INSPECTION AND PROTECTION OF WORK Sample Clauses

INSPECTION AND PROTECTION OF WORK. A. Contractor shall make the Work accessible at all reasonable times for inspection by the City. Contractor shall, at the first opportunity, inspect all material and equipment delivered to the jobsite by others to be used or incorporated in the Contractor's work and give prompt notice of any defect therein. Contractor assumes full responsibility to protect the work done hereunder until final acceptance by the City. B. When the Work is completed, Contractor shall request, in writing, a final inspection. Within ten (10) days of the receipt of such request, the City shall make a final inspection. The Contractor or its representatives may be present at the final inspection. The purpose of such final inspection shall be to determine whether the Work has been completed in accordance with the Contract Documents, including all change orders and all interpretations and instructions previously issued.
Sample 1Sample 2Sample 3See All (14)
AutoNDA by SimpleDocs
INSPECTION AND PROTECTION OF WORK. Subcontractor shall make the Work accessible at all reasonable times for inspection by the Contractor. Subcontractor shall make every reasonable effort to facilitate any and all issuance of permits and conduct of inspections by governmental agencies including, but not limited to, city, county and state building inspectors, and Subcontractor will take no action that will hinder or delay issuance of permits or inspections, including, but not limited to, inspections necessary to obtaining the Certificate of Occupancy. Subcontractor shall, at the first opportunity, inspect all material and equipment delivered to the job site by others to be used or incorporated in the Subcontractor’s Work and give prompt notice of any defect therein. Subcontractor assumes full responsibility to protect the Work until final acceptance by the Owner and Contractor, respectively. Subcontractor shall clean up all rubbish and debris each day and shall remove the same from the premises. Subcontractor shall clean any walkways, roads, streets, floors, walls and other finished surfaces that may become soiled as a result of its activities. Subcontractor shall protect the Work by lights, barriers, supports and guards, so as to avoid injury or damage to persons and property. Subcontractor shall be directly responsible for any negligence in its performance of the Work.
Sample 1Sample 2
INSPECTION AND PROTECTION OF WORK. 12.1 Should performance of the work hereunder depend upon performance of other work, Subcontractor shall carefully examine all contiguous or dependent work, determine whether it is suitable for performance of the work hereunder, report immediately any unsuitable conditions to Contractor in writing, and allow Contractor reasonable time to have such unsuitable conditions remedied. Unless Subcontractor reports such unsuitable conditions, Subcontractor shall be deemed to have accepted dependent work as adequate for the completion of the work. 12.2 Subcontractor shall make the work accessible at all times for inspection by the Contractor. Subcontractor shall, at the first opportunity, inspect all material and equipment delivered to the job site by others to be used or incorporated in the Subcontractor’s work and give prompt notice of any defect therein. Subcontractor assumes full responsibility to protect the work done hereunder until final acceptance by the Architect, Owner, Prime Contractor and Contractor.
Sample 1Sample 2
INSPECTION AND PROTECTION OF WORK. Subcontractor shall take necessary precautions to properly protect the work of Contractor and other subcontractors from damage caused by operations under this Subcontract. Subcontractor shall cooperate with Contractor and other subcontractors. Subcontractor shall participate in the preparation of coordinated drawings in areas of congestion specifically noting and advising Contractor of potential conflicts between the Work of Subcontractor and that of the Contractor and other subcontractors.
Sample 1Sample 2
INSPECTION AND PROTECTION OF WORK. A. Responsibility for, and security of, all work and materials is the responsibility of the Contractor until final acceptance of the Project by CVWD. B. All Work shall be inspected by CVWD. The charges for inspection shall be in accordance with CVWD’s regulations. If CVWD is unable to provide an inspector or inspectors, Contractor shall reschedule the Work for another time at no cost to CVWD. Work performed without inspection shall be rejected. C. Contractor shall make the work accessible at all reasonable times for inspection by CVWD. Contractor shall, at the first opportunity, inspect all material and equipment delivered to the jobsite by others to be used or incorporated in the Contractor's work and give prompt notice of any defect therein. Contractor assumes full responsibility to protect the work done hereunder until final acceptance by CVWD. D. When the Work is completed, Contractor shall request, in writing, a final inspection. Within ten (10) days of the receipt of such request, CVWD shall make a final inspection. The Contractor or its representatives may be present at the final inspection. The purpose of such final inspection shall be to determine whether the Work has been completed in accordance with the Contract Documents, including all change orders and all interpretations and instructions previously issued. E. CVWD may reject materials or Work that does not meet the requirements of the Contract Documents. If CVWD does so, Contractor shall promptly remove the rejected materials or work and replace it with materials or work that meet the requirements of the Contract Documents, at no additional cost to CVWD.
Sample 1
INSPECTION AND PROTECTION OF WORK. Subcontractor shall make the work accessible at all reasonable times for inspection by the Contractor. Subcontractor shall, at the first opportunity, inspect all material and equipment delivered to the job site by others to be used or incorporated in the Subcontractor's work and give prompt notice of any defect therein. Subcontractor assumes full responsibility to protect the work done hereunder until final acceptance by the Architect, Owner and Contractor.
Sample 1
INSPECTION AND PROTECTION OF WORK. Subcontractor shall make the Work accessible at all reasonable times for inspection by the Contractor. Subcontractor shall make every reasonable effort to facilitate any and all issuance of permits and conduct of inspections by governmental agencies including, but not limited to, city, county and state building inspectors, and Subcontractor will take no action that will hinder or delay issuance of permits or inspections, including, but not limited to, inspections necessary to obtaining the Certificate of Occupancy. Subcontractor shall, at the first opportunity, inspect all material and equipment delivered to the job site by others to be used or incorporated in the Subcontractor’s Work and give prompt notice of any defect therein. Subcontractor assumes full responsibility to protect the Work until final acceptance by the Owner and Contractor, respectively.
Sample 1
AutoNDA by SimpleDocs
INSPECTION AND PROTECTION OF WORK. Subcontractor shall make its work done pursuant to the herein subcontract accessible at all reasonable times for inspection by Contractor. Subcontractor shall, at the first opportunity, inspect all material and equipment delivered to the jobsite by others to be used or incorporated in Subcontractor’s work and give prompt notice of any defect therein to Contractor within two (business days. Subcontractor shall effectually secure and protect its work done hereunder and assumes full responsibility for the condition thereof until final acceptance by Architect, Owner and Contractor. Subcontractor further agrees to take such measures and provide such protection as is necessary to protect the work and the workmen of Contractor, Owner and other subcontractors from its operations. Subcontractor shall be liable for any loss or damage to any work in place or to any equipment and materials on the job site caused by it or its agents, employees or guests.
Sample 1

