Design Phase Services – Contract Documents and Bid Clause Samples

Design Phase Services – Contract Documents and Bid. Depending upon the results of any EA Report, Design Phase Services may commence at Schematic or Design Development Services. Pursuant to a Design Work Authorization (“DWA”) issued by the OWNER for the Project described therein, the CONTRACTOR shall produce drawings for the Project for OWNER review and written approval, and, at a minimum, the specified following deliverables, stamped by a professional engineer licensed in the State of New York where appropriate and required by law. The following services and deliverables will not apply to every Project. Consult the DWA and written instructions from OWNER for the requirements. Alternatively, this section sets forth an expedited design process for the creation of scope of work delineations called “Scoping Documents” may not involve the practice of professional architecture nor engineering. Scoping Documents may only be used where no building permit is required to implement the scope of work delineation, such as for minor alterations or ordinary repairs. Scoping Documents are intended to provide efficiency in situations where traditional designs stamped by a design professional are not required. The CONTRACTOR shall provide design documentation and deliverables as directed by OWNER, which may include some or all of the tasks set forth below. Such documentation shall be provided as required for the installation as directed by the OWNER of a range of projects including, but not limited to: -Maintenance – Minor Equipment, Controls, Devices and Upgrades -Capital – Minor Miscellaneous Modifications – Equipment, Controls, Devices and Upgrades -Capital – Intensive Modifications – Design/Construction Management Build -Design/Build 1. Preschematic and/or Schematic Services Preschematic and/or Schematic Services shall be performed by the CONTRACTOR as set forth in “Requirements of the DWA” section below.