Weekly OM&M Sample Clauses

Weekly OM&M. When directed and upon receipt of prior written authorization of the OC Waste & Recycling Project Manager (or designee), the Prima LFGES flare/blower station shall be monitored on a once per week basis. The data obtained shall be evaluated, and any modifications, adjustments, or recommendations shall be reported to the OC Waste & Recycling Project Manager or designee by the end of the site visit, or immediately, should it be warranted. Monitoring data for the following must be recorded on a weekly basis and reported to the OC Waste & Recycling Project Manager (PM) or designee prior to departing the site: • Date, time and signature of monitoring technician; • Monitoring instrument ID and daily calibration log for the instrument; • LFGES Operating hours/day (i.e. 24hr/day, 7am-1pm, etc.); • Meteorological conditions (e.g., barometric pressure, ambient temperature, etc.); • LFGES flare station inlet header static pressure; • Knockout Vessel inlet and outlet static pressures and calculated pressure drop across the demister pad; • Operating Air compressor(s), Blower(s) and Flare(s) ID; • Extraction blower(s) operating (inlet and outlet) temperatures and static pressures; • Pressure drop across the operating extraction blower(s); • Operating flare(s) inlet LFG concentrations of methane, oxygen, carbon dioxide, hydrogen sulfide and carbon monoxide; LFG temperature, pilot tube measurement, static pressure, and inside diameter of pipe where these measurements were taken (for back-up flow rate calculations); • Flame arrestor inlet and outlet static pressures and calculated pressure drop across the flame arrestors of the operating flare(s); • Compliance thermocouple selected location (i.e. top, middle, bottom, etc.); • Operating flare(s) operating temperature and operating temperature set points; • Operating flare(s) high and low temperature shutdown set points; • Operating Flare(s) LFG flow rate (utilizing the permanently installed flow meter); • Condensate injection flow rate (where applicable); and • Approximate amount of condensate in the flare station condensate holding tank(s). • Perform field measurements of xxxxx as directed by PM or designee. • Perform field measurements of perimeter probes as directed by PM. This data shall be recorded on a monitoring form tailored specifically for the site (Required format will be provided by the County).
Sample 1
AutoNDA by SimpleDocs

Related to Weekly OM&M

  • Weekly Overtime An Employee required to work in excess of forty (40) hours per week shall be paid at the rate of time and one-half (1 1/2) for the first eight (8) hours of work in excess of the forty (40) hours and double time thereafter.

  • Business Day Convention If the date on which any payment is due to be made under this Agreement shall occur on a day on which is not a Business Day, such payment shall be made in accordance with the Business Day Convention as specified in the Notes or the Indenture.

  • How are Required Minimum Distributions Computed A required minimum distribution (“RMD”) is determined by dividing the account balance (as of the prior calendar year end) by the distribution period. For lifetime RMDs, there is a uniform distribution period for almost all IRA owners of the same age. The uniform distribution period table is based on the joint life and last survivor expectancy of an individual and a hypothetical beneficiary 10 years younger. However, if the IRA owner’s sole beneficiary is his/her spouse and the spouse is more than 10 years younger than the account owner, then a longer distribution period based upon the joint life and last survivor life expectancy of the IRA owner and spouse will apply. An IRA owner may, however, elect to take more than his/her RMD at any time.

  • Minimum Shipping Requirements for TIPS Sales Vendor shall ship, deliver, or provide ordered goods and services within a commercially reasonable time after acceptance of the order. If a delay in delivery is anticipated, Vendor shall notify the TIPS Member as to why delivery is delayed and provide an updated estimated time for completion. The TIPS Member may cancel the order if the delay is not commercially acceptable or not consistent with the Supplemental Agreement applicable to the order.

  • Calculation of Charges Contractor shall provide an invoice to the City on a monthly basis for goods delivered and/or Services completed in the immediate preceding month, unless a different schedule is set out in Appendix B, “Calculation of Charges.” Compensation shall be made for goods and/or Services identified in the invoice that the City, in his or her sole discretion, concludes has been satisfactorily performed. In no event shall the amount of this Agreement exceed [insert whole dollar amount in numbers and words -- no pennies and no “.00”]. The breakdown of charges associated with this Agreement appears in Appendix B, “Calculation of Charges.” A portion of payment may be withheld until conclusion of the Agreement if agreed to by both Parties as retainage, described in Appendix B. In no event shall City be liable for interest or late charges for any late payments. City will not honor minimum service order charges for any services covered by this Agreement.

