Company's Liability The Consultant agrees to defend, indemnify, and hold the Company harmless from an against any and all reasonable costs, expenses and liability (including reasonable attorney's fees paid in defense of the Company) which may in any way result pursuant to its gross negligence or willful misconduct or in any connection with any actions taken or statements made, on behalf of the Company, without the prior approval or authorization of the Company or which are otherwise in violation of applicable law.
Your Liability The following determines your liability for any unauthorized EFT or any series of related unauthorized EFTs:
1. If you notify the Credit Union within two (2) business days after your password was lost or stolen, your liability will not exceed $50.00 or the amount of the unauthorized EFTs that occur before notification, whichever is less.
2. If you fail to notify the Credit Union within two (2) business days after your password was lost or stolen, your liability will not exceed the lesser of $500.00or the total of: • $50.00 or the amount of unauthorized EFTs that occur within the two (2) business days; and • The total of authorized EFTs which occur during the two (2) days before notification to the Credit Union, provided the Credit Union establishes that these EFTs would not have occurred had the Credit Union been notified within that two-day period.
3. You must report an unauthorized EFT that appears on your periodic statement, no later than 60 days of transmittal of the statement to avoid liability for subsequent transfers; your liability will not exceed the amount of the unauthorized EFTs that occurred within the 60-day period. You may also be liable for the amounts as described in sections 1 and 2 above.
4. If the report is made orally, we will require that you send the complaint or question in writing within 20 business days. We will notify you with the results of the investigation within 10 business days and will correct any error promptly. If more time is needed, however, we may take up to 45 days to investigate a complaint or question. If this occurs, we will credit your account within 10 business days for the amount you think is in error. This will allow you to use the money during the time it takes us to complete out investigation. If your complaint or question is not received in writing within 10 business days, we may not credit your account until the investigation is completed. If an alleged error involves an electronic fund transfer outside a state or territory or possession of the United Stated, the applicable time periods for action by us are 20 business days (instead of 10) and 90 calendar days (instead of 45). If we determine that no error occurred, we will send you a written explanation within three business days after the investigation is complete. You may request copies of the documents that were used in the investigation.
5. You may notify the Credit Union by telephone, writing, or by email using the guest book provided in our online banking site. Notification by general e-mail to report an unauthorized transaction is not secure and therefore not advised.
Products Liability (a) Except as set forth on Schedule 3.25, (i) there is no Action before any Governmental Entity pending, or to the Knowledge of the Seller, threatened against the Company involving any products manufactured, produced, distributed or sold by or on behalf of the Company and/or in connection with the Business (including any parts or components) (collectively, “Products”), or class of claims or lawsuits involving the same or similar Product which is pending or, to the Seller’s Knowledge, threatened, resulting from an alleged defect in design, manufacture, materials or workmanship of any Product, or any alleged failure to warn, or from any breach of implied warranties or representations (collectively, “Product Liability Lawsuits”); (ii) there has not been, within the past 12 months, any Occurrence (as hereinafter defined); and (iii) there has not been, within the past 12 months, any Product rework or retrofit (collectively, “Retrofits”) conducted by or on behalf of the Company.
(b) For purposes of this Section 3.25, the term “Occurrence” shall mean any accident, happening or event which takes place at any time which is caused or allegedly caused by any alleged hazard or alleged defect in manufacture, design, materials or workmanship including, without limitation, any alleged failure to warn or any breach of express or implied warranties or representations with respect to, or any such accident, happening or event otherwise involving any Product that can reasonably be expected to result in a claim or loss.
(c) Except as set forth on Schedule 3.25, to the Seller’s Knowledge, each Product manufactured, sold, leased, or delivered by the Company and the Business has been in conformity with all applicable material contractual commitments and all express and implied warranties, and the Company and the Business have no Liability (and there is no basis for any present or future proceeding against any of them giving rise to any Liability) for replacement or repair thereof or other damages in connection therewith. No Product manufactured, sold, leased, or delivered by the Company and the Business is subject to any guaranty, warranty, or other indemnity beyond the applicable standard terms and conditions of sale or lease. Schedule 3.25 includes copies of the standard terms and conditions of sale or lease for the Company and the Business (containing applicable guaranty, warranty, and indemnity provisions). Except as set forth on Schedule 3.25, the Seller and the Business have no obligation to any person to maintain, modify, improve or upgrade any of the Products.
(d) Except as set forth on Schedule 3.25, to the Seller’s Knowledge, the Company and the Business have no material Liability (and there is no basis for any present or future proceeding against any the Company and the Business giving rise to any material Liability) arising out of any injury to individuals or property as a result of the ownership, possession, or use of any Product manufactured, sold, leased, or delivered by the Company and the Business.