Related to INSPECTION AND PROTECTION OF WORK

  • Inspection of Work It is FIRST PARTY's obligation to make the work product available for CITY's inspections and periodic reviews upon request by CITY.

  • PROTECTION OF WORK AND PROPERTY Contractor shall erect and properly maintain at all times, as required by conditions and progress of the Work, all necessary safeguards, signs, barriers, lights, and security persons for protection of workers and the public, and shall post danger signs warning against hazards created by the Work. In an emergency affecting life and safety of life or of Work or of adjoining property, Contractor, without special instruction or authorization from District, is permitted to act at his discretion to prevent such threatened loss or injury.

  • PROTECTION OF WORK 12.1 Subcontractor shall effectually secure and protect the work done hereunder and assume full responsibility for the condition thereof until final acceptance by the OWNER and Contractor. Subcontractor further agrees to provide such protection as is necessary to protect the work and the workmen of Contractor, the OWNER, and other subcontractors from its operations. 12.2 Subcontractor shall be liable for any loss or damage to any work in place or to any equipment and materials on the job site caused by Subcontractor or its agents, employees or guests.

  • Preservation, Maintenance, and Protection of the Property Inspections. Borrower will not destroy, damage, or impair the Property, allow the Property to deteriorate, or commit waste on the Property. Whether or not Borrower is residing in the Property, Borrower must maintain the Property in order to prevent the Property from deteriorating or decreasing in value due to its condition. Unless Lender determines pursuant to Section 5 that repair or restoration is not economically feasible, Borrower will promptly repair the Property if damaged to avoid further deterioration or damage. If insurance or condemnation proceeds are paid to Lender in connection with damage to, or the taking of, the Property, Borrower will be responsible for repairing or restoring the Property only if Xxxxxx has released proceeds for such purposes. Lender may disburse proceeds for the repairs and restoration in a single payment or in a series of progress payments as the work is completed, depending on the size of the repair or restoration, the terms of the repair agreement, and whether Borrower is in Default on the Loan. Lender may make such disbursements directly to Borrower, to the person repairing or restoring the Property, or payable jointly to both. If the insurance or condemnation proceeds are not sufficient to repair or restore the Property, Borrower remains obligated to complete such repair or restoration. Lender may make reasonable entries upon and inspections of the Property. If Lender has reasonable cause, Xxxxxx may inspect the interior of the improvements on the Property. Lender will give Borrower notice at the time of or prior to such an interior inspection specifying such reasonable cause.

  • Inspection of Agreement A copy of this Agreement shall be available at all reasonable times at the principal corporate trust office of the Warrant Agent for inspection by the holder of any Warrant Certificate. The Warrant Agent may require such holder to submit his Warrant Certificate for inspection by it.

