Cluster Development Standards Sample Clauses

Cluster Development Standards. Cluster development standards for the neighborhood shall be as follows (applies to both Single Family Detached and Cottage homes unless otherwise noted): Minimum Front yard setback: 10 feet to face of home, 20 feet to face of garage. Minimum Side yard setback: 5 feet Minimum Rear yard setback: 10 feet Minimum Exterior site setback: 10 feet Depictions showing a typical lot configuration for Single Family Detached and Cottage lots are attached hereto as Exhibits 5a and 5b, incorporated herein. Pervious surface: Minimum 70% of gross site area. No minimum requirements for pervious surfaces on individual lots. Impervious surface: Maximum 30% of gross site area. No maximum requirements for impervious surfaces on individual lots. The conceptual site plan (Exhibit 3) shows pervious surface measured at 1,595,161 sf (or 80% of gross site area) and impervious surface measured at 393,002 sf (or 20% of gross site area). Actual measurements at time of construction plan or final plat review shall be considered a minor amendment per Section 11. Minimum standard lot size: 3,500 sf Minimum cottage lot size: 2,000 sf Minimum lot width: None, except as indicated for corner lots in Section 2.c., Design Standards Building height: For Single Family Detached homes: 35 feet from the base of the structure, not to exceed 40 feet above the road centerline. Building height shall be shall be measured as described below. Measuring height: For Cottage homes: 22 feet from the base of the structure, not to exceed 25 feet above the road centerline. Building height shall be shall be measured as described below. Building height shall be measured from the average finished grade of a building footprint and from road centerline fronting the center of the lot to the midpoint of the highest xxxxx of a pitched or hipped roof with a minimum 4:12 pitch and a maximum of 12:12 pitch, or the highest point of the coping of a flat roof. All parts of the roof extending above the base building height shall be a minimum 4:12 pitch unless specifically excepted in section 18.07.060, B(4) of the City of Issaquah Municipal Code (“Code”). Gabled dormers may comprise no more than fifty (50) percent of the total roof area as measured in plan-view. No portion of a shed roof shall extend above the base building height limit. An architectural feature may not be used to measure or establish building height. A depiction showing building height determination for Single-Family Detached and Cottage homes is attached hereto...
Sample 1
AutoNDA by SimpleDocs

Related to Cluster Development Standards

  • Development Standards 9.1 Developer shall comply with the requirements contained in the Annexation Agreement and any other duly executed agreement related to the Property, except as specifically amended by this Agreement.

  • Procurement Standards For projects being managed by the Local Government and on the State highway system or that include state funding, the Local Government must obtain approval from the State for its proposed procurement procedure for the selection of a professional services provider, a contractor for a construction or maintenance project, or a materials provider.

  • Content Standards You agree that you will not upload or provide content or otherwise post, transmit, distribute, or disseminate through the Zelle® Payment Service any material that: (1) is false, misleading, unlawful, obscene, indecent, lewd, pornographic, defamatory, libelous, threatening, harassing, hateful, abusive, or inflammatory; (2) encourages conduct that would be considered a criminal offense or gives rise to civil liability; (3) breaches or infringes any duty toward or rights of any person or entity, including rights of publicity, privacy or intellectual property; (4) contains corrupted data or any other harmful, disruptive, or destructive files; (5) advertises products or services competitive with Zelle®, as determined by Zelle® in its sole discretion; or (6) in Zelle®’s or our sole judgment, is objectionable, restricts or inhibits any person or entity from using or enjoying any portion of the Zelle® Payment Service, or which may expose us, Zelle® or our respective affiliates or customers to harm or liability of any nature.

  • Quality Standards Each Party agrees that the nature and quality of its products and services supplied in connection with the other Party's Marks will conform to quality standards set by the other Party. Each Party agrees to supply the other Party, upon request, with a reasonable number of samples of any Materials publicly disseminated by such Party which utilize the other Party's Marks. Each Party will comply with all applicable laws, regulations, and customs and obtain any required government approvals pertaining to use of the other Party's marks.

  • Procurement and Property Management Standards The parties to this Agreement shall adhere to the procurement and property management standards established in 2 CFR 200, Uniform Administrative Requirements, Cost Principles, and Audit Requirements for Federal Awards, and to the Texas Uniform Grant Management Standards. The State must pre-approve the Local Government’s procurement procedures for purchases to be eligible for state or federal funds.

  • Development Plan document specifying the work program, schedule, and relevant investments required for the Development and the Production of a Discovery or set of Discoveries of Oil and Gas in the Contract Area, including its abandonment.

  • Development Schedule The Project shall substantially comply with the specific timetables and triggers for action set forth in Article 5 of this Agreement. The parties acknowledge that, as provided in G.S. 160A-400.25(b), the failure to meet a commencement or completion date shall not, in and of itself, constitute a material breach of this Agreement pursuant to G.S. 160A-400.27 but must be judged based upon the totality of the circumstances.

  • Development Plans 4.3.1 For each Licensed Indication and corresponding Licensed Product in the Field, Licensee will prepare and deliver to Licensor a development plan and budget (each a “Development Plan”). The initial Development Plans for each Licensed Indication will be delivered within […***…] after the Grant Date for such Licensed Indication.

  • PROFESSIONAL DEVELOPMENT AND EDUCATIONAL IMPROVEMENT A. The Board agrees to implement the following:

  • Design Development Phase Services 3.3.1 Based on the Owner’s approval of the Schematic Design Documents, and on the Owner’s authorization of any adjustments in the Project requirements and the budget for the Cost of the Work, the Architect shall prepare Design Development Documents for the Owner’s approval. The Design Development Documents shall illustrate and describe the development of the approved Schematic Design Documents and shall consist of drawings and other documents including plans, sections, elevations, typical construction details, and diagrammatic layouts of building systems to fix and describe the size and character of the Project as to architectural, structural, mechanical and electrical systems, and other appropriate elements. The Design Development Documents shall also include outline specifications that identify major materials and systems and establish, in general, their quality levels.

Draft better contracts in just 5 minutes Get the weekly Law Insider newsletter packed with expert videos, webinars, ebooks, and more!