  • Determination of One-Month LIBOR Pursuant to the terms of the Global Agency Agreement, the Global Agent shall calculate the Class Coupons for the applicable Classes of Notes (including MAC Notes on which the Exchange Administrator has directed the Global Agent to make payments) for each Accrual Period (after the first Accrual Period) on the applicable LIBOR Adjustment Date. “One-Month LIBOR” will be determined by using the “Interest Settlement Rate” for U.S. dollar deposits with a maturity of one month set by ICE Benchmark Administration Limited (“ICE”) as of 11:00 a.m. (London time) on the LIBOR Adjustment Date (the “ICE Method”). ICE’s Interest Settlement Rates are currently displayed on Bloomberg L.P.’s page “BBAM.” That page, or any other page that may replace page BBAM on that service or any other service that ICE nominates as the information vendor to display the ICE’s Interest Settlement Rates for deposits in U.S. dollars, is a “Designated Page.” ICE’s Interest Settlement Rates currently are rounded to five decimal places. If ICE’s Interest Settlement Rate does not appear on the Designated Page as of 11:00 a.m. (London time) on a LIBOR Adjustment Date, or if the Designated Page is not then available, One-Month LIBOR for that date will be the most recently published Interest Settlement Rate. If ICE no longer sets an Interest Settlement Rate, Freddie Mac will designate an alternative index that has performed, or that Freddie Mac (or its agent) expects to perform, in a manner substantially similar to ICE’s Interest Settlement Rate.

  • Required Minimum Distributions Your required minimum distribution is calculated using the uniform lifetime table in Regulations section 1.401(a)(9)-9. However, if your spouse is your sole designated beneficiary and is more than 10 years younger than you, your required minimum distribution is calculated each year using the joint and last survivor table in Regulations section 1.401(a)(9)-9. If you fail to request your required minimum distribution by your required beginning date, we can, at our complete and sole discretion, do any one of the following. • Make no distribution until you give us a proper withdrawal request • Distribute your entire IRA to you in a single sum payment • Determine your required minimum distribution from your IRA each year based on your life expectancy, calculated using the uniform lifetime table in Regulations section 1.401(a)(9)-9, and pay those distributions to you until you direct otherwise We will not be liable for any penalties or taxes related to your failure to take a required minimum distribution.

  • Minimum scope of coverage Commercial general coverage shall be at least as broad as Insurance Services Office Commercial General Liability occurrence form CG 0001 (ed. 11/88) or Insurance Services Office form number GL 0002 (ed. 1/73) covering comprehensive General Liability and Insurance Services Office form number GL 0404 covering Broad Form Comprehensive General Liability. Automobile coverage shall be at least as broad as Insurance Services Office Automobile Liability form CA 0001 (ed. 12/90) Code 1 (“any auto”). No endorsement shall be attached limiting the coverage.

  • Minimum Scope and Limit of Insurance Coverage shall be at least as broad as:

  • Definition of Holiday Pay and Qualifiers (The following clause is applicable to full-time employees only) Holiday pay will be computed on the basis of the employee's regular straight time hourly rate of pay times the employee's normal daily hours of work. In order to qualify for holiday pay for any holiday, as set out in the Local Provisions Appendix, or to qualify for a lieu day an employee must complete her scheduled shift on each of the working days immediately prior to and following the holiday except where absence on one or both of the said qualifying days is due to a satisfactory reason. An employee who was scheduled to work on a holiday, as set out in the Local Provisions Appendix, and is absent shall not be entitled to holiday pay or to a lieu day to which she would otherwise be entitled unless such absence was due to a satisfactory reason. An employee who qualifies to receive pay for any holiday or a lieu day will not be entitled, in the event of illness, to receive sick pay in addition to holiday pay or a lieu day in respect of the same day.

Time is Money Join Law Insider Premium to draft better contracts faster.