  • Uncovering and Correction of Work 12.1 The Contractor shall promptly correct Work rejected by the Owner or failing to conform to the requirements of the Contract Documents, whether observed before or after Substantial Completion and whether or not fabricated, installed or completed, and shall correct any Work found to be not in accordance with the requirements of the Contract Documents within a period of two years from the date of Substantial Completion, or by terms of an applicable special warranty required by the Contract Documents. The provisions of this Article apply to work done by Subcontractors as well as to Work done by direct employees of the Contractor. 12.2 At any time during the progress of the work, or in any case where the nature of the defects shall be such that it is not expedient to have them corrected, the Owner, at their option, shall have the right to deduct such sum, or sums, of money from the amount of the contract as they consider justified to adjust the difference in value between the defective work and that required under contract including any damage to the structure.

  • Installation and Use Rights You may install and use any number of copies of the software on your devices.

  • CORRECTION OF WORK 13.2.1 The Contractor shall be responsible for correcting all Work which the Architect has found to be defective or which fails to conform to the Contract Documents whether observed be- fore or after Substantial Completion and whether or not fabricated, installed or completed. The Contractor shall bear all costs of correcting such rejected Work, including compensation for the Architect's and the State’s additional services made necessary thereby. 13.2.2 If, within one year after the Date of Substantial Completion of the Work or designated portion thereof or within one year after acceptance by the State of designated equipment or within such longer period of time as may be prescribed by law or by the terms of any applicable special warranty required by the Contract Documents, any of the Work is found to be defective or not in accordance with the Contract Documents, the Contractor shall correct it promptly after receipt of a written notice from the State to do so unless the State has previously given the Contractor a written acceptance of such condition. This obligation shall survive termination of the Contract. The State shall give such notice promptly after discovery of the condition. 13.2.3 The Contractor shall remove from the site all portions of the Work which are defective or non-conforming and which have not been corrected under Subparagraphs 4.5.1, 13.2.1 and 13.2.4 If the Contractor fails to correct defective or nonconforming Work as provided in Subparagraphs 4.5.1, 13.2.1 and 13.2.2, the State may correct it in accordance with Paragraph 13.2.5 If the Contractor does not proceed with the correction of such defective or non- conforming Work within a reasonable time fixed by written notice from the Architect, the State may remove it and may store the materials or equipment at the expense of the Contractor. If the Contractor does not pay the cost of such removal and storage within ten days thereafter, the State may upon ten additional days written notice sell such Work at auction or at private sale and shall account for the net proceeds thereof, after deducting all the costs that should have been borne by the Contractor, including compensation for the Architect's and the State’s additional services and expenses made necessary thereby. If such proceeds of sale do not cover all costs which the Contractor should have borne, the difference shall be charged to the Contractor and an appropriate Change Order shall be issued. If the payments then or thereafter due the Contractor are not sufficient to cover such amount, the Contractor shall pay the difference to the State. 13.2.6 The Contractor shall bear the cost of making good all work of the State or separate contractors destroyed or damaged by such correction or removal. 13.2.7 Nothing contained in this Paragraph 13.2 shall be construed to establish a period of limitation with respect to any other obligation which the Contractor might have under the

  • Installation and Use You may install and use the Software only for the number of licenses acquired by you. In order to exercise your rights to the Software under this Agreement, you must activate your copy of the Software in the manner described during the launch sequence.

  • Inspection and Tests 3.8.1 The Procuring entity or its representative shall have the right to inspect and/or to test the goods to confirm their conformity to the Contract specifications. The Procuring entity shall notify the tenderer in writing in a timely manner, of the identity of any representatives retained for these purposes. 3.8.2 The inspections and tests may be conducted in the premises of the tenderer or its subcontractor(s), at point of delivery, and/or at the Goods’ final destination If conducted on the premises of the tenderer or its subcontractor(s), all reasonable facilities and assistance, including access to drawings and production data, shall be furnished to the inspectors at no charge to the Procuring entity. 3.8.3 Should any inspected or tested goods fail to conform to the Specifications, the Procuring entity may reject the equipment, and the tenderer shall either replace the rejected equipment or make alterations necessary to make specification requirements free of costs to the Procuring entity. 3.8.4 The Procuring entity’s right to inspect, test and where necessary, reject the goods after the Goods’ arrival shall in no way be limited or waived by reason of the equipment having previously been inspected, tested and passed by the Procuring entity or its representative prior to the equipment delivery. 3.8.5 Nothing in paragraph 3.8 shall in any way release the tenderer from any warranty or other obligations under this Contract.

Draft better contracts in just 5 minutes Get the weekly Law Insider newsletter packed with expert videos, webinars, ebooks, and more!