Safe Working Conditions The Employer undertakes to maintain office furniture, equipment, etc., in a practical and safe condition in order to avoid injury to employees or damage to their attire. Employees, for their part and in their own interest, are expected to advise the Employer of any such potentially injurious equipment.
Unsafe Working Conditions Employees shall be recognized by the Employer to have the competence to determine what constitutes unsafe working conditions within their discipline. No employee shall be disciplined for refusal to work in a situation which is deemed unsafe beyond the reasonable requirements of the employee's job.
GENERAL WORKING CONDITIONS Section 18-1. Employment begins and ends at each project site.
Section 18-2. The selection of craft foremen and/or general foremen and the number of foremen required shall be entirely the responsibility of the Employer, it being understood that in the selection of such foremen and/or general foremen the Employer will give primary consideration to the qualified individuals available in the local area. After giving such consideration, the Employer may select such individuals from other areas. All foremen shall take orders from the designated Employer representatives. Craft foremen shall be designated working foremen at the request of the Employer.
Section 18-3. There shall be no limit on production by employees nor restrictions on the full use of tools or equipment. Employees using tools shall perform any of the work of the trade and shall work under the direction of the craft foremen. There shall be no restrictions on efficient use of manpower other than as may be required by safety regulations.
Section 18-4. Employees shall be at their place of work at the starting time and shall remain at their place of work performing their assigned functions under the supervision of the Employer until quitting time. The parties reaffirm their policy of a fair day’s work for a fair day’s wage.
Section 18-5. All equipment assigned to a project shall be under the control of the Employer. The Employer shall have the right to determine how many pieces of equipment an individual employee shall operate. In an emergency, foremen shall operate any equipment assigned by the Employer, and there shall be no restriction on foremen in the use of the tools of his or her craft in such emergency. The foremen shall be from the craft normally operating the equipment. In accordance with currently recognized craft jurisdiction, the Employer shall determine the assignment of employees to start, stop, and maintain small portable construction equipment. Such work may be assigned to craft employees within a reasonable distance of their primary duties or an employee may be assigned full time to start, stop and maintain the Employer’s small, portable equipment on the job site. There shall be no over xxxxxxx of this type of equipment. The number of employees assigned to rigging and scaffolding operations shall be at the sole discretion of the Employer. The ratio of journeyperson to welders shall be determined solely by the Employer.
Section 18-6. The Employer may utilize the most efficient methods or techniques of construction, tools or other labor saving devices to accomplish the work. Practices not a part of the terms and conditions of this Agreement, stand by crews and feather bedding practices will not be recognized.
Section 18-7. It is recognized that specialized or unusual equipment may be installed and/ or serviced by individuals who have special training, skill, or qualifications and are not covered by this Agreement. Testing, inspection, or service performed on plant equipment under warranty may be performed by the vendor’s personnel.
Section 18-8. Neither the Union nor its local unions shall coerce or in any way interfere with the Owner’s personnel, operation or facilities at the plant site. The Owner’s right to contract directly with other companies for work at the plant site shall not be limited, and the Union shall cooperate and not interfere with the Employer’s operations.
Section 18-9. It is agreed that overtime is undesirable and not in the best interest of the industry or the employees; therefore, except in unusual circumstances, overtime will not be worked. Where unusual circumstances do exist, however, the Employer will have the right to assign specific employees and/or crews to perform such overtime work as is necessary to accomplish the job.
Section 18-10. There will be no rest periods, organized coffee breaks or other non-working time established during working hours.
Section 18-11. Individual seniority shall not be recognized or applied to employees working on projects under this Agreement.
Section 18-12. The Employer shall establish such reasonable project rules as the Employer deems appropriate. These rules will be reviewed at the pre-job conference and posted at the project site by the Employer, and may be amended thereafter as necessary.
WORKING CONDITIONS 9.01 Lunch periods shall be at mid-shift.
9.02 The Employer shall allow each employee two (2) breaks of ten (10) minutes each, but not more in a work shift. Time of breaks shall be mutually agreed upon.
9.03 Essential protective clothing including welder’s gloves, protective vests or leather jackets, noise abatement devices, and rainwear shall be supplied at no charge to the employee. In the event that an employee does not return the foregoing items supplied to him by the Employer, the Employer shall charge the cost of same to the employee and deduct this cost from any money owing to the employee.
9.04 Chemical or flush toilets shall be provided from the commencement of work on all jobs. Where the sewer or chemical toilets are not available, sanitary toilet facilities shall be provided as called for in local sanitary regulations. Toilet houses shall be painted, at least on the inside, and cleaned out daily. Toilet paper will be provided.
9.05 Where there is no running tap water available, drinking water in approved sanitary containers shall be provided. Paper cups will be supplied. Salt tablets shall be supplied during the summer months.
