References to Defaulting Party and Non-Defaulting Party in this Section include the Potentially Defaulting Party and Potentially Non-Defaulting Party, as applicable.
Labour Disputes 15.01 If employees are prevented from performing their duties because of a strike or lock-out on the premises of another employer, the employees shall report the matter to the Employer, and the Employer will make reasonable efforts to ensure that such employees are employed elsewhere, so that they shall receive their regular pay and benefits to which they would normally be entitled.
Xxxxxxx Money Dispute Notwithstanding any termination of this Agreement, the Parties agree that in the event of any controversy regarding the release of the Xxxxxxx Money that the matter shall be submitted to mediation as provided in Section XXIII.
