Vehicle speed Sample Clauses

Vehicle speed. The TPMS shall be calibrated and tested for vehicles of category M1 up to a maximum mass of 3,500 kg and N1: (a) In a speed range from forty km/h and 120 km/h or the vehicle's maximum design speed if it is less than 120 km/h for the puncture test to verify the requirements of paragraph 5.2. to this Regulation; and (b) In a speed range from forty km/h and 100 km/h or the vehicle's maximum design speed if it is less than 100 km/h for the diffusion test to verify the requirements of paragraph 5.3 to this Regulation and for the malfunction test to verify the requirements of paragraph 5.4. to this Regulation. The TPMS shall be calibrated and tested for vehicles of categories X0, X0, X0, X0, O3 and O4: (c) In a speed range from 30 km/h and 90 km/h (or the vehicle's maximum design speed if it is less than 90 km/h) for the puncture test to verify the requirements of paragraph 5.2. to this Regulation; and (d) In a speed range from 30 km/h and 90 km/h (or the vehicle's maximum design speed if it is less than 90 km/h) for the diffusion test to verify the requirements of paragraph 5.3 to this Regulation and for the malfunction test to verify the requirements of paragraph 5.4. to this Regulation. The whole speed range shall be covered during the test. For vehicles equipped with cruise control, the cruise control shall not be engaged during testing.
Vehicle speed. During dredging and dewatering activities, the contractor shall ensure that on-site vehicle speed shall be limited to 15 miles per hour. Contract specifications shall be included in the proposed Project construction documents, which shall be reviewed by the San Diego Water Board prior to the issuance of construction permits. The San Diego Water Board shall verify implementation of this measure. Dredge area Compliance monitoring Contractor, as verified by the San Diego Water Board During dredging operations
Vehicle speed. The TPMS shall be calibrated and tested: (a) In a speed range from forty km/h and 120 km/h or the vehicle's maximum design speed if it is less than 120 km/h for the puncture test to verify the requirements of paragraph 5.2. to this Regulation; and (b) In a speed range from forty km/h and 100 km for the diffusion test to verify the requirements of paragraph 5.3 to this Regulation and for the malfunction test to verify the requirements of paragraph 5.4. to this Regulation. The whole speed range shall be covered during the test. For vehicles equipped with cruise control, the cruise control shall not be engaged during testing.
Vehicle speed. Contractor shall at all times operate sweepers at no more than five (5) miles per hour, unless it can be demonstrated to satisfaction of City Contract Manager that the specified quality of service can be safely accomplished at a higher speed.
Vehicle speed. The TPMS shall be calibrated and tested: (a) In a speed range from 40 km/h and 120 km/h or the vehicle's maximum design speed if it is less than 120 km/h for the puncture test to verify the requirements of paragraph 5.
Vehicle speed. The vehicle shall be capable of reaching and maintaining a maximum speed of no less than 2.5 miles per hour on a hard dry level surface. Control of the vehicle speed between zero and the maximum speed shall be continuously variable. The vehicle shall meet the speed specification while carrying a 10 pound payload that is located as close as possible to the center of gravity of the vehicle. The capability to reach and maintain a maximum speed of 5 miles per hour is desired.
Vehicle speed. No vehicle, except emergency vehicles, shall exceed fifteen (15) miles per hour on any aircraft ramp area.
Vehicle speed. The maximum speed shall be limited to 59.9 MPH due to the rear gear ratio of 6.14 An engine scan providing the gear ratio information shall be provided.
Vehicle speed. The speed of the vehicle shall at all times be consistent with the safety of the passengers and shall at no time exceed the posted speed limit or as set forth in the minimum standards of the Bureau of Traffic Safety, PennDot, as promulgated from the Vehicle Code.

Related to Vehicle speed

  • Vehicle Use 5.2.1 Each Lessee may use Lease Vehicles leased hereunder in connection with its car rental business, including use by such Lessee’s and its subsidiaries’ employees, directors, officers, agents, representatives and other business associates in their personal or professional capacities, subject to Sub-Clause 6.1 (

  • Vehicle Allowance Vehicle allowances for all distances travelled on Employer business shall be paid to employees required to use their own vehicles in the performance of their duties. Ownership of a vehicle shall not be a condition of employment. Vehicle allowance shall be thirty-seven cents (37¢) per kilometre.

  • Vehicle Maintenance 16.1 You must report to thl as soon as possible, where the oil is above or below the recommended level or the warning indication light is illuminated. 16.2 You must add water/coolant to the cooling system and an appropriate Australian Society of Automotive Engineers rated oil for petrol or diesel powered vehicles (as applicable) to the engine if the indicator level is below minimum. 16.3 You agree to maintain the Vehicle in these conditions and acknowledge that any mechanical damage occasioned as a result of Your failure to maintain the Vehicle in accordance with this clause must be paid by You.

  • Motor Vehicle Allowance 5.1.1 Employees required by their employer to use their own vehicles for school business shall be paid an allowance of $0.62 per kilometre.