9.06 If requested by the Union or employee, the Employer will provide within three (3) calendar days, a termination slip which shall state the reason for the employee’s termination and whether or not he is eligible for rehire.
9.07 Adequate time will be allowed prior to quitting time for picking up tools.
9.08 A lock-up shall be provided for employees for drying clothes, and dressing room, as well as lunch room. The lock-up shall have tables, and benches with provision for drying clothes. Such lock-up shall have windows and venting with adequate lighting and provision for continuous heat twenty-four (24) hours a day. The Employer shall be responsible for having the lock-up cleaned out daily and kept cleared of building material and other construction paraphernalia. Additional shelters shall be provided for employees to eat their lunch as may be required.
9.09 In case of fire or burglary on property or premises provided by the Employer, the Employer shall protect the value of an employee’s work clothes up to a total of three hundred and fifty dollars ($350.00). The Employer shall also provide fire and burglary insurance for the employees required tools to a total value of the tools, tool for tool, make for make, provided an inventory of tools and clothing is filed with the Employer. The Employer shall supply the required forms and obtain the inventory from each employee. The employee shall receive a signed copy of the inventory from the Employer. Coverage will commence at the date of the filing of the inventory with the Employer. Where an employee fails to file an inventory his rights to submit a claim shall be waived.
(a) All mechanics, welders, servicemen, tire servicemen, drill doctors, steel sharpeners, bodymen painters, and mechanics and welder apprentices who request coveralls shall have these supplied and cleaned by the Employer. There shall be one change a week available in the employee’s proper size. Employees are expected to take reasonable care of coveralls supplied. In the event that an employee does not return the coveralls supplied to him by the Employer, the Employer shall charge the cost of same to the employee and deduct this cost from any monies owing to the employee. When requested, coveralls shall be supplied on a temporary basis to employees who assist on work as described above, or where the Employer and the Union mutually agree that coveralls are required.
(b) Employees entitled to receive coveralls as provided herein may obtain an additional change of coveralls in any one week providing the condition of the coveralls requires a change. The shop xxxxxxx shall use discretion in authorizing the additional change.
(c) All shops shall provide adequate clean-up facilities.
9.11 The Employer shall pay the cost of obtaining operators’ licences other than those required under the Motor Vehicles Act for employees covered by this Agreement.
9.12 No employee will be permitted to use his own motor vehicle in a manner which is unfair to other members or against the best interest of the Union.
9.13 Each employee being terminated will be given one (1) hour’s notice of termination by the Employer or one (1) hour’s pay allowed in lieu thereof. Heavy duty mechanics and apprentice mechanics may utilize this hour to gather together their tools and put them in shape for their next job.
9.14 When a mechanic leaves the employ of the Employer, the Employer shall be required to pay cost of shipping mechanic’s tools. Tools shall be shipped within forty-eight (48) hours of his leaving his employment, subject to the same conditions as govern transportation. When an Operating Engineer elects to transport his own tools to and from the jobsite, the employee shall be paid the rate of two dollars and seventy-five cents ($2.75) per one hundred (100) pounds per one hundred (100) miles. (e.g. $2.75 x 528 pounds x 273 miles = $39.64). Where the Employer fails to comply with the above, the employee shall be deemed to be still on the payroll of the Employer and shall receive his usual wages and all other conditions of this Agreement until there is compliance with these provisions.
9.15 Where an employee is involved in an accident while on the job and as a result is unable to perform his work, he shall receive a full day’s pay for the day of the accident.
CONDITIONS FOR EMERGENCY/HURRICANE OR DISASTER - TERM CONTRACTS It is hereby made a part of this Invitation for Bids that before, during and after a public emergency, disaster, hurricane, flood, or other acts of God that Orange County shall require a “first priority” basis for goods and services. It is vital and imperative that the majority of citizens are protected from any emergency situation which threatens public health and safety, as determined by the County. Contractor agrees to rent/sell/lease all goods and services to the County or other governmental entities as opposed to a private citizen, on a first priority basis. The County expects to pay contractual prices for all goods or services required during an emergency situation. Contractor shall furnish a twenty-four (24) hour phone number in the event of such an emergency.
Designated Configuration; Trained Personnel State Street and the Fund shall be responsible for supplying, installing and maintaining the Designated Configuration at the Designated Locations. State Street and the Fund agree that each will engage or retain the services of trained personnel to enable both parties to perform their respective obligations under this Addendum. State Street agrees to use commercially reasonable efforts to maintain the System so that it remains serviceable, provided, however, that State Street does not guarantee or assure uninterrupted remote access use of the System.
