Testing Standards. Tests of each Service provided on Seller’s Facilities shall be made to determine whether the Service complies with the following specifications:
(a) MPLS Network Solutions - The applicable Service will successfully meet the CoS Performance Objectives during the duration of the testing period at a rate of not less than 99% of CIR.
Testing Standards a. Employees will be required to take drug tests as part of any promotional physical examination required by this Department.
b. The Employer may order an employee to submit to a drug test when there is reasonable suspicion that the employee is or has been using illegal drugs or prescription drugs in violation of this policy.
c. An employee’s failure or refusal to submit to a drug test as directed by the Department or the alteration or substitution of a specimen shall be a violation of this drug testing policy and shall result in discipline up to, and including, discharge.
Testing Standards. Texas will test and turn-up the OC-3, OC-12, and/or OC-48 circuits to the applicable demarcation point per this Agreement. The tests will be performed per the applicable manufacturer's test specifications as it applies to the specific type of traffic hand- off. The system will also be tested for a long-term stability test running end-to-end for a period of 24 hours; Bit Error Rate (BER) performance shall be no greater than 10-(1)(1). Five (5) days prior to testing, Texas will notify Virginia verbally and in writing of Texas' intent to complete testing of the applicable circuit activation: Virginia will have the right but not the obligation to witness the activation testing. Copies of test results will be provided to Virginia upon completion of the activation tests. If Virginia is not present at time of testing, a copy of the test results will be forwarded to same. After Texas delivers circuits to PSINet, PSINet shall test same in accordance with the following criteria, and accept installation segments of IRU Capacity only after it meets the following: - Optical signal strength and other characteristics are within industry standards at each termination point as measured with appropriate test equipment. - Backup path verified by testing fault switching hardware applicable to the circuit being provided (test of 1:1 redundancy on the optronics). - Packet data passed with payload contents of 4500 bytes of all zeros for twelve hours registering frame/code violations or other bit errors at a rate not to exceed 10-(1)(1). - Packet data passed with payload contents of 4500 bytes of pseudo- random data patterns for twelve hours registering frame/code violations or other bit errors at a rate not to exceed 10-(1)(1). - Live production data passed for twelve hours registering frame/code violation or other bit errors at a rate not to exceed 10-(1)(1). - Each segment, regardless of capacity meets the applicable Bellcore specification, and equipment manufacturer's specification to the applicable demarcation point per this Agreement.
Testing Standards. Tests of each Service provided on Seller's Facilities shall be made to determine whether the Service complies with the following specifications:
a) Ethernet Private Line - The applicable Service will successfully pass 99% of the Ethernet frames during the duration of the testing period.
b) Ethernet Service -The applicable Service will successfully meet the Performance Objectives as outlined in Section 4.3 below during the duration of the testing period at a rate of not less than 99% of CIR.
Testing Standards. Test of each Service provided on Seller’s Facilities shall be made to determine whether the Service complies with the following specifications:
Testing Standards. Each Party will test, operate and maintain System Protection Facilities in accordance with Good Utility Practice.
Testing Standards. Conduct tests of electrical and mechanical equipment and appliances in accordance with recognized, applicable test codes.
Testing Standards. When a particular test to detect substances is used, the laboratory protocol shall follow the guidelines of the U.S. Human Health and Services Department in force at the time of the test.
Testing Standards. In order for Contractor to confirm that the sewage sludge biosolids provided by Client qualify as Qualified Wet Biosolids, Client shall provide Contractor with relevant information regarding the existing process/procedures associated with the production of dewatered biosolids including the addition of any additional materials (alum/polymer) or any known changes to the makeup of the biosolids or processes and procedures for the duration of the agreement.
Testing Standards. The Tribe's Testing Lab will perform the tests described in the Board rules when conducting testing for State Licensees.
