Plywood. TS-531 The minimum thickness shall be 5mm. TS-532 Plywood face veneers shall be approved by the Managing Official. TS-533 Plywood adhesives shall be approved by the Managing Official. TS-534 The Contractor shall not be permitted to make up the required thickness by gluing together sheets of thinner plywood.
Plywood. The plywood in general shall be conforming to PWD Specifications for cupboard shutters the specified ply should be urea bonded whereas for flush doors shutters the specified ply to be used shall be phenol bonded only. The plywood should be termite proof and water proof.
Plywood. Plywood for general purpose shall confirm ISI 303 - 1975. It shall be of B.W.R. grade in the specified thickness for the commercial type B.W.R. grade plywood, formed with
Plywood. The plywood shall be from a manufacturing source approved by the Architect and shall comply in all respects with the requirements of B.S. 66566. Grade 1 veneer plywood shall be used visible surface is to be wax polished, varnished, plastic lacquered or left untreated. Grade 2 veneer plywood shall be used where subsequent painting is intended. All plywood shall be WBP bonded, and of marine quality when specified. Routine tests will be required from time to time to check the quality of plywood manufacture. Specification Carpentry and Joinery (2/M/4) M.13 Chipboard Chipboard shall comply with B.S. 5669
Plywood. A. Plywood shall be the following:
1. Plywood sheathing over masonry substrate shall be Grade A-C, exterior marine grade, minimum five-eighths inch (⅝”) thick, except where otherwise indicated.
2. New plywood deck shall be DOC PS 1, three-quarter inch (¾”) thickness. Factory mark panels according to indicated standard.
B. Plywood shall not be pressure treated. Plywood shall have maximum moisture content of fifteen percent (15%) by weight on a dry weight basis.
C. All plywood shall have grade stamps; plywood from contaminated areas will not be accepted.
Plywood. 1. For unexposed concrete and basic forms: Xxxxxxx Fir; Exterior Grade C‐C or better.
2. For exposed concrete: Xxxxxxx Fir Plyform, Exterior Class 1; B‐B wood face or high density overlay sheet (HDO).
Plywood. A. Comply with U.S. Department of Commerce Product Standard PS 1-74. Grade and grade-mark by the Engineered Wood Association.
B. Use the galvanized variety of bolts, nuts, and washers, in compliance with ASTM A153, in locations subject to moisture, outside, in portions of the structure that are not completely enclosed, or as indicated elsewhere.
Plywood. Plywood for general purpose shall confirm I.S. 303-1975 It shall be of B.W.R. grade the specified thickness for commercial type B.W.R. grade plywood formed with 0.8mm. th. commercial face veneers and 1.5mm th. Intermediate veneers in two opposite grain direction shall be 1:1. The moisture content shall not be more than 12.5% by mass. It shall either be of Mafatlal, Kitply make or other equivalent approved make. Where B.W.P. grade is specified it should be boiling water proof confirming to I.S. standards.
Plywood. Plywood for veneer of solid core and hollow core flush doors shall be 3-ply, rotary cut, 6mm thick ordinary plywood, Class B grade. Marine or waterproof plywood, rotary cut, 3-ply, 6 mm thick shall be used for flush doors at toilets and bathrooms or at places where these are exposed to moisture.
Plywood. Plywood shall be manufactured to comply with B.S. 1455 (Grades 1 or 2, Type INT for "interior work"; type WBP for "exterior work"). Marine plywood shall comply with B.S. 1088.