Supplier Personnel The Customer and Supplier agree and acknowledge that in the event of the Supplier ceasing to provide the Services or part of them for any reason, Call Off Schedule 10 (Staff Transfer) shall apply. The Supplier shall not and shall procure that any relevant Sub-Contractor shall not take any step (expressly or implicitly and directly or indirectly by itself or through any other person) without the prior written consent of the Customer to dissuade or discourage any employees engaged in the provision of the Services from transferring their employment to the Customer and/or the Replacement Supplier and/or Replacement Sub-Contractor. During the Termination Assistance Period, the Supplier shall and shall procure that any relevant Sub-Contractor shall: give the Customer and/or the Replacement Supplier and/or Replacement Sub-Contractor reasonable access to the Supplier's personnel and/or their consultation representatives to present the case for transferring their employment to the Customer and/or the Replacement Supplier and/or to discuss or consult on any measures envisaged by the Customer, Replacement Supplier and/or Replacement Sub-Contractor in respect of persons expected to be Transferring Supplier Employees; co-operate with the Customer and the Replacement Supplier to ensure an effective consultation process and smooth transfer in respect of Transferring Supplier Employees in line with good employee relations and the effective continuity of the Services. The Supplier shall immediately notify the Customer or, at the direction of the Customer, the Replacement Supplier of any period of notice given by the Supplier or received from any person referred to in the Staffing Information, regardless of when such notice takes effect. The Supplier shall not for a period of twelve (12) months from the date of transfer re-employ or re-engage or entice any employees, suppliers or Sub-Contractors whose employment or engagement is transferred to the Customer and/or the Replacement Supplier except that this paragraph 10.5 shall not apply where an offer is made pursuant to an express right to make such offer under Call Off Schedule 10.1 (Staff Transfer) in respect of a Transferring Supplier Employee not identified in the Supplier's Final Supplier Personnel List.
TEACHING CONDITIONS The parties recognize that optimum school facilities for both student and teacher are desirable to insure the high quality of education that is the goal of both the Association and the Board. It is also acknowledged that the primary duty and responsibility of the teacher is to teach and that the organization of the school and school day should be directed toward ensuring that the energy of the teacher is primarily utilized to this end.
Supervision of Contractor Personnel The Contractor must supply all necessary and sufficient supervision over the work that is being performed and will be held solely responsible for the conduct and performance of his employees or agents involved in work under the Agreement.
Contractor Personnel Contractor's staff is expected to present a professional appearance. All personnel of the Contractor will be neat, well groomed, properly uniformed in industry standard uniforms and are expected to conduct themselves at all times in a responsible and courteous manner while performing any work under this Agreement and/or whenever they are on District property. The following code of conduct will be adhered to by the Contractor, his agent(s) and/or his employees. If Contractor fails to ensure that its employees or other agents comply with these requirements, then Contractor may be terminated for cause under this Agreement:
A. All employees of the Contractor shall wear a recognizable uniform. No hats will be worn inside the building. All of Contractor’s employees and agents performing work must carry a government-issued photo ID. Contractor’s employees and agents will present ID to District Staff upon request. This provision will be strictly enforced.
B. The use of tobacco or tobacco products on Board property is prohibited by State law.
C. The Contractor will not be permitted to utilize Day Labor or Temporary Workers to provide any services at any District facility. This includes any employees or agents that are hired prior to contract award. Failure to comply with this requirement could result in immediate termination of contract with the Contractor liable for any breach, including liquidated damages for delay damages and/or forfeiture of Performance Bond.
D. The Contractor or employees or agents of the Contractor are not permitted to play loud music, to make unnecessary noises, or to use vulgar or inappropriate language that causes offense to others.
E. The employment of unauthorized or illegal aliens by the Contractor is considered a violation of Section 247A (e) of the Immigration and Naturalization Act. If the Contractor knowingly employs unauthorized aliens, such a violation shall also be cause for termination of this Agreement.
F. Possession of firearms will not be tolerated on Board property. No person who has a firearm in their vehicle will be permitted to park on District property. Any employee of the Contractor found in violation of this policy will be immediately asked to leave, and will not be allowed to return to perform further work without the consent of the District.
G. The Contractor certifies that he/she will not engage in the unlawful manufacture, sale distribution, dispensation, possession, or use of a controlled substance or drug during the performance of the contract and that a drug-free workplace will be provided for the Contractor’s employees or agents during the performance of the contract. The Contractor also certifies that he will secure from any subcontractor who works on the contract, written certification of the same drug free workplace requirements. False certification or violation by failing to carry out requirements of O.C.G.A. § 50-24-3 may cause suspension, termination of contract, or debarment of such bidder Please Note: If any employee or agent of the Contractor or Sub-contractor is found to have brought a firearm on District property, the Contractor or Sub-contractor shall prohibit them from continuing to perform any work on District property. If the Contractor or Sub-contractor fails to do so, then the District may terminate this Agreement for cause as set forth below.