Umbrella Liability The Umbrella / Excess Liability must be at least as broad as the underlying general liability and automobile liability policies. Limits – Each Occurrence $1,000,000 General Aggregate $1,000,000
Civil Liability If an action or proceeding is brought against any employee or former employee covered by this Agreement for an alleged tort committed by him in the performance of his duties, then:
Our Liability (a) The quality and reliability of your electricity supply and the quality, pressure and continuity of your gas supply is subject to a variety of factors that are beyond our control as your retailer, including accidents, emergencies, weather conditions, vandalism, system demand, the technical limitations of the distribution system and the acts of other persons (such as your distributor), including at the direction of a relevant authority.
(b) To the extent permitted by law, we give no condition, warranty or undertaking, and we make no representation to you, about the condition or suitability of energy, its quality, fitness for purpose or safety, other than those set out in this contract.
(c) Unless we have acted in bad faith or negligently, the National Energy Retail Law excludes our liability for any loss or damage you suffer as a result of the total or partial failure to supply energy to your premises, which includes any loss or damage you suffer as a result of the defective supply of energy.
Cross-Liability All required liability policies shall provide cross-liability coverage as would be achieve under the standard ISO separation of insureds clause.
Advisor’s Liability The Advisor shall have responsibility for the accuracy and completeness (and liability for the lack thereof) of the statements in each Fund’s offering materials (including the prospectus, the statement of additional information, and advertising and sales materials), except for information supplied by the co-administrators or the Trust or another third party for inclusion therein. The Advisor will not be liable for any error of judgment or mistake of law or for any loss suffered by Advisor or by the Trust in connection with the performance of this Agreement, except a loss resulting from a breach of fiduciary duty with respect to the receipt of compensation for services or a loss resulting from willful misfeasance, bad faith or gross negligence on its part in the performance of its duties or from reckless disregard by it of its duties under this Agreement.
Defects Liability 9.1 In this Contract, and subject to Clause 9.2, a defect shall mean any non-conformity of the Supplies with the express terms of this Contract resulting from circumstances existing in the Supplies at the time of the transfer of risk to the Customer (“Defects”).
9.2 In particular, the following shall not be Defects:
a) normal wear and tear, non-conformity resulting from excessive strain,
b) non-conformity resulting from faulty or negligent handling; non-compliance with instructions or recommendations in operation or maintenance manuals and other documents;
c) installation, erection, modification, commissioning, or pre-commissioning, in each case not carried out by Xxxxxxx,
d) non-reproducible software errors,
e) defects which do not significantly impair the use of the respective Supplies.
9.3 The Customer shall immediately inspect the Supplies upon delivery and shall notify Flender in writing of any Defects without undue delay. The Customer’s claims in respect of defects shall be excluded for any apparent defects if the Customer has failed to do so. Upon such written notification, Flender shall, at its option, remedy a Defect by repair, replacement, or re-performance. Flender shall be given a reasonable period of time and opportunity to remedy the Defect. For this purpose, the Customer shall xxxxx Xxxxxxx working access to the non- conforming Supplies, shall undertake any necessary dis-assembly and re-assembly, and shall provide access to operation and maintenance data, all at no charge to Flender. Upon Flender’s request, the Customer shall ensure that the title to the replaced parts/items shall pass to Flender.
9.4 Unless otherwise agreed, the defects liability period for any part of the Supplies is 12 months. It starts at the date of transfer of risk. For replaced or repaired parts of the Supplies, the defects liability period is 6 months from the date of replacement or repair, if the original defects liability period for the Supplies expires earlier. In any event, the defects liability period shall end no later than 24 months from the beginning of the original defects liability period.
9.5 If software is defective, Flender shall only be obliged to provide the Customer with an updated version of the software in which the Defect has been remedied when such updated version is reasonably available from Flender or, if Flender is only licensee, from Flender’s licensor. If the software has been modified or individually developed by Flender, Flender shall in addition provide the Customer with a workaround or other interim corrective solution until the provision of an updated version of the software, if such workaround or interim solution is feasible at reasonable expense and if otherwise the Customer’s business operations would be substantially impeded.
9.6 If Flender carries out remedial work and it is ultimately not established that there was a Defect, the Customer shall pay Flender for such remedial work including error diagnosis.
9.7 Any other liability of Flender and rights and remedies of the Customer in case of defects of the Supplies, other than those expressly stipulated in this Clause 9 or , in case Flender failed at least three times in remedying the defect, in Clause 15.2b) shall be excluded. All warranties, representations, conditions, and all other terms of any kind whatsoever implied by statute or law are, to the fullest extent permitted by applicable law, excluded from this Contract.
Contractor’s Liability By requiring insurance, the State and DCYF do not represent that the coverage and limits specified will be adequate to protect Contractor. Such coverage and limits shall not limit Contractor’s liability under the terms and conditions of this Contract.
