Lesson Plans The parties agree that instruction requires thoughtful preparation. The development of lesson plans by and for the teacher is a professional responsibility. However, a teacher’s planning and preparation may be different based on personal style, professional needs, student needs and experience in the classroom. Plans are to be used as a guide to fulfill the state standards and District’s instructional objectives for student achievement. Plans should include strategies and accommodations for students with disabilities, and English Language Learners, if needed. Remediation and enrichment and the type of progress monitoring should be included, if needed. As such, administrators shall not require that lesson plans be in a particular format. Administrators also shall not require the posting or storage of lesson plans in a particular place or manner. A principal or principal’s designee may request teachers to submit a copy of their lesson plans at the end of the teaching week or at the end of a particular unit. The teacher’s plans are to be used as a guide in order to fulfill the county’s instructional objectives and to assist the teacher in conducting a planned instructional program. Current lesson plans shall be available in the classroom for inspection at all times. Teachers shall not be routinely required to submit a copy of their lesson plans to the site administrator unless required by Article 6.9-2.
6.9-1 In the event a teacher is absent, it shall be the teacher’s responsibility to have lesson plans at the school prior to the start of the pupil day to cover the period of absence not to exceed the balance of the week in which the absence occurred.
6.9-2 If the principal or their designee, through documented classroom observation, determines that a teacher is having difficulty with classroom instruction or is not meeting instructional objectives, the principal shall hold a conference with the teacher having difficulty. The principal may require lesson plans to be turned in at the start of each week if the teacher is in one of the following categories:
a) Category I teacher as defined in Article 15: or
b) The teacher is on an Instructional Assistance Conference (IAC) or on a Professional Development Plan (PDP); or
c) The teacher holds an average rating of Needs Improvement or Unsatisfactory on their last overall summative evaluation; or
d) Educational Emergency as outlined in Article XXXI – Board’s Rights per Section 1012.28(8), Florida Statutes.
Erosion Prevention and Control Purchaser’s Operations shall be conducted reasonably to minimize soil erosion. Equipment shall not be operated when ground conditions are such that excessive damage will result. Purchaser shall adjust the kinds and intensity of erosion control work done to ground and weather condi- tions and the need for controlling runoff. Erosion control work shall be kept current immediately preceding ex- pected seasonal periods of precipitation or runoff.
XXXREAS the Trust is registered under the Investment Company Act of 1940, as amended, (the "1940 Act") as an open-end, series management investment company; and
Laboratory Testing All laboratories selected by UPS Freight for analyzing Controlled Substances Testing will be HHS certified.
Preventive cleaning (periodontal cleaning in the presence of inflamed gums is considered to be a Basic Benefit for payment purposes), topical application of fluoride solutions, space maintainers.
As-Built Plans Within thirty (30) days after completion of Tenant’s Changes requiring the submission of plans to Landlord, Tenant shall furnish to Landlord a complete set of “as-built” plans and specifications.
Fire Extinguishers Provide UL-listed extinguishers, cabinets and accessories from a single manufacturer such as X.X. Industries or Xxxxxx’x Manufacturing Company that comply with local fire marshal approval.
12.1 Systems Furnishings: Systems furnishings will be supplied and installed by the State. It will be the Lessor’s responsibility to complete the electrical connections from the building electrical grid to the power connections or power poles for the system furnishings (see Division 16, Electrical).
Irrigation An irrigation reduced pressure zone (hereinafter referred to as “RPZ”) is required for any irrigation systems and must be installed by the Developer and/or eventual lot owner and tested in accordance with the Minnesota Department of Health Guidelines for Designing Backflow Prevention Assembly Installations (hereinafter referred to as “Guidelines”). The initial test results and certification shall be submitted to the City of Maple Grove Public Works Department. Subsequently, the RPZ must be tested, per the Guidelines, at least annually by a certified tester with the results reported to the City of Maple Grove Building Department and the RPZ must be rebuilt as needed in accordance with the Guidelines. Test/rebuilt reports shall be mailed or faxed to the City of Maple Grove Building Department at (000) 000-0000. The irrigation system shall be designed, and the Plans shall be modified accordingly, prior to the issuance of any permits for the development of the Property, to accommodate a 1-inch water meter and a maximum flow of 50 gallons per minute.
Preventive Care This plan covers preventive care as described below. “
Heating, Ventilation and Air Conditioning Landlord shall furnish to the Premises heating, ventilation and air-conditioning (“HVAC”) in accordance with the Design Standards set forth in Exhibit D during Ordinary Business Hours. Landlord shall have access to all air-cooling, fan, ventilating and machine rooms and electrical closets and all other mechanical installations of Landlord (collectively, “Mechanical Installations”), and Tenant shall not construct partitions or other obstructions which may interfere with Landlord’s access thereto or the moving of Landlord’s equipment to and from the Mechanical Installations. No Tenant Party shall at any time enter the Mechanical Installations or tamper with, adjust, or otherwise affect such Mechanical Installations. Landlord shall not be responsible if the HVAC System fails to provide cooled or heated air, as the case may be, to the Premises in accordance with the Design Standards by reason of (i) any equipment installed by, for or on behalf of Tenant, which has an electrical load in excess of the average electrical load and human occupancy factors for the HVAC System as designed, or (ii) any rearrangement of partitioning or other Alterations made or performed by, for or on behalf of Tenant. Tenant shall install, if missing, blinds or shades on all windows, which blinds and shades shall be subject to Landlord’s approval, and shall keep operable windows in the Premises closed, and lower the blinds when necessary because of the sun’s position, whenever the HVAC System is in operation or as and when required by any Requirement. Tenant shall cooperate with Landlord and shall abide by the rules and regulations which Landlord may reasonably prescribe for the proper functioning and protection of the HVAC System. Tenant acknowledges that the server room in the Premises currently has three heat pumps installed, being two 4-ton units, and one 2.5-ton unit (the “Existing Heat Pumps”). The 2.5-ton unit is currently connected and operational. Tenant shall determine whether it is satisfied with the condition of the Existing Heat Pumps and Landlord shall not have any responsibility or liability for the condition, operation, maintenance, repair or replacement of the Existing Heat Pumps. Tenant may operate the Existing Heat Pumps. Tenant shall be responsible for, and pay directly for, all necessary maintenance and repairs to the Existing Heat Pumps. Tenant shall reimburse Landlord monthly for the cost of all utility services used to operate the Existing Heat Pumps within 10 Business Days after receipt of Landlord’s invoice for such amount. Landlord may measure Tenant’s usage of such utility services by either a sub-meter or by other reasonable methods such as by temporary check meters or by survey. Tenant, at its cost, may replace the Existing Heat Pumps with one or more new heat pumps, provided, however, that the capacity of such replacement heat pump(s) shall not exceed the 10.5-ton capacity cooling capacity of the Existing Heat Pumps.
