WORK AND CHECKPOINT REQUIREMENTS Sample Clauses

WORK AND CHECKPOINT REQUIREMENTS. 1. The Contractor shall drydock the vessel and hold it at a wet berth as required for the completion of all Work items in accordance with the requirements of ITEM S401 - DRYDOCK AND WET BERTHING REQUIREMENTS.
Sample 1
AutoNDA by SimpleDocs
WORK AND CHECKPOINT REQUIREMENTS. 1. All Work accomplished under this Item shall be performed in accordance with and as detailed in ITEM S402 – CLEANING, BLASTING, AND COATING REQUIREMENTS. Unless otherwise noted, all reference Sections and Paragraphs detailed herein refer to ITEM S402 – CLEANING, BLASTING, AND COATING REQUIREMENTS.
Sample 1
WORK AND CHECKPOINT REQUIREMENTS. 1. All Work accomplished under this Item shall be performed in accordance with and as detailed in ITEM S403 – VALVE, REACH ROD, ACTUATOR, AND SPOOL PIECE OVERHAUL REQUIREMENTS. Unless otherwise noted, all reference Sections and Paragraphs detailed herein refer to ITEM S403.
Sample 1

Related to WORK AND CHECKPOINT REQUIREMENTS

  • Procurement Requirements The below listed provisions of State Procurement requirements shall be complied with throughout the contract period:

  • Project Requirements Failure to comply with the following requirements will result in a suspension of all other operations:

  • Development Requirements The exterior wall standards set forth in this section shall apply to the structures located on the Property. At least ninety percent (90%) of the combined exterior surface area of all walls, including all stories of buildings / structures, shall consist of stone, brick, painted or tinted stucco, and factory tinted (not painted) split faced concrete masonry unit or similar material approved by the Director of Planning.

  • Management Requirements Procedures for managing equipment (including replacement equipment), whether acquired in whole or in part under a Federal award, until disposition takes place will, as a minimum, meet the following requirements:

  • Contractor Work Hours and Safety Standards Contractor shall ensure compliance with all safety and hourly requirements for employees, in accordance with federal, state, and County safety and health regulations and laws.

  • Agreement Requirements This agreement will be issued to cover the Janitorial Service requirements for all State Agencies and shall be accessible to any School District, Political Subdivision, or Volunteer Fire Company.

  • Standards for Network Elements 1.8.1 BellSouth shall comply with the requirements set forth in the technical references, as well as any performance or other requirements identified in this Agreement, to the extent that they are consistent with the greater of BellSouth’s actual performance or applicable industry standards.

  • Equipment Requirements No Equipment is provided to Customer as part of this Service.

  • License Requirements The Hotel’s alcoholic beverage license requires that the Hotel shall: (i) request proper identification (photo ID) of any person of questionable age and refuse alcoholic beverage service if the person is either under age or proper identification cannot be produced, and (ii) refuse alcoholic beverage service to any person who, in the Hotel’s judgment, appears to be intoxicated; and (iii) instruct its personnel to avoid encouraging patrons to consume alcoholic beverages (commonly referred to as “over-pouring”).

  • Quality Management System Supplier hereby undertakes, warrants and confirms, and will ensue same for its subcontractors, to remain certified in accordance with ISO 9001 standard or equivalent. At any time during the term of this Agreement, the Supplier shall, if so instructed by ISR, provide evidence of such certifications. In any event, Supplier must notify ISR, in writing, in the event said certification is suspended and/or canceled and/or not continued.

Time is Money Join Law Insider Premium to draft better contracts faster.